EN 8
C - CONFIGURATION
1 - QUICK START-UP
These steps must be followed in the order
described.
Insert 2 x AA LR06 batteries (not supplied) into the
station 15. Then insert the 2 x AAA LR03 batteries
(not supplied) into the outdoor sensor, ensuring
that the polarity is respected 16.
PAIRING THE SENSOR TO THE STATION
Pairing is automatic once the batteries are
inserted. To force pairing, if required:
- On the station, press and hold the
DOWN button for 5 seconds. The indicator
starts to flash
- On the outdoor sensor, remove then reinsert the
batteries whilst standing close to the weather
station
TIME AND DATE SETTING
- Hold the SET button until the “°C” flashes.
- Set the measurement unit choice using the +
and - buttons (°C = Celsius or °F = Fahrenheit).
Confirm using the SET button.
- 24h or 12h flashes on the display, set the
time display format using the + and - buttons.
Confirm using the SET button.
- Both digits: 00 flash on the display. Set the
time zone using the UP and DOWN buttons.
Confirm using the SET button.
- Then set the hour using the + and - buttons.
Confirm using the SET button.
- Set the minutes using the + and - buttons.
Finally confirm using the SET button.
ALARM SETTING
- Press the SET button once: AL appears next to
the time.
- Press and hold the SET button for 3 seconds:
The hour of the alarm flashes on the display.
Set the hour of the alarm using the + and -
buttons
- Press the SET button to confirm. The minutes
flash on the display.
- Set the minutes of the alarm using the + and -
buttons
- Press the SET button to confirm. Zz 05 flashes
on the display.
- Set the alarm snooze duration using the + and -
buttons
- Complete the setting by pressing briefly on the
SET button
When the alarm clock rings, you can press
the Snooze/Light button to stop or pause the
alarm by the previously set time (Zz). To activate
the alarm, press the + button once, a bell icon
(3) will appear between the hour and the
minutes
To deactivate the alarm, press the + button
once. The bell (3) disappears.
The ring lasts for a maximum of 2 minutes.
AUTOMATIC TIME SETTING
To launch the automatic time setting for the
station, press and hold the + button until the
LED flashes (4). The station switches to radio
reception (for 7 minutes) and attempts to pick up
the DCF77 time signal to automatically update the
time and date.
Note: the time zone must be set correctly for a
correct display. If reception is insufficient, bring
the station near to a window.
Ensure that you leave a gap of 2.5 m between the
station and any source of interference (television,
router, microwave, etc.)
The signal search can be cut off at any point by
pressing the + button, if the signal is not available.
MIN - MAX VALUE DISPLAY
- Briefly pressing on MEM displays the maximum
measured values; pressing MEM again displays
the minimum measured values; a third press on
MEM returns you to the display of the current
values. Press and hold for 3 seconds the MEM
button to erase the saved MIN/MAX values
WIRELESS WEATHER STATION
