Creda C60CHX User manual
1
USER
MANUAL
CHIMNEY COOKER HOOD
V 1.0
MODEL/S
C60CHX
C90CHX
C90CHA
2
USER
MANUAL
You’ll soon be enjoying your new Creda Cooker Hood!
It all begins here, with your instructions. Don’t worry, there’s nothing too technical
coming up. Just simple, step-by-step guidance to get you up and running quickly. Sound
good? Then let’s get started.
Help and Guidance
We’re here to help you get the most from your appliance.
Should you require any guidance, a simple solution can often be found online at:
www.creda.co.uk
If you still require further assistance, call one of our experts on 01759 487836.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can
often be found in the Troubleshooting section of these instructions, or online at www.creda.co.uk If you still require
further assistance, call one of our experts on 01759 487836.
3
USER
MANUAL
Contents
PAGE
4
5
6
7
10
12
12
13
13
14
15
—
Safety instructions
General overview
Accessories
Installation
Use of Cooker Hood
Control panel
Maintenance and cleaning
Efficient use of the device
Transporting the device
Troubleshooting
Help and Assistance
4
USER
MANUAL
SAFETY INSTRUCTIONS
1. It is recommended that the product is installed by authorized persons. Installation by unauthorized persons
could lead to poor operation performance, damage to the product, and accidents. The product will not be
covered by the warranty.
2. Electric cooker hoods shall not be connected to a flue or air duct that is used to discharge the smoke from
devices that use gas or other fuels (stove, water heater, thermosiphon, etc.). This warning does not apply to
uses without flue.
3. Comply with the regulations of the authorities on the discharge of outlet air. (Not applicable for devices that
discharge air back into the room)
4. When the cooker hood is placed on a gas burning device, the distance between the hob and the hood should
be at least 65 cm. If a larger distance is specified in the installation instructions of the gas burning hob, this
value should be taken into account.
5. While the hood is running, ensure fresh air can enter the environment; especially when used at the same time
with ovens that use gas and appliances that use solid and gas fuel.
6. For your safety, use” Max 6 A” fuses in the hood installation.
7. Do not leave boiling oil on the stove. Pots that contain boiling oil may catch fire by themselves.
8. Do not operate the stove without cookware placed on them. High heat may cause some parts of your product
to deform and lead to fire.
9. The packages pose a danger to children. Never allow children to play with packaging materials. Keep
packaging materials out of reach of children.
10.Clean the oil absorbent aluminum filters regularly. Filters pose risk of fire due to accumulated grease deposits
on them.
11.Do not operate your product without filter, and do not remove the filters when the product is in operation. Do
not use filtering materials that are not fire-resistant instead of the filter.
12.Flammable foods must not be cooked under the appliance.
13.In case of any fire, de-energize the device. Cover the flames with a damp cloth or towel. Never use water to
extinguish the fire.
14.Failure to comply with deadlines and instructions while cleaning may result in a fire hazard.
15.This device should not be used by children, persons with physical, sensory or mental disabilities, persons
lacking experience or technical knowledge. Do not allow the persons and children that are not under custody to
use the product, play with the product, to perform maintenance and cleaning on the product.
16.Kitchen hoods are designed for domestic use. They should not be used for other purposes. Otherwise, it may
cause various accidents and the device will be out of warranty.
17.The electrical connection of the product must be made to a grounded outlet.
18.The electrical connection should only be made once the installation of the appliance has been completed.
19.Before the installation, maintenance and cleaning of the product, de-energize the device. (Unplug the device or
turn off the fuse).
20.It is forbidden to install the power cord near equipment or materials that may come into contact with water and
cause distortion of the cord. This may cause fire.
21.Avoid touching the lamps in your product when they have been operating for a long period of time. Since they
would be hot, they could burn your hand.
22.Accessible sections may be hot when used with cooking appliances.
23.Failure to install screws or fasteners in accordance with these instructions may result in electrical hazards.\
24. Your device is manufactured in accordance with 220-240 V 50Hz AC power supply and requires a fuse of 16
Amp. Should your electrical system differ from these specified values, contact a licensed electrician or your
authorized service center.
5
USER
MANUAL
GENERAL VIEW
Note: Product images are representative. Product may vary in size and model.
1.Inner flue
2.Outer flue
3.Body
4.Filter
5.Control panel
6.Light
7.Handle*
6
USER
MANUAL
ACCESSORRIES
7
USER
MANUAL
INSTALLATION
Mounting Distances
Distance between the cooker and the cooker hood must be considered prior to assembly. The distance between
the hob and the hood shall be at least 65 cm.
Body Mounting
Drill the product from points Awith a Ø8 drill bit and from
points Bwith a Ø6 drill bit as per the dimensions given
below. Tap Ø8 and Ø6 dowels. From the points A,
perform installation to the body with a Ø5 x 50 mm screw;
and from points B, perform installation to the inner flue
connection plate with a Ø3.9 x 30 mm screw.
Note: The dimensions provided above are determined by
considering the distance between the lower contact point
of the cooking pot and the bottom of the hood is 650 mm.
8
USER
MANUAL
Carbon Filter Assembly
Open the product cover and take out the aluminum filter. Turn the carbon filter in the direction of the arrow by
pressing the sides. (see Fig. 1-2)
Flap Assembly
Air Discharge valve prevents the entry of foreign bodies in the engine group in the installation of the products with a
flue. Install the flap as shown in Figures 3 and 4 by removing the product from the installation package.
9
USER
MANUAL
Mounting of Aluminum Pipe
Mount the flexible aluminum pipe on the flue. Install the other end of the pipe to the flue hole in the kitchen. Spiral
tube and screw clamp are not included in the product accessories. They should be purchased additionally. (See
Fig. 6)
Note: Aluminum spiral tube is used for connections with flue.
Since twists and bends in the aluminum pipe will lead to reduction in the air suction power, avoid formation of twists
and bends as much as possible. (see Fig. 7-8)
Flue Installation
Secure the external flue to the body with 2 pieces of Ø3.5 x 9.5 mm screws as shown in Figure 9. Secure the inner
flue to the inner flue connection plate with 2 pieces of Ø3.5 x 9.5 mm screws as shown in figure 10.
1.Outer Flue
2.Ø3.5 x 9.5 mm Screw x 4
3.Chimney connection sheet x 1
4. Inner Flue
10
USER
MANUAL
Installation of the Handle *
To install the handle, remove the filters first as shown in Figure 11. After aligning the handle with the installation
holes as shown in figure 12, tighten the handle screw to the handle from the interior of the hood.
USE OF THE COOKER HOOD
Hood may be used in kitchens with or without flue.
Air Outlet Connection
Air discharge can be done by flue connection (air discharge to the external environment) or by filtering the air back
to the environment (carbon filter).
Operation with Flue Connection
For flue-connected operation, Ø120 mm spiral pipe and clamp must be provided from an authorized service or a
point recommended by service.
Flueless operation
The absorbed air is delivered to a flue or outdoor environment with the help of a pipe attached
to the blower motor outlet of the hood in use with flue connection.
WARNING: These parts are not included in the product content and must be purchased.
WARNING: In case of installation to a chimney, it is necessary to note all relevant warnings in the safety and
environmental instructions.
During flueless operation, the air sucked by the activated carbon filter mounted on the blower
motor side parts or hood body is filtered and returned to the environment.
This manual suits for next models
2
Table of contents
Other Creda Ventilation Hood manuals
