Aqua-Marina BLUEDRIVE S PF-240S User manual
User’s Guide
WARNING
For your own safety and that of your equipment, make sure to take the following precautions. Failure to follow
warning notices and instruction may result in property damage, serious injury or death. Please keep the manual and
read it carefully before using the product; If the manual is lost, please contact our after-sale service center.
PF-240S
BLUEDRIVE S POWER FIN
EN
2
TABLE OF CONTENTS
I. SAFETY WARNING
II. MAIN COMPONENTS, PARAMETERS AND OVERALL DIMENSIONS
III. PACKING LIST
IV. INSTALLATION AND INSTRUCTION
V. MAINTENANCE
VI. GUIDANCE ON PROBLEMS
VII. WARRANTY AND AFTER SERVICE CONTACT INFORMATION
3
Application scope of the product: Any types of SUP boards, kayaks or canoes with
slide-in fin base. The electric power fin only provides the power in one-way
direction, changing directions requires paddlers’ operation.
SAFETY WARNING
1. This product is only for providing power for water leisure products and only limited to be
used in water. It is forbidden to use it for other purposes.
2. When using the product, it is necessary to consider the use precautions of floating products,
and the rules of the local waters and the use attention points.
3. When using the product, it is necessary to consider that the depth of the water is enough to
float the devices of the power fin, so that it will not be damaged.
4. When using the product, it is required for each passenger to take with the lifejacket
approved by CGA (coast guard approved) or similar PFD device and oars.
5. When using the product, a proper emergency stop leash should be tied with user's ankle.
6. Do not use this power fin in the fast flowing rivers, strong currents, or sudden storm or tide.
7. Do not use the product after taking pills or alcohol.
8. This appliance can be used by children aged from 8 years and above and persons with
reduced physical sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without supervision.
9. This product can not be used by children under 8 years old; and children should be in
supervision to make sure they do not play with it.
10. Do not modify the product or add other parts to it in any way. If any parts is damaged, please
contact after-sale service center.
11. If there is seaweed or fishing line wrapped on the propeller, or it is trapped in the mud,
please turn off the power immediately and clear it up.
12. If touch any stones or obstacles in the water in using process, turn direction timely to avoid
falling into the water.
13. Wash the power fin and its motor with fresh water; and do not put it in sea water or salt water
to avoid damage to the motor.
14. This product is with li-ion batteries, always follow the batteries use principle and matters
needing attention.
15. The battery must be removed from the appliance before it is scrapped.
16. The appliance must be disconnected from the supply mains before removing the battery.
17. The battery must be disposed properly according to local regulations.
18. Never charge or use the product in thunderstorms and lightning conditions.
19. It is necessary to check whether each connection is firm before each use.
20. Check whether its electricity is enough before each use.
21. The power fin only be supplied at SELV(Safety Extra Low Voltage), can be applied only with
specified batteries, specified chargers and remote control. If user needs to replace them,
please contact the appointed after-sale service center.
4
22. The electric charging port of the control box should be either connected with the power fin, or
connected with charger, or cover its lid to avoid short circuit damage caused by other metals
or moisture.
23. When the remote control and the charger are not used for a long time, it is necessary to
disconnect power supply.
24. When it is not in use, it should be stored under the temperature of -15°~45° and avoid direct
sunlight.
25. If the power fin is scrapped or need to be replaced with new one, it is necessary to follow the
principle of recycling or return it to the dealer.
26. This is class III appliance，it must only be supplied at safety extra low voltage.
27. The appliance can be only used with specified chargers from the original manufacturer.
The major components include:
Control box
Cable
Bungee rope set SUP board
(* Optional)
Underwater jet
Wireless remote control
5
POWER FIN PRODUCT DETAIL:
Metal connector
Motor
propeller
Motor
Motor protective
cover
Motor protective
cover
* BLUEDRIVE S Power Fin is compatible with all AM iSUP boards and kayaks with
slide-in fin box.
Guide vane
* With a US Fin adaptor (optional), the power fin can be also used on any watercrafts with a US
FIN box.
