Da-Lite Parallax Thin User manual

INSTRUCTION BOOK FOR

Parallax™Thin

Preparation

Note: It requires two people to install a Parallax Thin. To maintain

optimal projected image geometry and screen alignment, a lat

and straight wall free from obstructions and angular distortions

should be used.

Tools Required For Assembly

Level Measuring Tape

Choose a clean work area for assembly using padded material or

other soft, clean materials. The work area should be larger than

the overall screen size and directly in front of the location where

the screen is to be installed.

Hardware Provided

44” Wall Bracket

(2) 92”, 96” and 105½” Wide Screens

28” Wall Bracket

(2) 80” and 87” Wide Screens

Cleaning

Parallax screen surface can be cleaned as follows:

Using a white clean cloth (100% cotton preferred) that is dampened with clean water, gently wipe the area in a horizontal direction. Do

not wipe in a vertical direction or with a circular motion. Using a dry 100% cotton cloth, wipe screen surface dry in horizontal direction

after each cleaning. Windex Original spray cleaner can be used on tough to clean areas.

Drill Drill Bits

(1) Striker plate with countersunk hole for #10 screw

Figure 1

Wall Mounting Instructions

NOTE: The screen is shipped with two wall brackets. Screens in

widths of 88¾” and below receive (2) 28” wall brackets. Screens

above 88¾” in width receive (2) 44” wall brackets. Use appropriate

mounting hardware for the wall type and to accommodate for

the screen’s hanging weight (Figure 1).

1. Secure the two wall brackets to wall studs at the desired height.

The outside edge of each wall bracket must be no greater than 5”

away from the left and right edges of the frame. You will need at

least 2” clearance above the drilled holes to hang the screen

(Figure 1) .

2. To install the striker plate, take your screens overall height

(including frame) and subtract 1¼”. Using that dimension, measure

down from the top edge of the wall brackets and mark the wall

for a screw hole (Figure 1).

NOTE: Make sure your mark corresponds with where you intend

the center of your image to be once the screen is fully installed.

3. Secure the striker plate to the wall at the marked locations.

NOTE: Make sure the screw head is lush to the face of the striker

plate so that the full pull force of the magnet is acheived.

4. With two people, one on either end of the screen, lift the screen

onto the wall. Making sure the wall brackets are securely seated in

the back of the screens frame.

5. Slowly lower the bottom of the screen, making sure the center of

the screen is aligned with the striker plate on the wall.

CAUTION: Pinch Hazard. While lowering the screen, be

careful to keep your ingers clear of the magnet and striker

plate.

Overall Height Less 1¼”

Striker Plate

LIMITED ONE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTS

Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in

materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly

operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the

factory.

This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered

with or repaired by a person other than authorized Da-Lite personnel.

Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise.

Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite,

transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.

To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS

OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of itness for use,

or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. This warranty gives

you speciic legal rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT PERMITTED

BY APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION

OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Customer Care Specialists at

3100 North Detroit Street, Warsaw, IN 46582, (574) 2678101, (800) 6223737.

IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DALITE BRANDED PRODUCTS SHALL NOT BE BOUND BY THIS

WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DALITE WRITTEN INSTRUCTIONS.

Keep your sales receipt to prove the date of purchase and your original ownership.

29090

A Milestone AV Technologies Brand

3100 North Detroit Street

Warsaw, Indiana 46582

P: 574.267.8101 or 800.622.3737

F: 574.267.7804 or 877.325.4832

E: info@da-lite.com

www.da-lite.com

DL–0632 01.16

Other Da-Lite Projection Screen manuals

Da-Lite

Da-Lite TENSIONED CONTOUR ELECTROL User manual

Da-Lite

Da-Lite Designer Electrol User manual

Da-Lite

Da-Lite Model B User manual

Da-Lite

Da-Lite Designer Contour® User manual

Da-Lite

Da-Lite TENSIONED EXECUTIVE ELECTROL User manual

Da-Lite

Da-Lite EXECUTIVE ELECTROL User manual

Da-Lite

Da-Lite DELUXE MODEL B User manual

Da-Lite

Da-Lite ADVANTAGE DELUXE ELECTROL User manual

Da-Lite

Da-Lite Theater-Lite User manual

Da-Lite

Da-Lite ADVANTAGE DELUXE ELECTROL User manual

Da-Lite

Da-Lite Cosmopolitan Electrol User manual

Da-Lite

Da-Lite Parallax User manual

Da-Lite

Da-Lite TENSIONED LARGE ADVANTAGE ELECTROL User manual

Da-Lite

Da-Lite ADVANTAGE ELECTROL User manual

Da-Lite

Da-Lite Da-Snap Screen User manual

Da-Lite

Da-Lite Tensioned Conference Electrol User manual

Da-Lite

Da-Lite ExecutiveElectrol User manual

Da-Lite

Da-Lite Senior Electrol User manual

Da-Lite

Da-Lite IDEA Screen User manual

Da-Lite

Da-Lite Large Cosmopolitan Electrol User manual

Da-Lite

Da-Lite DESIGNER ELECTROL User manual

Da-Lite

Da-Lite Wireline Advantage User manual

Da-Lite

Da-Lite ADVANTAGE ELECTROL User manual

Da-Lite

Da-Lite Viewshare tensioned Advantage Electrol User manual

Popular Projection Screen manuals by other brands

FART PRODUKT

FART PRODUKT Standard SCREEN Installation instruction

Draper

Draper E Series Installation & operating instructions

Elite Screens

Elite Screens Elite Tripod Series user guide

Laarhoven

Laarhoven Companion II General assembly instructions

Renogy

Renogy RMS-LFPS-US manual

Samsung

Samsung S*H65* user manual

FONESTAR

FONESTAR PPTR-43100-FA quick start guide

Slide Clear

Slide Clear Varro XL installation instructions

Elite Screens

Elite Screens M85XWS1-SRM manual

OS РХ-090Н user manual

Niko

Niko 10-845 Product information

Speaka Professional

Speaka Professional 2357532 Important information

Sima

Sima XL-72 instruction manual

Jasic

Jasic EVO 2.0 ET-200P Fitting instructions

Elite Screens

Elite Screens Starling 2 Series user guide

InFocus

InFocus SC-WALL GRY-92H Instruction guide

Barco

Barco OverView MVL-615 Brochure & specs

Draper

Draper Envoy Installation & operating instructions