Spectrum 230 by BATHOLOGY
4
Operation
On/Off light button. The first press will
turn the light on, starting at 100%. The red
indicator light just above the button will
light up, indicating the power is on. The
second press will turn the light and its red
indicator light off.
Increase light button. Press or hold to
increase brightness of light up to a
maximum of 100% brightness. Red
indicator light to its right will light up while
pressed.
Decrease light button. Press or hold to
decrease brightness of light down to a
minimum of 50% brightness. Red indicator
light to its left will light up while pressed.
Product Care
For routine cleaning, simply use a soft damp cloth
and common household soap. Use a damp cloth
to wipe clean, then dry. Clean product frequently to
avoid calcium deposits on surfaces. Use only mild
soap. Never use abrasive cleaners, bleach,
disinfectants or cleaning products containing
alcohol, ammonia, hydrochloric or phosphoric
acids as they may damage the product’s finish. To
clean electrical components, gently wipe down
using a dry cloth or duster. Never use a wet duster,
water, or any other liquid to clean the device.
Replacement Parts
Description
Soft-Touch light switch, polished chrome
Soft-Touch light switch, brushed nickel
Power supply module
25’ Soft-Touch switch cable
NEMA male plug
Strain relief bushing
Part Number
Spectrum034
Spectrum037
Spectrum035
Spectrum036
Spectrum038
Spectrum039
Contact your Bathology representative for Spectrum
230 In-Shower Light Switch replacement parts.
Installation (continued)
Make a 1-1/2” diameter hole at the desired
Soft-Touch light switch location.
Route the 25’ Soft-Touch switch cable from the
Soft-Touch switch to the 6‘ power supply
module switch tether.
With a clean and dry mounting surface, remove
the peel-off paper from the back of the
Soft-Touch light switch (see figure 3). For wet
environments, run a thin bead of silicone
completely around the mounting flange. Press
the Soft-Touch light switch against the wall until
the adhesive sticks.
Plug in the NEMA male plug into 4’ female
power supply module cord.
Plug in the 4’ male power supply module cord
into the grounded 120VAC light circuit outlet A.
Allow silicone to cure for 24 hours before
exposing Soft-Touch light switch to any source
of moisture.
6.
7.
8.
9.
10.
11.
900-0113-1012
BATHOLOGY
rediscover bathing
A division of Bathing Brands, Inc.
www.Bathology.com 847-465-1070
Peel-Off Paper
Mounting Flange
Figure 3