6
PARAMETERS
Underwater Jet
Control Box
Charger
Operating Speed: 4-6km/h
• Low gear : Max. Speed 4km/h
• High gear : Max. Speed 6km/h
Runtime: 1h for low gear, 0.5h for high gear
Protective Cover Material: ABS
Dimension: 300 x 210 x 110mm (11.8” x 8.3” x 4.3”)
Weight: 2.5kg (5.5lbs)
Rechargeable Battery Pack: 11.1VDC, 8.8Ah/97.68Wh
Special lithium-ion battery for BlueDrive S Power Fin
Material: IP67, flame retardant ABS
Battery Life: ≥300 cycles
Dimension: 210 x 155 x 75mm (8.3” x 6.1” x 3”)
Net Weight: 1.25kg (2.8lbs)
With rechargeable battery, circuit board and
2-in-1 magnetic switch (working as both power
switch and emergency stop switch)
Input: 230V / 50Hz
Output: DC12.6V 5A
Full charging time for battery pack is 2~3 hours
Packing Dimension 62 x 29.5 x 18.5cm (24.4'' x 11.6'' x 7.3'')
Remote Control
Packing weight /
Net weight:
5.9 kg (13 lbs) /
4.25 kg (9.4 lbs)
Interface Metal interface of IP67 marine waterproof for plug in
Operation Frequency Range: 2400~2483.5 MHz
Radio Frequency Transmitting Power: 36 mW
Max Output Power: 6.18 dBm (E.I.R.P）
Motor Power: 12V DC, 240W
7
OVERALL DIMENSIONS:
210mm
300mm
Overall dimension chart of power fin, 300 x 210x 110mm (11.8" x 8.3" x 4.3")
Overall dimension chart of the control box,
210 x 155 x 75mm (8.3" x 6.1" x 3")
Overall dimension chart of the handbag,
610 x 282 x 175mm (24" x 11.1" x 6.9")
155mm
282mm
210mm 610mm 175mm
110mm
Emergency Stop Leash
must be worn when
using this product.
Oriental Recreational Products (Shanghai) Co., Ltd.
aquamarina.com MADE IN CHINA
ORPC S.A.S. 17 avenue George V 75008 Paris - France
BlueDrive S Power Fin
Control Box (LBP-12V6S)
Nominal Capacity：
97.68Wh • Do not dispose in fire.
• Do not disassemble.
• Use specified chargers only.
• Store it below 60°C and
avoid short-circuit.
BlueDrive S Power Fin
PF-240S DC12V, 240W, IP67
To reduce the risk of
injury, user must read
and understand
instruction’s manual
before using this
product. Do not open
control box when in
use.
8
PACKING LIST
No. Name of component
part Picture Quantity/
Unit Remark
Underwater Jet With power cord, plug,
fin base and push-in pin
1 1 Set
Control Box ( Include
Li-ion battery pack)
2 1 Set
Elastic rope buckle3 1 Set
Remote Control4 1 Set
Charger5 1 Set
Manual European standard6 1 Copy
With rechargeable
battery, circuit board
and 2-in-1 magnetic
switch (working as
both power switch and
emergency stop
switch)
Black elastic rope of
88cm in length with
carabiner
With arm band, remote
control and battery
(CR 2025/CR 2032 3V)
Picture shown: Europe
standard (*The actual
charging plug may
vary with different
regional standards.)
9
INSTALLATION AND INSTRUCTION
1. Open the packing box and check whether the components are complete
2. Install power fin into ISUP (as shown in the picture)
2.1 Insert the bottom of power fin into the fin base of ISUP;
2.2 Insert the slide in push-in pin into the fin base;
* With a US Fin adaptor, the power fin can be also used on any watercrafts with a US FIN
box.
2.1
a b c
d e
2.2
Insert push-in pin
Insert push-in pin
3. Install the control box
Firstly check whether the control box is with electricity (please refer to the manual of
Magnetic Switch for details). If it is without or lack of electricity, please charge the control box
in following steps (as shown in following pictures).
Plug in
four core
10
a. Insert the power cord of the charger into the corresponding hole position on the charger to
charge the control box.
b. Screw off the metal nut on the back of the control box counterclockwise;
c. Connect the metal plug on the charger to the corresponding connector on the control box
(Please note the direction of convex and concave corresponding position) and tighten the nut;
d. Plug the power plug of the charger into the home power supply.
e. Snap the magnetic switch in the right position of the control box. And the indicator light on the
charger will turn red when it is charging successfully. Please note: the control box can NOT
be charged when it is not connected with the magnetic switch.
f. The indicator light on the charger will turn solid green when the control box is fully charged.
After charging, remove the power plug and charger and keep them properly for next
charging.
3.1 Put the control box on the ISUP with the
direction of metal plug towards the stern
of ISUP;
3.2 Fix the battery by fastening the elastic ropes
across the bottom of board respectively
and hook them on the 4 corners of control box. Metal plug towards the stern of ISUP
4. The connection between the power fin and the control box: screw off the nut lid of the metal
plug on the control box, and insert the metal plug in the end of power line of the power fin
into the corresponding metal socket hole of the control box with correct direction and proper
inserting; and tighten the metal nut.
Table of contents
Other Aqua-Marina Engine manuals
