ECOVACS WINBOT 920 User manual
Instruction Manual
2
EN
Important Safety Instructions
1. This appliance can be used by persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. The appliance
is not to be used if it has been dropped, if there
are visible signs of damage or if it is leaking.
Keep the appliance out of reach of children
when it is energized.
2. Do not use the Appliance in extremely hot or
cold environments (below 0˚C/32˚F or above
40˚C/104˚F, above 65% humidity). The Appliance
can be used to clean outside windows if it is
properly tethered to a safe position with the
Carabiner, winds are calm, and it is not raining
or snowing.
3. Do not use this product in whole gale storms and
force-10 winds, or in areas where the altitude
exceeds 2000 meters(6162 feet).
4. Please ensure the Appliance is plugged in while it
is cleaning. The Appliance has a Back-Up Battery
that charges during use. The Back-Up Battery
powers the Appliance if it becomes unplugged or
the electricity fails.
5. Do not leave the Appliance unattended when it
is plugged in.
6. For household use ONLY. Do not use the
Appliance in commercial or industrial
environments.
7. Do not use the Appliance on cracked glass.
8. Only use accessories recommended or supplied
by the manufacturer. Only use the Power Adapter
supplied by the manufacturer.
9. Please make sure your power supply voltage
matches the power voltage marked on the
Power Adapter.
10. Do not use the Appliance on a framed window
with a frame smaller than 5mm (0.2 inches).
11. Do not use the Appliance on wet or greasy
windows.
12. Store the Appliance away from heat and
ammable materials.
13.Do not use the Appliance if it does not rmly attach
When using an electrical appliance, basic
precautions should always be followed, including
the following:
READ ALL INSTRUCTIONS BEFORE
USING THIS APPLIANCE.
SAVE THESE INSTRUCTIONS
3EN
to the glass or has visible signs of damage.
14. To reduce the risk of electrical shock, do not put
the Appliance in water or other liquid. Do not
place or store Appliance where it can fall or be
pulled into a tub or sink.
15. Do not touch power plug or the Appliance with
wet hands.
16. Do not charge the Appliance in extremely hot or
cold environments, or it may affect battery life
span.
17. When charging the Appliance, do not place it
on other electrical appliances and keep it away
from re and liquid.
18. Take care not to damage the power cord. Do
not pull on or carry the Appliance by the power
cord, use the power cord as a handle, close
a window on the power cord, or put heavy
weights on the power cord. Keep power cord
away from hot surfaces.
19. Do not use with a damaged power cord or
receptacle. Do not use the Appliance if it is not
working properly, has been dropped, damaged,
or come in contact with water. It must be
repaired by the manufacturer or its service
agent in order to avoid a hazard.
20. If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent in order to avoid a hazard.
21. The plug must be removed from the receptacle
before cleaning or maintaining the Appliance.
Do not unplug the Power Adapter by pulling on
the power cord.
22. The Back-Up Battery must be replaced by the
manufacturer or its service agent in order to
avoid a hazard.
23. The Back-Up Battery must be removed
and discarded according to local laws and
regulations before disposal of the Appliance.
24. The Appliance must be disconnected from
the receptacle before removing the battery for
disposal of the Appliance.
25. Please dispose of used batteries according to
local laws and regulations.
26. Do not incinerate the Appliance even if it is
severely damaged. The battery can explode in a
re.
27.The Appliance must be used in accordance with the
directions in this Instruction Manual. The company
cannot be held liable or responsible for any
damages or injuries caused by improper use.
28. WARNING: For the purposes of recharging the
battery, only use the detachable supply unit
EA10952/GM95-240375-D provided with this
Appliance.
4
EN
29. The robot contains batteries that are only
replaceable by skilled persons.
30. The plug and the Power Adapter must be used
indoor.
To satisfy RF exposure requirements, a separation
distance of 20 cm or more should be maintained
between this device and persons during device
operation.
