Dimplex CASTILLO CS3540 Quick start guide

PARTS AND SERVICE MANUAL

FOR

CASTILLO AND ZAMORA

Models CS3540/CS3550

TABLE OF CONTENTS

OPERATION PAGE 2

PARTS DRAWING PAGE 3

PARTS LIST PAGE 4

WIRING DIAGRAM PAGE 5

LIGHT BULB REPLACEMENT PAGE 6

FLAME MOTOR/FLAME ROD REPLACEMENT PAGE 7

HEATER ON/OFF SWITCH REPLACEMENT PAGE 8

HEATER ASSEMBLY REPLACEMENT PAGE 9

POWER CORD REPLACEMENT PAGE 10

CS3540, CS3550

OPERATION

Three switches provide a choice of heat settings (FIG. 1). A switch is in the ON position

when the side with the markings on (i.e. I, I, or II) is pushed in.

Switch 1 (I) Controls the electricity supply to the heater and flame effect.

Note: This switch must be in the ON (I) position for heater to operate with or without

heat.

Switch 2 (I) Provides 600 W heat output.

Switch 3 (II) Provides 1200 W heat output with switch 2.

RESETTING THE TEMPERATURE CUTOFF SWITCH

Should the heater overheat, an automatic cut out will turn the heater off and it will not

come back on without being reset. It can be reset by switching the MAIN ON/OFF

SWITCH to OFF and waiting 5 minutes before switching the unit back on.

CAUTION

If you need to continuously reset the heater, unplug the unit and call Dimplex North

America Limited at 1-800-668-6663.

DFB6016

CS3540, CS3550

REPLACEMENT PARTS

FIREBOX, 30” – Dimplex

CATALOGUE NO. CS3540, CS3550

PART NO. 000000000

REPLACEMENT PART

1. FLICKER MOTOR 2000210200RP

2. WIRE ASSY LAMPHOLDER SOCKET 4200120800RP

3. ON/OFF SWITCH 2800070700RP

4. CORD SET 4100040500RP

5. MIRROR 5900300400RP

6. LOW HEAT SWITCH 2800070900RP

7. HIGH HEAT SWITCH 2800071000RP

8. COAL STONES 1400000100RP

9. WHITE ROCK 1400010100RP

10.SURROUND, BLACK 0478090159RP

11.SURROUND, SILVER 0478090153RP

12.HEATER ASSEMBLY 1200W, 980RPM 2200490900RP

WIRING DIAGRAM

N L

L N

BULBS

MAIN ON/OFF SWITCH

HEATER ASSEMBLY

FLAMEMOTOR

TERMINAL BLOCK

LOW HEAT SWITCH

HIGH HEAT SWITCH

POWER CORD

CS3540/CS3550

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and

heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

Light bulbs need to be replaced when you notice a dark section of the flame. There are

two bulbs under the log set which generate the flames and embers located under the

emberbed.

It is a good idea to replace all of the light bulbs at one time if they are close to the end of

their rated life. Group replacement will reduce the number of times you need to open

the unit to replace the light bulbs.

BULB REPLACEMENT

1. Remove the coal/pebbles and place in a container.

2. Remove the front panel from the fireplace by lifting it up and out from the slots on the

fireplace.

3. Remove the rotisserie by carefully sliding the rubber connecter off the motor shaft.

4. Remove the defective bulb by unscrewing it as shown below.

LIGHT BULB REQUIREMENTS

Quantity of 2 clear chandelier or candelabra bulbs with an E-12 (small) socket base,

60 watt rating.

CS3540/CS3550

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and

heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

TO REPLACE FLAME MOTOR/FLAME ROD

1. Remove the coal/pebbles and place in a container.

2. Remove the front panel from the fireplace by lifting it up and out from the slots on

the fireplace

3. Remove the reflector rod from the flame motor by pulling the end of the rod to the

left and carefully remove flame rod from rubber sleeve.

4. Remove the 2 screws securing the flame motor to the flame motor bracket

5. Remove the lower mirror bracket by remove the 2 mounting screws.

6. Slide the mirror down and lift out to access the terminal block.

7. Disconnect the flame motor wires from the terminal block, noting their original

locations.

