Dimplex 26" Quick start guide

PARTS AND SERVICE MANUAL

FOR

DIMPLEX 26” OUTDOOR

ELECTRIC FIREPLACE

Model DFO2607

TABLE OF CONTENTS

OPERATION PAGE 2

PARTS DRAWING PAGE 3

PARTS LIST PAGE 4

WIRING DIAGRAM PAGE 5

FRONT GLASS REMOVAL PAGE 6

UPPER LIGHT REPLACEMENT PAGE 7

LOWER LIGHT REPLACEMENT PAGE 8

MAIN ON/OFF/FLAME CONTROL REPLACEMENT PAGE 9

FLAME ROD AND MOTOR REPLACEMENT PAGE 10

CIRCUIT BOARD REPLACEMENT PAGE 11

AUDIO BOARD REPLACEMENT PAGE 12

DFO2607

OPERATION

ELECTRIC FIREPLACE MANUAL CONTROL

The manual controls for the firebox are located in the upper right hand corner behind

the access panel. To access the controls, open the upper access panel by pulling

forward and down.

To locate controls refer to Figure 3.

NOTE: The main on/off switch/flame action and flame brightness controls are

always illuminated as long as the unit is plugged in.

A. Main On/Off Switch

The ON/OFF SWITCH supplies power to the flames and over head lights.

B. Flame Action Control

Press the up or down arrow to adjust the flame speed to the desired level.

C. Flame Brightness Control

Press the up or down arrow to increase or decrease the brightness of the over head

lights.

D. Storage Compartment

A convenient location to place your CD’s or MP3 player.

E. Audio Input Plug

Using the audio cord included, a CD or MP3 player may be connected to the firebox.

NOTE: This unit does not have a heat option

Figure 3

Main

On/Off

Switch

Flame Brightness

Flame ActionAudio Input Plug Storage Compartment

DFO2607

REPLACEMENT PARTS

FIREBOX, 26” – Dimplex

CATALOGUE NO. DFO2607

PART NO. 6903100200

REPLACEMENT PART

1. MOTOR, ASSEMBLY 3000240200RP

2. LED LIGHT, TOP 3700060200RP

3. SWITCHBOARD 3000560100RP

4. CIRCUIT BOARD 3000520200RP

5. MIRROR 5900750200RP

6. GLASS FRONT 5900710200RP

7. LED LIGHT, BOTTOM 3700060200RP

8. TRANSFORMER 2100200200RP

9. FLAME ROD 5900080600RP

10.BUSHING 8500000400RP

11. LOGSET 0437960600RP

12.AUDIO BOARD 3000530100RP

YELLOW WIREOF CABLE

TO LINE UP WITH SQUARE

SOLDER PAD OF CONNECTOR BOARD.

LIGHT WIRE HARNESS

REFER TO DWG#

2500420000

INCLUDED IN

LIGHT WIRE HARNESS

INCLUDE DIN

LIGHT WIRE HARNESS

MAIN PC BBOARD

(BACK SIDE VIEW)

BLACK WIRE OF CABLE

TO LINE UP WITH SQUARE

SOLDER PAD OF CONNECTOR BOARD.

1 WATT LED

FLAME LIGHT 1 WATT LED

FLAME LIGHT

3 WATT LED

FLAME LIGHT

1 WATT LED

TOP LIGHT

CONNECTOR, WIRE

TWISTER

"B" TERMINAL

TYP.

FLICKER MOTOR

P/N 300240200

(HARNESSINCLUDED)

AUDIO BOARD

(BACK SIDE VIEW)

SWITCHBOARD

P/N 3000500100

(HARNESS INCLUDED)

CONNECTOR, FEMALE

P/N 4300430100

(HARNESS INCLUDED)

4X"A"TERMINAL

SPEAKER TERMINAL

4X "C" TERMINAL

2 X "A" TERMINAL

4 X "A" TERMINAL

SQUARE

SOLDER PAD

WIRING DIAGRAM

DFO2607

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

Lights need to be replaced when you notice a dark section of the flame. There are

three lights under the log set which generate the flames and embers located under the

emberbed.

It is a good idea to replace all of the lights at one time if they are close to the end of their

rated life. Group replacement will reduce the number of times you need to open the unit

to replace the lights.

FRONT GLASS REMOVAL

1. Remove top from mantel.

2. Lift firebox out of mantel.

3. Lay firebox on it’s back.

4. Remove screws from the left and right side of the front glass lower support.

5. Insert the tip of a slot screwdriver between the glass edge on either the left or right

side trim.

6. Using the screwdriver as a lever, apply pressure in a downward motion forcing the

edge of the glass up.

