____________________________________________________________________________________________
__________________________________________________________________________________________ 10
• Proximity to dressing rooms and bathrooms
• Storage for spa chemicals
• Local building codes ( if applicable)
• Power cable (see electrical requirements)
GENERAL CONSIDERATIONS FOR INDOOR INSTALLATION
GENERAL CONSIDERATIONS FOR INDOOR INSTALLATIONGENERAL CONSIDERATIONS FOR INDOOR INSTALLATION
GENERAL CONSIDERATIONS FOR INDOOR INSTALLATION
Installing your spa indoors creates an entirely different set of considerations. Here again,
with proper planning, no matter what room you spa goes in, it will be your favorite room.
• Work with your Down ast Spa dealer and contractor to insure
all local building, electrical and plumbing codes are met
• Plan for a floor drain to drain off excess water or for draining
and cleaning your spa
• A ventilation fan may be necessary due to high humidity
created by your spa
• Finished material in your spa room should also be capable of
withstanding increased humidity
INITIAL
INITIALINITIAL
INITIAL
START
STARTSTART
START-
--
-UP
UPUP
UP
PROCEDURE
PROCEDUREPROCEDURE
PROCEDURE
Now that all electrical connections to your new Down ast Spa are complete, start-up
procedures may begin. This is the fun part!
CAUTION
CAUTION CAUTION
CAUTION -
--
- DO NOT APPLY POWER
DO NOT APPLY POWER DO NOT APPLY POWER
DO NOT APPLY POWER TO OR OPERATE THE SP
TO OR OPERATE THE SPTO OR OPERATE THE SP
TO OR OPERATE THE SPA WHEN THE
A WHEN THE A WHEN THE
A WHEN THE
SPA
SPASPA
SPA IS PARTIALLY FILLED
IS PARTIALLY FILLED IS PARTIALLY FILLED
IS PARTIALLY FILLED OR THERE IS NO WATE
OR THERE IS NO WATE OR THERE IS NO WATE
OR THERE IS NO WATER IN THE SPA!
R IN THE SPA!R IN THE SPA!
R IN THE SPA!
1) Be sure that the circuit breaker in your breaker panel is off.
2) Be sure all jets in the spa are fully open by turning the jet face clockwise.
3) LOCATE AND OPEN ALL VALVES. NOTE: There are two valves per pump.
Pump locations vary depending on model of spa.
4) Be sure drain fitting is fully closed.
5) Fill your new Down ast Spa with water. We recommend using the CO PUR
Charcoal Pre-Filter which gives you much cleaner water to start your spa. Fill to
waterline, which is approximately three inches above bottom of filter/skimmer
opening.
6) Bleed air from system by briefly opening the external drain fitting then close.
Turn breaker switches on. You may then press any of the spa function
switches. After power has been applied your spa will automatically
move into its pre-set filter cycle. (See operation section for further
information.)