8. Discard the old flicker motor.

9. Reassemble in the reverse order.

CS3540/CS3550

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and

heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

TO REPLACE MAIN ON/OFF, LOW HEAT AND HIGH HEAT SWITCHES

1. Remove the coal/pebbles and place in a container.

2. Remove the front panel from the fireplace by lifting it up and out from the slots on

the fireplace

3. Remove the 9 retaining screws on the rear of the fireplace and remove the outer trim

4. Remove the heater assembly cover by removing the 4 screws on the top and front of

the cover.

5. Locate the defective switch mounted to the heater assembly cover and disconnect

the wiring clips and connections noting their original locations.

6. Depress the retainer clips on the rear of the switch and push the switch out of the

heater assembly cover.

7. Properly orientate the new switch and connect all of the wiring clips and

connections.

8. Reassemble in the reverse order as above

CS3540/CS3550

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and

heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

TO REPLACE HEATER ASSEMBLY

1. Remove the coal/pebbles and place in a container.

2. Remove the front panel from the fireplace by lifting it up and out from the slots on the

fireplace

3. Remove the 9 retaining screws on the rear of the fireplace and remove the outer trim

4. Remove the heater assembly cover by removing the 4 screws on the top and front of

the cover.

5. Remove the 4 mounting screws holding the heater assembly to the heater assembly

cover.

6. Disconnect wiring connections and connect to replacement heater assembly noting their

original locations.

7. Reassemble in the reverse order as above.

Other manuals for CASTILLO CS3540

This manual suits for next models

Table of contents

Other Dimplex Indoor Fireplace manuals

Dimplex

Dimplex Charlotte CRT20AB User manual

Dimplex

Dimplex Opti-myst User manual

Dimplex

Dimplex MULTIFIRE DF3215 User manual

Dimplex

Dimplex OPTIFLAME BF Series Quick start guide

Dimplex

Dimplex BLF3451 User manual

Dimplex

Dimplex Marbello User manual

Dimplex

Dimplex Wynford WYN20BR User manual

Dimplex

Dimplex BELLINI CONCRETE BLN15C User manual

Dimplex

Dimplex SP16 User manual

Dimplex

Dimplex Indoor Electric Fireplace User manual

Dimplex

Dimplex Prism BLF5051 User manual

Dimplex

Dimplex BF SERIES User manual

Dimplex

Dimplex DF2622 User manual

Dimplex

Dimplex Bari 2kW Optiflame User manual

Dimplex

Dimplex BF33STP/DXP User manual

Dimplex

Dimplex DF3003 User manual

Dimplex

Dimplex DFO2307 Quick start guide

Dimplex

Dimplex Juneau JUN User manual

Dimplex

Dimplex RITZ20W User manual

Dimplex

Dimplex NAVARRA NAV15P PEBBLE Owner's manual

Dimplex

Dimplex VCX1525 User manual

Dimplex

Dimplex Xpression SP220 User manual

Dimplex

Dimplex BFSL33 User manual

Dimplex

Dimplex Siena Fire SNA20 User manual

Popular Indoor Fireplace manuals by other brands

Brigantia

Brigantia 35-DVRS31N-2 User's installation, operation and maintenance manual

Nordpeis

Nordpeis Bergen Installation and user manual

Superior

Superior BCT2536TMN Installation and operation instructions

Quadra-Fire

Quadra-Fire 5100I-GD-B owner's manual

Renaissance

Renaissance RUMFORD 1000 user manual

Lacunza

Lacunza IV-800 Instruction book

Baxi

Baxi 940 Installer and owner guide

Dru

Dru Maestro 60/2 Tall RCH installation manual

Diamond Fireglass

Diamond Fireglass SS-O22 General assembly, installation, and operation instructions

HearthStone

HearthStone Windsor Bay 8830 Owner's manual and installation guide

Napoleon

Napoleon ASCENT B42 quick start guide

Enviro

Enviro E33GI owner's manual

Smeg

Smeg L30 FABE Installation & user's instructions

KEDDY

KEDDY K700 Installation instructions care and firing instructions

Godin

Godin 3451 manual

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Installation and operation instructions

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 operating manual

Desa

Desa CCFPDFT Owner's operating & installation manual