C.P. Electronics EBMPIR-MB-B User manual

PIR Sensor

Detects movement within the unit’s detection range,

allowing load control in response to changes in occupancy.

Front view

PIR lens

which covers...

PIR sensor

Overview

The EBMPIR-MB-B miniature PIR (passive infrared)

presence detector provides automatic control of lighting

loads. It is specifically designed for mounting onto a batten

style luminaire.

The detector will switch incandescent, fluorescent, compact

fluorescent and LED lighting.

The unit detects movement using a PIR sensor and turns

the load on. When an area is no longer occupied the load

will switch off after a 10 minute time out period.

Features

Product Guide

Cables to luminaire control gear

Batten mount PIR detector

EBMPIR-MB-B

Detection diagram

Range

Walk towardsWalk across

Height Range Diameter

7m 10m

2.8m 5m

Height Range Diameter

7m 16m

2.8m 9m

Note: illustration shows an average of the walk across and walk towards figures below.

 When power is applied to the unit, the load will turn on immediately.

 For the first 5 minutes of operation the time out period is 10 seconds to aid commissioning.

 Vacate the room or remain very still for more than 10 seconds and wait for the load to switch off.

 Check that the load switches on when movement is detected.

 When the 5 minutes have elapsed the time out will be 10 minutes.

Power-up test procedure

What if the load does not turn ON?

 Check that the live supply to the circuit is good.

 Check that the load is functioning by bypassing the sensor (e.g. link Land L/ Out).

What if the load does not turn OFF?

 Ensure that the area is left unoccupied for longer than the 10 minute time out period.

 Ensure that the sensor is not adjacent to circulating air, heaters or lamps.

Fault finding

Wiring diagram

Installation

Components

Standard luminaire fitting

IP luminaire fitting

Part Quantity

Supplied

IP Spacer with silicone coating 1

Silicone washer 1

5º washer 1

5º spacer 1

M20 nut 1

Mounting hole without key

Mounting hole with key

Note. Key to be at top of

sensor.

Note. Use the 5ºspacers

where the luminaire

housing has a draft angle.

Important

Ensure that the silicone washer and/or the IP spacer are used to maintain IP rating.

Do not grip unit at the lens end. Hold the square body near the threaded end when installing and tightening the

nut. Care must be taken to prevent damage to the lens and surrounding IP seal.

Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.

Dimensions See diagrams opposite.

Weight 0.10kg

Supply Voltage 230VAC +/- 10%

Frequency 50Hz

Maximum Switching Load 2 Amps fluorescent and incandescent

lighting.

2 Amps compact fluorescent lighting.

2 Amps low energy lighting.

2 Amps low voltage lighting (switch primary

of transformer).

Switch SON lighting loads via a contactor.

Power consumption On 799mW, Off 807mW

Cable specification 1m 1/1.13 solid core cable 105ºC

Temperature -10ºC to 50ºC

Humidity 5 to 95% non-condensing

Material Flame retardant ABS/PC

Type Class 2

IP rating IP65

Compliance EMC-2004/108/EC

LVD-2006/95/EC

Technical data

C.P. Electronics Ltd

Brent Crescent

London

NW10 7XR

United Kingdom

Tel: + 44 (0) 333 900 0671

Fax: + 44 (0) 333 900 0674

www.cpelectronics.co.uk

[email protected]

Ref: #WD601 Issue 3

FM 45789 EMS 534520

IMPORTANT NOTICE!

This device should be installed by a qualified electrician in

accordance with the latest edition of the IEE Wiring

Regulations and any applicable Building Regulations.

Table of contents

Other C.P. Electronics Security Sensor manuals

C.P. Electronics

C.P. Electronics MWS1A-C-PRM User manual

C.P. Electronics

C.P. Electronics EBDSPIR User manual

C.P. Electronics

C.P. Electronics MWS3A User manual

C.P. Electronics

C.P. Electronics MWS3A-DD User manual

C.P. Electronics

C.P. Electronics MWS6 User manual

C.P. Electronics

C.P. Electronics GENB-IR User manual

C.P. Electronics

C.P. Electronics MWS3A-DD-LV User manual

C.P. Electronics

C.P. Electronics MWS3 Instruction manual

C.P. Electronics

C.P. Electronics EBDSPIR-PRM-L3 User manual

C.P. Electronics

C.P. Electronics EBDSPIR-DD User manual

C.P. Electronics

C.P. Electronics EBDHS-DD-LT30 User manual

C.P. Electronics

C.P. Electronics EBDMR-DNET1 User manual

C.P. Electronics

C.P. Electronics MWS6-PRM-VFC-NC User manual

C.P. Electronics

C.P. Electronics EBDHS-AD-LT30 User manual

C.P. Electronics

C.P. Electronics MWS5-DD-SA-C User manual

C.P. Electronics

C.P. Electronics green-i GEFL-IR User manual

C.P. Electronics

C.P. Electronics EBDHS-SR User manual

C.P. Electronics

C.P. Electronics EBDSPIR-CB User guide

C.P. Electronics

C.P. Electronics EBDHS -KNX Manual

C.P. Electronics

C.P. Electronics MWS6-AD User manual

C.P. Electronics

C.P. Electronics MWS6-PRM-LV User manual

C.P. Electronics

C.P. Electronics MWS3A-PRM-2CH-NC User manual

C.P. Electronics

C.P. Electronics MWS6-PRM-2CH-NC User manual

C.P. Electronics

C.P. Electronics EBDSPIR-AT-DD User manual

Popular Security Sensor manuals by other brands

THORLABS

THORLABS PDA10JT user guide

Waeco

Waeco UV-DETECT operating manual

Intermatic

Intermatic IOS-DSIMF manual

urmet domus

urmet domus 1083 manual

Siemens

Siemens AZL66 Series manual

BTI

BTI Profiline Multi Finder operating instructions

Challenger

Challenger SL01 instruction manual

DMP Electronics

DMP Electronics 1122INT installation guide

Rielta

Rielta Ladoga MK-RK installation guide

Mirion Technologies

Mirion Technologies ACCURAD PRD user manual

Bosch

Bosch DS835 installation instructions

DBI SALA

DBI SALA EZ Stop User instruction manual

Lamptime

Lamptime ST05C instructions

Ubiquiti

Ubiquiti MFI-MSC quick start guide

Subsite

Subsite 910R Support

Satel

Satel OPAL Pro manual

Aleph

Aleph XC-1XTEU manual

Pima

Pima LARIS QUAD installation instructions