160.480UK User Manual
Introduction
Thank you for purchasing the UMBRA-1200 mist machine. This unit can produce a low mist
“dry ice” effect for stage productions and themed events. Please read and keep this manual in
order to achieve the best results from this equipment and avoid damage through misuse.
Unpacking
The UMBRA-1200 is self-contained in its own flight case with lockable castors for stability.
Inside, the main unit is seated on the base with the flexible duct and outlet funnel attached
and the fluid tank is installed into the main unit. An IEC mains lead and 5-pin remote control
lead are also provided. If you find any accessory is missing or the machine has arrived
with any problems, please contact your local dealer at once.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on areas other than inside the fluid tank, disconnect the mains, allow the
UMBRA-1200 to dry out and have it checked by qualified personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
Avoid blocking or crushing the flexible duct, as this could lead to damage during use.
D not open the case other than the water reservoir and remote control cavity.
No user serviceable parts inside. Refer any repair or service to qualified personnel.
Allow the UMBRA-1200 to acclimatize to room temperature before operating.
Placement
The UMBRA-1200 has a built-in fluid container which can be removed for filling.
When in place, ensure that the cap is securely sealed and the bottle is not inverted.
The UMBRA-1200 also has a water reservoir, which should be filled to the required level.
The unit in its flight case should be positioned on a stable surface.
Remove the lid completely before operating.
Safety
•Check for correct mains voltage and condition of IEC lead before connecting to mains
•This unit must be earthed
•This unit uses a heating element –be aware that parts of the housing may be hot in use!
Cleaning
•Use a soft dry or slightly damp to clean the casing
•Do not use strong solvents for cleaning the housing or case
•Clean the haze mechanism periodically by operating with distilled water instead of haze
•It is also recommended to use fog machine cleaning fluid (160.670UK) periodically to
clean out the fog mechanism