DFO2607

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

Lights need to be replaced when you notice a dark section of the flame. There are

three lights under the log set which generate the flames and embers located under the

emberbed.

It is a good idea to replace all of the lights at one time if they are close to the end of their

rated life. Group replacement will reduce the number of times you need to open the unit

to replace the lights.

UPPER LIGHT REPLACEMENT

1. Remove the front glass as shown on page 6 of this manual.

2. Remove the top trim piece by removing the 3 retaining screws.

3. Remove the 10 retaining screws and lift the top off of the unit.

4. Unplug the light wiring harness from the circuit board.

5. Remove the 3 screws and remove the light from the unit.

6. Reassemble in the reverse order.

LIGHT BULB REQUIREMENTS

Quantity of 2 clear chandelier or candelabra bulbs with an E-12 (small) socket base,

60 watt rating.

DFO2607

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

Lights need to be replaced when you notice a dark section of the flame. There are

three lights under the log set which generate the flames and embers located under the

emberbed.

It is a good idea to replace all of the lights at one time if they are close to the end of their

rated life. Group replacement will reduce the number of times you need to open the unit

to replace the lights.

LOWER LIGHT REPLACEMENT

1. Remove the front glass as shown on page 6 of this manual.

2. Remove the top trim piece by removing the 3 retaining screws.

3. Remove the 10 retaining screws and lift the top off of the unit.

4. Unplug the lower light wiring harness from the circuit board.

5. Remove the flame rod.

6. Remove the 3 screws holding each light and remove the light assembly from the

unit.

7. Reassemble in the reverse order.

DFO2607

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

MAIN ON/OFF SWITCH REPLACEMENT

1. Remove the front glass as shown on page 6 of this manual.

2. Remove the top trim piece by removing the 3 retaining screws.

3. Remove the 10 retaining screws and lift the top off of the unit.

4. Locate the main on/off/flame control mounted on the top panel and disconnect the

wiring plug noting it’s original location.

5. Remove the 4 mounting screws on the front of the top panel and remove the control

from the unit.

6. Reassemble in the reverse order.

This manual suits for next models

Table of contents

Other Dimplex Indoor Fireplace manuals

Dimplex

Dimplex Mini Mozart Deluxe User manual

Dimplex

Dimplex DWF1203 User manual

Dimplex

Dimplex Optimyst 3STEP-RGB-EU Instruction Manual

Dimplex

Dimplex MIDI FIRE MIDI32B User manual

Dimplex

Dimplex DF3033-EU User manual

Dimplex

Dimplex DWF3651B User manual

Dimplex

Dimplex DWF1215B User manual

Dimplex

Dimplex 314 CHE User manual

Dimplex

Dimplex DF2608-INT User manual

Dimplex

Dimplex DF3033ST User manual

Dimplex

Dimplex ROTHESAY RSY20 User manual

Dimplex

Dimplex BF33ST Quick start guide

Dimplex

Dimplex SCANDIC User manual

Dimplex

Dimplex Silverton SVT20 User manual

Dimplex

Dimplex VF5452L User manual

Dimplex

Dimplex MULTIFIRE DF3015 User manual

Dimplex

Dimplex Ravello RVO20 User manual

Dimplex

Dimplex Opti-myst RTOPW20 User manual

Dimplex

Dimplex VFA2927 User manual

Dimplex

Dimplex DIMPLEX ELECTRIC FIREPLACE User manual

Dimplex

Dimplex DF2608-EU User manual

Dimplex

Dimplex CAS400 User manual

Dimplex

Dimplex EF2870 User manual

Dimplex

Dimplex Bach User manual

Popular Indoor Fireplace manuals by other brands

Brigantia

Brigantia 35-DVRS31N-2 User's installation, operation and maintenance manual

Nordpeis

Nordpeis Bergen Installation and user manual

Superior

Superior BCT2536TMN Installation and operation instructions

Quadra-Fire

Quadra-Fire 5100I-GD-B owner's manual

Renaissance

Renaissance RUMFORD 1000 user manual

Lacunza

Lacunza IV-800 Instruction book

Baxi

Baxi 940 Installer and owner guide

Dru

Dru Maestro 60/2 Tall RCH installation manual

Diamond Fireglass

Diamond Fireglass SS-O22 General assembly, installation, and operation instructions

HearthStone

HearthStone Windsor Bay 8830 Owner's manual and installation guide

Napoleon

Napoleon ASCENT B42 quick start guide

Enviro

Enviro E33GI owner's manual

Smeg

Smeg L30 FABE Installation & user's instructions

KEDDY

KEDDY K700 Installation instructions care and firing instructions

Godin

Godin 3451 manual

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Installation and operation instructions

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 operating manual

Desa

Desa CCFPDFT Owner's operating & installation manual