To ensure compliance, operations at closer than this
distance is not recommended. The antenna used for
this transmitter must not be co-located in conjunction
with any other antenna or transmitter.
Class II
Short-circuit-proof safety isolating
transformer
Switch mode power supply
For indoor use only
Direct current
Alternating current
Correct Disposal of this Product
This marking indicates that this product should
not be disposed of with other household
waste throughout the EU. To prevent possible
harm to the environment or human health
from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of
material resources. To recycle your used device,
please use the return and collection systems
or contact the retailer where the product was
purchased. They can safely recycle this product.
For EU Countries
For EU Declaration of Conformity information, visit
https://www.ecovacs.com/global/compliance
5EN
WINBOT+ Safety Tether
and Carabiner Power Adapter
Instruction Manual
Cleaning Pads
Finishing Cloth
WINBOT Cleaning
Solution
Note: Figures and illustrations are for reference only and may differ
from actual product appearance.
Product design and specications are subject to change without notice.
Package Contents
Instruction Manual
WINBOT
Bumper Rail
Status Indicator
Light/START/
PAUSE Button
Product Diagram
Bottom View
Power Switch
Fan Bottom Status
Indicator Light
Suction Sensor
Side Rollers
Edge Detection
Sensors
Driving Treads
6
EN
Make sure Safety Tether and Carabiner have been connected with WINBOT before using.
(Connected by default. Do not disconnect before cleaning.)
Note: Do not use WINBOT on a framed window with a frame narrower than 5 mm(0.2”).
Notes Before Cleaning
7EN
1Connect WINBOT Power Cord, Power Adapter and Plug
2ECOVACS HOME App 3Preparation before Use
Quick Start
A B C
To enjoy all available features, it is recommended to control your
WINBOT via the ECOVACS HOME App.
Properly Tether WINBOT to a Safe Place
• Deep Cleaning Mode • Spot Cleaning Mode
• Switching Interior/Exterior Window
Note: To ensure safety, please make sure to properly tether WINBOT
to a safe place before use.
It is recommended to fasten the Safety Tether with the Carabiner on a
firm and safe metal railing.
HOME
ECOVACS HOME
8
EN
Wipe the area for WINBOT to safety attach to.
Place WINBOT on the window at least 10cm (4”) from window corners
or other obstacles.
Note: Keep objects away from WINBOT’s Fan to avoid blockage.
It is recommended to use WINBOT with WINBOT Cleaning Solution
from ECOVACS. Using tap water or other cleaners could have an
adverse effect on cleaning performance. Using other cleaning solutions
could potentially void the warranty.
Spray Cleaning Solution
Wipe the Bottom of WINBOT with a Dry Cloth
Wipe the Area for WINBOT to Attach to
Note: Do not over-spray Cleaning Solution as doing so may cause the
driving treads to slip.
4Start
Turn the Power Switch to "I". Attach WINBOT to the glass, and WINBOT
will start cleaning after it has attached to the window successfully.
9EN
5Pause
Remove WINBOT
Unfasten Safety Tether
Power Off
Unplug WINBOT
1 2
6Finish
10
EN
Note: Wash with mild detergent.
Do NOT use a wet Cleaning Pad on WINBOT or it may slip on the window.
Washing the Cleaning Pad regularly can extend its service life.
If the Cleaning Pad becomes worn or no longer fits exactly within the fastener area, replace it with a new one to achieve optimal cleaning performance.
Explore more accessories at https://www.ecovacs.com/global.
Maintenance
Cleaning Pad
Replace the Cleaning Pad
Washing Cleaning Pad
Remove the dirty Cleaning Pad from the WINBOT and place a clean new one on it. Please make sure the cleaning pad is correctly attached,
and do not cover the Edge Detection Sensors.
Note: The gray microfiber side faces out.
A
B
A>B
A
B
This manual suits for next models
1
Table of contents
Other ECOVACS Cleaning Equipment manuals
