Black Box LB9019A-R3 User manual

Installation

This installation guide gives step-by-step instructions about how to install the Express Ethernet Switches:

LB9019A-R3

Selecting a Site for the Express Ethernet Switch: LB9019A-R3

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures,

humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:

- The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

- The relative humidity should be less than 90 percent, non-condensing.

- Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3,

Level 2 (3V/M) field strength.

- Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of the

switch or the fan exhaust port on the rear of the switch.

- The power outlet should be within 1.8 meters of the switch.

Connecting to Power

yConnect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into

a standard AC outlet with a voltage range from 100 to 240 Vac.

Figure: Rear view of the switch

Connecting to Your Network

Cabling

yFirst, ensure the power of the switch and end devices are turned off.

<NOTE> Always ensure that the power is off before any installation.

yPrepare cable with corresponding connectors for each type of port in use.

yConsult Table 2 below for cabling requirements based on connectors and speed.

yConnect one end of the cable to the switch and the other end to a desired PC or workstation.

yOnce the connections between two end devices are made successfully, turn on the power and the

switch is operational.

Rece

tacle

Cable Length

The maximum distance of a node to a directly connected switch on a 100BASE-TX network is 100 meters with

Category 5 shielded twisted-pair (STP) cable or unshielded twisted-pair (UTP) cable. For a 10BASE-T network, it

may range up to 100 meters with Category 3, 4, or 5 STP/UTP cable.

The maximum segment distance between a node and a directly connected switch port on a 100BASE-FX network is

75 km using 10/125(or 9/125)µm single-mode fiber optic cable. It is capable of spanning at most 2 kilometers when

use of 62.5/125(or 50/125)µm multi-mode fiber-optic cable.

Table: Cable Specifications

Ethernet

Standards

Connector Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-T RJ-45 10/20

Mbps

Cat. 3, 4 or 5

UTP/STP

100 m

100BASE-TX RJ-45 100/200

Mbps

Cat. 5

UTP/STP

100 m

CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

INFORMATION Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web Site: www.blackbox.com yE-mail: [email protected]

Other manuals for LB9019A-R3

Table of contents

Other Black Box Switch manuals

Black Box

Black Box PSE544 User manual

Black Box

Black Box LE2425A User manual

Black Box

Black Box LGB708A-R3 User manual

Black Box

Black Box ServSwitch 4site User manual

Black Box

Black Box ISU2011-4-UK User manual

Black Box

Black Box KV9502A User manual

Black Box

Black Box SC120A-R2 User manual

Black Box

Black Box LGB6026A User manual

Black Box

Black Box KV7000A User manual

Black Box

Black Box KV1702A User manual

Black Box

Black Box ServSelect III KV21008A Installation and maintenance instructions

Black Box

Black Box LPJ008A-F User manual

Black Box

Black Box SW421A-R2 User manual

Black Box

Black Box LT0007A-4U User manual

Black Box

Black Box ServSwitch Wizard DVI KV1002A User manual

Black Box

Black Box LGB6026A Programming manual

Black Box

Black Box LB620C User manual

Black Box

Black Box IC562A User manual

Black Box

Black Box KV6416FA-R2 User manual

Black Box

Black Box SS4P-DVI-4X2-UCAC User manual

Black Box

Black Box LGH1004A User manual

Black Box

Black Box LBG1000A-R2 User manual

Black Box

Black Box KV5300 Series User manual

Black Box

Black Box ServSwitch CX Quad IP User manual

Popular Switch manuals by other brands

URC

URC Total Control MFS-8 installation manual

Azbil

Azbil HPQ-D11 user manual

Sony

Sony DFS-900M operating instructions

SICK

SICK i17S operating instructions

F&F

F&F SZR-277 quick start guide

Shure

Shure UAMS/BK user guide

Dräger

Dräger X-zone Switch Off Instructions for use

Asco

Asco Joucomatic 349 Series manual

BT Mini Hub user guide

D-Link

D-Link DES-1226G manual

Johnson Controls

Johnson Controls FS80-C installation instructions

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Configuration guide

MicroNet

MicroNet SP1200A user manual

Ruijie

Ruijie RG-PF2920 Series Hardware installation and reference guide

Altinex

Altinex DA1914SX user guide

MiLAN

MiLAN MIL-SM2401M user guide

RJM

RJM MASTERMIND PBC/6X user manual

Atlas

Atlas MMK-KVM8 owner's manual