DEVI DEVIreg Touch User manual
DEVIreg™ Touch
Electronic Intelligent Timer Thermostat
Installation Guide
www.DEVI.com
Table of Contents
1 Introduction ............... 3
1.1 Technical Specifications ..... 4
1.2 Safety Instructions ........ 7
2 Mounting Instructions ......... 8
3 Settings ................. 12
3.1 Initial Settings .......... 12
3.2 Forecast .............. 16
3.3 Window Open .......... 18
3.4 Maximum Floor Temperature . 19
4 Symbols ................. 23
5 Warranty ................. 24
6 Disposal Instruction .......... 24
1 Introduction
DEVIreg™ Touch is an electronic programmable timer ther-
mostat used for controlling electrical floor heating ele-
ments. The thermostat is designed for fixed installation
only and can be used for both direct heating of the entire
room and for comfort heating of the floor. Among others,
the thermostat has the following features:
ƒA touchscreen display with backlight.
ƒAn easy-to-follow menu-driven programming and op-
eration.
DEVIreg™ Touch
Installation Guide 3
ƒAn installation wizard with room/floor type-specific
setup.
ƒSupport for multiple frame systems.
ƒCompatible with several 3rd party NTC sensors.
ƒThermostat settings can be specified before installa-
tion and imported to the thermostat using a web-gen-
erated code, or copied from a thermostat in a similar
installation.
ƒSmart access to thermostat settings after installation
by using a web code interface for easy setup or remote
troubleshooting.
More information on this product can also be found at:
touch.devi.com
1.1 Technical Specifications
Operation voltage 220-240 V~, 50/60 Hz
Standby power con-
sumption
Max. 0.40 W
Relay:
Resistive load
Inductive load
Max. 16 A / 3680 W @ 230 V
cos φ= 0.3 Max. 1 A
DEVIreg™ Touch
4 Installation Guide
Sensing units NTC 6.8 kOhm at 25°C
NTC 10 kOhm at 25°C
NTC 12 kOhm at 25°C
NTC 15 kOhm at 25°C (Default)
NTC 33 kOhm at 25°C
NTC 47 kOhm at 25°C
Sensing values: (De-
fault NTC 15 K)
0°C
20°C
50°C
42 kOhm
18 kOhm
6 kOhm
Control PWM (Pulse Wide Modulation)
Ambient temperature 0° to +30°C
Frost protection tem-
perature
5°C to +9°C (default 5°C)
Temperature range Room temperature: 5-35°C.
Floor temperature: 5-45°C.
Max. floor: 20-35°C (if unrecovera-
ble seal is broken then up to
45°C).
Min. floor: 10-35°C, only with
combination of room and floor
sensor.
DEVIreg™ Touch
Installation Guide 5
Sensor failure moni-
toring
The thermostat has a built-in
monitoring circuit, which will
switch off the heating if the sen-
sor is disconnected or short-
circuited
Cable specification
max.
1x4 mm2or 2x2,5 mm2
Ball pressure test
temperature
75°C
Pollution degree 2 (domestic use)
Controller type 1C
Software class A
Storage temperature -20°C to +65°C
IP class 21
Protection class Class II -
Dimensions 85 x 85 x 20-24 mm (in-wall
depth: 22 mm)
Weight 103 g
Electrical safety and Electro-Magnetic Compatibility for this
product is covered by the compliance with the EN/IEC
Standard “Automatic electrical controls for household and
similar use”:
ƒEN/IEC 60730-1 (general)
ƒEN/IEC 60730-2-9 (thermostat)
DEVIreg™ Touch
6 Installation Guide
1.2 Safety Instructions
Make sure the mains supply to the thermostat is turned off
before installation.
IMPORTANT: When the thermostat is used to control a
floor heating element in connection with a wooden floor or
similar material, always use a floor sensor and never set the
maximum floor temperature to more than 35°C.
Please also note the following:
ƒThe installation of the thermostat must be done by an
authorized and qualified installer according to local
regulations.
ƒThe thermostat must be connected to a power supply
via an all-pole disconnection switch.
ƒAlways connect the thermostat to continuous power
supply.
ƒDo not expose the thermostat to moisture, water, dust,
and excessive heat.
DEVIreg™ Touch
Installation Guide 7
2 Mounting Instructions
Please observe the following placement guidelines:
Place the thermostat at a suitable height on
the wall (typically 80-170cm.).
The thermostat should not be placed in wet
rooms. Place it in an adjacent room. Always
place the thermostat according to local regula-
tion on IP classes.
Do not place the thermostat on the inner side
of an exterior wall.
Always install the thermostat at least 50 cm.
from windows and doors.
Do not place the thermostat in a way that it
will be exposed to direct sunlight.
DEVIreg™ Touch
8 Installation Guide
Note: A floor sensor enables a more accurate
temperature control and is recommended in
all floor heating applications and mandatory
under wooden floors to reduce the risk of
over-heating the floor.
ƒPlace the floor sensor in a conduit in an appropriate
place where it is not exposed to sunlight or draft from
door openings.
ƒEqually distant and >2cm from two heating cables.
ƒThe conduit should be flush with the floor surface -
countersink the conduit if necessary.
ƒRoute the conduit to the connection box.
ƒThe bending radius of the conduit must be min 50mm.
DEVIreg™ Touch
Installation Guide 9
Follow the steps below to mount the thermostat:
1. Open the thermostat:
Important: Do NOT press on the display screen when
removing the front part.
Press your fingers under the side of the front part and
pull toward you:
2. Connect the thermostat according to the connection
diagram.
DEVIreg™ Touch
10 Installation Guide
Other manuals for DEVIreg Touch
3
Table of contents
Other DEVI Thermostat manuals
DEVI
DEVI devireg 530 User manual
DEVI
DEVI DEVIreg 535 User manual
DEVI
DEVI devireg 550 User manual
DEVI
DEVI DEVIreg Opti User manual
DEVI
DEVI DEVIreg 535 User manual
DEVI
DEVI devireg 550 User manual
DEVI
DEVI VUGDB202 User manual
DEVI
DEVI devireg 550 User manual
DEVI
DEVI DEVIreg 130 User manual
DEVI
DEVI Devireg 330 User manual
DEVI
DEVI Devireg 330 Operating and maintenance manual
DEVI
DEVI Devireg 530 Series User manual
DEVI
DEVI Devilink FT User manual
DEVI
DEVI DEVIreg 535 User manual
DEVI
DEVI devireg 132 User manual
DEVI
DEVI Devireg 330 User manual
DEVI
DEVI devireg 550 User manual
DEVI
DEVI devireg 532 User manual
DEVI
DEVI devireg 531 User manual
DEVI
DEVI DEVIreg Touch User manual
Popular Thermostat manuals by other brands
Saswell
Saswell SAS920XWHB-7-S-RF User manual and warranty card
Aircalo
Aircalo TFP1-ET85P2 operating manual
Honeywell
Honeywell CM721 user manual
Carrier
Carrier DEBONAIR 33CS Installation and operating instructions
Lennox
Lennox iHarmony Zone Thermostat Installation and setup guide
Gemtech
Gemtech GT7000 Operation
