Black Box KV9604A User manual

KV9604A

4-Port ServSwitch DT Series

USB/DVI/Audio KVM Switch

CUSTOMER

SUPPORT

INFORMATION

Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)

FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com • E-mail: [email protected]

FCC AND IC RFI STATEMENTS

FEDERAL COMMUNICATIONS COMMISSION

and INDUSTRY CANADA

RADIO FREQUENCY INTERFERENCE STATEMENTS

Class B Digital Device. This equipment has been tested and found to comply with

the limits for a Class B computing device pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. However, there is no guarantee that

interference will not occur in a particular installation. This equipment generates,

uses, and can radiate radio frequency energy, and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio

communications. If this equipment does cause harmful interference to radio or

telephone reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one of the following

measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

•Consult an experienced radio/TV technician for help.

CAUTION

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate

the equipment.

To meet FCC requirements, shielded cables and power cords are required

to connect this device to a personal computer or other Class B certified

device.

This digital apparatus does not exceed the Class B limits for radio noise emission from digital

apparatus set out in the Radio Interference Regulation of Industry Canada.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites

applicables aux appareils numériques de classe B prescrites dans le Règlement sur le brouillage

radioélectrique publié par Industrie Canada.

NORMAS OFICIALES MEXICANAS (NOM)

ELECTRICAL SAFETY STATEMENT

INSTRUCCIONES DE SEGURIDAD

1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de

que el aparato eléctrico sea operado.

2. Las instrucciones de seguridad y operación deberán ser guardadas para

referencia futura.

3. Todas las advertencias en el aparato eléctrico y en sus instrucciones de

operación deben ser respetadas.

4. Todas las instrucciones de operación y uso deben ser seguidas.

5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca

de la tina de baño, lavabo, sótano mojado o cerca de una alberca, etc..

6. El aparato eléctrico debe ser usado únicamente con carritos o pedestales que

sean recomendados por el fabricante.

7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea

recomendado por el fabricante.

8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá

a lo descrito en las instrucciones de operación. Todo otro servicio deberá ser

referido a personal de servicio calificado.

9. El aparato eléctrico debe ser situado de tal manera que su posición no

interfiera su uso. La colocación del aparato eléctrico sobre una cama, sofá,

alfombra o superficie similar puede bloquea la ventilación, no se debe colocar

en libreros o gabinetes que impidan el flujo de aire por los orificios de

ventilación.

10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor

como radiadores, registros de calor, estufas u otros aparatos (incluyendo

amplificadores) que producen calor.

11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo del

tipo descrito en el instructivo de operación, o como se indique en el aparato.

4-PORT SERVSWITCH DT SERIES USB/DVI/AUDIO KVM SWITCH

NOM STATEMENT

12. Precaución debe ser tomada de tal manera que la tierra fisica y la polarización

del equipo no sea eliminada.

13. Los cables de la fuente de poder deben ser guiados de tal manera que no

sean pisados ni pellizcados por objetos colocados sobre o contra ellos,

poniendo particular atención a los contactos y receptáculos donde salen del

aparato.

14. El equipo eléctrico debe ser limpiado únicamente de acuerdo a las

recomendaciones del fabricante.

15. En caso de existir, una antena externa deberá ser localizada lejos de las lineas

de energia.

16. El cable de corriente deberá ser desconectado del cuando el equipo no sea

usado por un largo periodo de tiempo.

17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean

derramados sobre la cubierta u orificios de ventilación.

18. Servicio por personal calificado deberá ser provisto cuando:

A: El cable de poder o el contacto ha sido dañado; u

B: Objectos han caído o líquido ha sido derramado dentro del aparato; o

C: El aparato ha sido expuesto a la lluvia; o

D: El aparato parece no operar normalmente o muestra un cambio en su

desempeño; o

E: El aparato ha sido tirado o su cubierta ha sido dañada.

4-PORT SERVSWITCH DT SERIES USB/DVI/AUDIO KVM SWITCH

TRADEMARKS USED IN THIS MANUAL

BLACK BOX, the Double Diamond logo, and ServSwitch are trademarks or

registered trademarks of BB Technologies, Inc.

IntelliMouse, Microsoft, Windows, Windows NT, and Windows Vista are either

registered trademarks or trademarks of Microsoft Corporation in the United States

and/or other countries.

Any other trademarks mentioned in this manual are acknowledged to be the property of the

trademark owners.

4-PORT SERVSWITCH DT SERIES USB/DVI/AUDIO KVM SWITCH

Contents

CONTENTS

Chapter Page

1. Specifications .......................................................................................................... 6

2. Overview .................................................................................................................. 7

2.1 Introduction .................................................................................................... 7

2.2 Components.................................................................................................... 8

2.2.1 Front Panel ............................................................................................ 8

2.2.2 Rear Panel.............................................................................................. 9

2.3 What’s Included ............................................................................................ 10

2.4 Cables That You’ll Need to Supply ............................................................. 10

3. Installation ............................................................................................................ 11

3.1 ServSwitch Placement................................................................................... 11

3.2 Hardware Installation................................................................................... 11

3.2.1 Connecting the Console Keyboard, Mouse, and Monitor ............. 11

3.2.2 Connecting the Computers................................................................ 13

3.2.3 Initial Power On .................................................................................. 13

4. Operation.............................................................................................................. 14

