Introduction
Thanks for choosing the Comax’s
wireless PIR motion sensor
Wave
TM
enabled device (interoperable, two
Z-Wave
TM
enabled network. Every
devices result in more possible transmissi
Z-Wave
TM
enabled device displaying the Z
and ours can also be used in other manufacturer’s Z
and send Z-Wave
TM
signal when movement is detected inside the building
Product Description
Specification:
Protocol: Z-
Operating Range: Up to 50M
Installation
1. Open the cover and i
nsert battery into the battery compartment, LED will start to flash slowly.
2. Close the back cover.
To add the sensor, Put the Z-
CM-PIR03 to your controller
. Press the program switch of
stop flashing, if not, please try again.
To Delete the sensor
instruction to delete the CM-
deleted. The LED on the
3. Mount the sensor
at 2 meters above surface. To enhance proper operation, place
can detect the room widely.
Operation Manual
Wireless PIR Motion Sensor
CM-PIR03
wireless PIR motion sensor
for
the home security device. This sensor is a Z
enabled device (interoperable, two
-
way RF mesh networking technology) and is fully compatible with any
powered Z-Wave
TM
enabled device acts as a signal repeater and multiple
devices result in more possible transmissi
on routes which helps eliminate “RF dead-spots”.
enabled device displaying the Z
-Wave
TM
logo can also be used with it regardless of the manufacturer,
and ours can also be used in other manufacturer’s Z
-Wave
TM
enabled networks. This sensor mon
signal when movement is detected inside the building
.
868.4MHz
,
865.2MHz
Operating Range: Up to 50M
line of sight
-10°C to 50°C
-1pcs
nsert battery into the battery compartment, LED will start to flash slowly.
Interface Controller into “add” mode, and follow
. Press the program switch of
CM-PIR03
stop flashing, if not, please try again.
Put the Z-Wave Interface Controller into “
to your controller. Press the program switch of
should start to flash.
at 2 meters above surface. To enhance proper operation, place
sensor
the home security device. This sensor is a Z
-
way RF mesh networking technology) and is fully compatible with any
enabled device acts as a signal repeater and multiple
logo can also be used with it regardless of the manufacturer,
enabled networks. This sensor mon
itors movement,
nsert battery into the battery compartment, LED will start to flash slowly.
to add the
sensor should
once to be
on the angle which
