The DWC-55 Roller Shutter Door Sensor is used for rolling gates.
When the Metal Magnet and the Metal Reed Switch are
separated more than 2cm, it will transmit wireless alert signal to
the connected control panel immediately. The lifespan of the
battery depends on the frequency of opening and closing the
door/gate, the normal battery’s service life is about 12 to 15
months.
Introduction
DWC-55
Roller Shutter
Door Sensor
LED Indication
Flashes once: Door opening is detected.
Low power indication; please change Flashes once every 3 seconds:
the batteries as soon as possible.
Product Overview
User Manual
Pair with Control Panel
Install it on the bottom of the rolling gate which 1. Metal magnet:
can move up and down, it should be parallel to the ground but
don’t over the bottom.
2. Metal reed switch: Install it on the ground and make sure the
distance between the metal magnet is less than 2cm.
3. Transmitter: It is connected with the metal reed switch and
should be mounted on the wall beside the rolling gate (Away from
the gate as far as possible because metal may disturb wireless
transmission).
4. Test: Set the control panel to Arm State, close the gate and
open it over 2cm, the sensor is working well if the LED indicator
flashes once and the system alarm goes off.
Specifications
BatteryDC 3V (AAA 1.5V LR03 x 2 PCS)
Static Current <23 uA
Alarm Current <40 mA
Transmitting Distance <80m (in open area)
Radio Frequency 315 MHz/433.92MHz (±75KHz)
Housing MaterialABS plastic
Operation ConditionTemperature -10°C~+55°C
Relative Humidity<80% (non-condensing)
105.5 X 15.5 X15.5 mmMetal Magnet Dimensions (L x W x H)
105.5 X 38 X 9.6 mmMetal Reed Switch Dimensions (L x W x H)
107 X 54 X 14.5 mmTransmitter Dimensions (L x W x H)
Ver : DWC-55-UM-EN-V1.0
2016 Chuango. All rights reserved.
Antenna
LED
Indicator
Transmitter
Metal MagnetMetal Reed Switch
Installation
Important:
Please test the sensor to make sure the connected control panel
can receive the transmitting signal of the sensor before fixing it in
place.
Install the sensor inside the house.
Steps:
1. Make sure the control panel enters Pairing Accessory State
(Please refer to the details in the control panel’s user manual)
2. Separate the Metal Magnet and the Metal Reed Switch for more
than 2cm. The control panel beeps once to indicate a successful
pairing. Note: If only LED indicator flashes once but the system alarm does not go
off, please pull out the antenna of DWC-55 or move the control panel a
little closer to the sensor.