4.1 Powering Up the System .............................................................................. 14

4.2 Selecting Computers Using Front-Panel Buttons ...................................... 14

4.3 Function Button............................................................................................ 14

Appendix. Troubleshooting ....................................................................................... 16

A.1 Calling Black Box.......................................................................................... 16

A.2 Shipping and Packaging .............................................................................. 16

4-PORT SERVSWITCH DT SERIES USB/DVI/AUDIO KVM SWITCH

Specifications

Hotkeys: No

Resolution: 1600 x 1200 @ 60 Hz

Supported Operating Systems: Windows® 98 SE/Me/2000/XP, and

Windows Vista™

User Controls: (4) port buttons (labeled 1–4) also used for Scan time buttons and

AutoScan, (1) function button

Connectors: (1) Power;

Console end: (1) DVI-I, (4) USB Type A, (2) 3.5-mm jacks for audio (speaker

and microphone);

Computer end: (4) DVI-I, (4) USB Type B, (8) 3.5-mm jacks for audio

(speaker and microphone)

Indicators: (4) Port

Temperature Tolerance: Operating: 32 to 104°F (0 to 40°C);

Storage: -4 to +140°F (-20 to +60°C)

Power: From the interface or via a 5-VDC, 2-A power supply (included)

Size: 1.7"H x 8.7"W x 5.1"D (4.4 x 2.2 x 13 cm)

Weight: 2.2 lb. (1 kg)

NOTE: The KV9604A does not support hotkeys.

CHAPTER 2: Overview

Overview

2.1 Introduction

The 4-Port ServSwitch USB/DVI/Audio KVM Switch allows you to control up to

four computers from a single IBM® console (USB keyboard, USB mouse, and DVI

[Digital Visual Interface] monitor, plus audio). Supported mice include Microsoft®

IntelliMouse® and other mice.

Setup is fast and simple, and there’s no software to configure. Its small desktop

footprint is ideal for on or under your desktop. Use front-panel buttons on the

ServSwitch to select ports or start AutoScan. The front-panel LEDs will light with

the corresponding active port when switching between the computers. The

AutoScan function allows you to automatically scan and monitor all computers,

one by one, that are connected to the ServSwitch.

4-PORT SERVSWITCH DT SERIES USB/DVI/AUDIO KVM SWITCH

2.2 Components

2.2.1

FRONT PANEL

Figure 2-1 shows the 4-Port ServSwitch front view. Table 2-1 describes

the components numbered in the illustration.

 

 

Figure 2-1. The 4-Port ServSwitch front-panel view.

Table 2-1. Front-panel components.

Component

Description



Port selection buttons

Press buttons 1–4 individually to select

a computer.



Scan time buttons

Press buttons 1 and 2 together to

change the Scan time interval. The unit

beeps 1, 2, 3, or 4 times for scan time

of 3, 8, 15, or 30 seconds, respectively.



Autoscan buttons

Press buttons 3 and 4 together to start

Autoscan.



Port LEDs

LEDs light when the connected

computer is selected.



Power LED

Lights when power is on.



Function button

Adjusts video signal strength or selects

audio signal. See Section 4.4.

Table of contents

Other Black Box Switch manuals

Black Box

Black Box ServSwitch Secure Plus (with USB) User manual

Black Box

Black Box ServSwitch Wiring diagram

Black Box

Black Box SERVSWITCH KV3108SA-R4 User manual

Black Box

Black Box KV9304A User manual

Black Box

Black Box RS-422 User manual

Black Box

Black Box SS4P-SH-DP-U User manual

Black Box

Black Box Switch User manual

Black Box

Black Box ServSelect KV124A-PS2 User manual

Black Box

Black Box ServSelect IP VM KV2116A Installation and maintenance instructions

Black Box

Black Box KV130A User manual

Black Box

Black Box LB8508A User manual

Black Box

Black Box LGB1110A User manual

Black Box

Black Box LPB2910A User manual

Black Box

Black Box IC445A User manual

Black Box

Black Box EMS100G-32 Manual

Black Box

Black Box AC506A User manual

Black Box

Black Box SW1000A User manual

Black Box

Black Box ACU5051A User manual

Black Box

Black Box LPH3100A User manual

Black Box

Black Box ACX048-R2 User manual

Black Box

Black Box LGB2003A-R2 User manual

Black Box

Black Box AC815A User manual

Black Box

Black Box LB9017A-R2 User manual

Black Box

Black Box ServSwitch SW625A-R2 User manual

Popular Switch manuals by other brands

URC

URC Total Control MFS-8 installation manual

Azbil

Azbil HPQ-D11 user manual

Sony

Sony DFS-900M operating instructions

SICK

SICK i17S operating instructions

F&F

F&F SZR-277 quick start guide

Shure

Shure UAMS/BK user guide

Dräger

Dräger X-zone Switch Off Instructions for use

Asco

Asco Joucomatic 349 Series manual

BT Mini Hub user guide

D-Link

D-Link DES-1226G manual

Johnson Controls

Johnson Controls FS80-C installation instructions

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Configuration guide

MicroNet

MicroNet SP1200A user manual

Ruijie

Ruijie RG-PF2920 Series Hardware installation and reference guide

Altinex

Altinex DA1914SX user guide

MiLAN

MiLAN MIL-SM2401M user guide

RJM

RJM MASTERMIND PBC/6X user manual

Atlas

Atlas MMK-KVM8 owner's manual