Cornelius P/N 629083202 User manual

ED150 ‘’K’’ Style Lid Kit Installation Instructions

INSTALLATION INSTRUCTIONS

ED150 “K” STYLE LID KITS,

P/N 629083204 AND 629083202

Revision Date: April 18, 2011 www.cornelius.com Revision:D

These “K” style kits apply to the following ice maker:

WARNING:

Disconnect power to the unit before installing the adaptor following all lockout/tag out procedures established by the

user. Verify all the power is off to the unit before performing any work.

Failure to comply could result in serious injury, death or damage to the equipment.

WARNING:

All ice baffle plates and bin states, if included or recommended in this kit, must be installed as directed in this manual

or the equipment manufacturer’s instructions.

Failure to comply could result in serious injury, death or damage to the equipment.

WARNING:

All of the attachment screw and plates must be installed as directed in this manual.

Failure to comply could result in serious injury, death or damage to the equipment.

Table 1. Appropriate Model

Ice maker Width

Manitowoc Q320/420 22”

Table 2. Loose Shipped Parts

Item No. Part No. Name Catty.

1 52994 Cover, Gray (629083202) 1

52934 Cover, Black (629083204)

2620027505 DF150 Ice Maker Lid Assembly 1

3 620027306 Bracket 2

4 70217 #8 Screw 6

5 50904 RTV 1

6 90221 Label 1

7 620909401 Installation Instruction 1

8 620701902 Acorn Nut, 8-32 Nylon 2

9 620701901 Sealing Washer 2

10 620042928 Baffle Ice ED150 Adapter Lid 1

11 621701903 #8 Nylon Washer 2

ED150 ‘’K’’ Style Lid Kit Installation Instructions

1. Unpack the kit.

2. Insert a baffle assembly into the adapter lid.

3. Place (2) sealing washers (item 9) over studs and (2) flat washers (item11), then fasten in place with (2)

plastic acorn nuts (item 8).

4. Set ice maker lid on the top of the dispenser.

5. Using the slotted holes in the lid as a template, drill four (4) 9/64I diameter holes at the bottom of the slots

(see Detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8

sheet metal screws, two on each side.

6. Seal the ice maker to the top of the dispenser as follows:

A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so

that the ice maker sets on the RTV.

B. Set the ice maker onto the lid and position it as required.

C. Wipe away the excess RTV.

7. Remove the two rear screws (only) installed in step 5. Use those screws to install the mounting brackets

(item3). Drill 9/64I diameter holes into the ice maker cabinet using the bracket as a template. Use extreme

care not to drill into any ice maker components (condenser, tubing, etc.). Secure the brackets using the

screws provided.

8. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the

bin thermostat if so equipped or required.

9. If the plastic acorn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary to

make small notches in the back flange of the cover to clear the acorn nuts.

CAUTION:

Bin Thermostat must not interfere with the agitator rotation.

ED150 ‘’K’’ Style Lid Kit Installation Instructions

Figure 1. Dispenser Assembly

ED150 ‘’K’’ Style Lid Kit Installation Instructions

Figure 2. ED150 Kit

ED150 ‘’K’’ Style Lid Kit Installation Instructions

View Z-Z

Figure 3. ED150 Kit Detail

This manual suits for next models

Table of contents

Other Cornelius Ice Maker manuals

Cornelius

Cornelius SPIRE 4.1 User manual

Cornelius

Cornelius Enduro-300 IntelliCarb User manual

Cornelius

Cornelius Nordic CCM0830 1 Guide

Cornelius

Cornelius 500 - Series User manual

Cornelius

Cornelius Nordic CCM1848 Guide

Cornelius

Cornelius Nordic CCM0322 Guide

Cornelius

Cornelius Quantum 1000 User manual

Cornelius

Cornelius D3030-1 User manual

Cornelius

Cornelius WCF1411-A Series User manual

Cornelius

Cornelius 500 - Series User manual

Cornelius

Cornelius 1000-Series User manual

Cornelius

Cornelius ICE MAKER User manual

Cornelius

Cornelius Hoshizaki KM250 User manual

Cornelius

Cornelius 500 - Series User manual

Cornelius

Cornelius DPT 230 Supplement

Cornelius

Cornelius UC 700 Series Supplement

Cornelius

Cornelius XTREME 631812001 Setup guide

Cornelius

Cornelius XTREME 631806001 Setup guide

Cornelius

Cornelius ED150 "K" Style Lid Kit User manual

Cornelius

Cornelius XWC1230 User manual

Cornelius

Cornelius Nordic CCM1448 Guide

Cornelius

Cornelius I Series 224 User manual

Cornelius

Cornelius WCC 2001 QT-R User manual

Cornelius

Cornelius UCR 700 Series Supplement

Popular Ice Maker manuals by other brands

Hoshizaki

Hoshizaki KMD-460MWJ instruction manual

Sub-Zero

Sub-Zero 315I Planning information

Unold

Unold 48945 Instructions for use

Kenmore

Kenmore 2217402A Use & care guide

GE XPIO43SCSS owner's manual

Hoshizaki

Hoshizaki KMD-901MAH Specifications

Whynter

Whynter FIM-450HA instruction manual

U-Line

U-Line UMCR014-SC01A User guide & service manual

Andrew James

Andrew James AJ000522 manual

Scotsman

Scotsman CME1356 user guide

Scotsman

Scotsman ACM 25 Service manual

Kärcher

Kärcher IP 120 manual

U-Line

U-Line SS1095 Quick referenc guide

Maytag

Maytag MIM1554WRS - Ice Maker User instructions

Hoshizaki

Hoshizaki KM-630MAH instruction manual

Princess

Princess Yonanas user manual

Unold

Unold 48946 Instructions for use

Electrolux

Electrolux E15IM60GP Factory parts catalog