Advent 128-8567 User manual

OPERATION

MANUAL

ADV10

10.1" OVERHEAD LCD

MONITOR WITH

DVD PLAYER

128-8567C

Important Notice

Installation of overhead products requires careful planning and preparation. Be extremely careful when working on a vehicle with side

curtain air bags. Do not route wires near any portion of the side curtain air bag assemblies. This includes any anchor points in A, B, C or

D pillars of the vehicle. Routing wires in these areas or running wires by the side curtain air bags can prevent the side curtain air bag from

fully deploying which can result in personal injury to vehicle occupants. If you have any questions regarding wire routing in a vehicle,

please contact Audiovox Technical Support at 1-800-225-6074.

When connecting power and ground in a mobile video installation ensure that the ACC wire is fused at the point where it is connected to

the vehicle ACC wiring. Failure to do so can result in damage to the vehicle if a short circuit develops between the vehicle connection

point and the mobile video product.

An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used

for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television

reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is

in “park” or when the vehicle's parking brake is applied.

An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the

parking brake is not applied must be installed to the rear of the driver's seat where it will not be visible, directly or indirectly, to the operator

of the motor vehicle.

Warnings

•

Do not use any solvents or cleaning materials when cleaning the video monitor.

Do not use any abrasive cleaners, they may scratch the screen.

Use only a lightly dampened lint free cloth to wipe the screen if it is dirty.

Lock the LCD screen in the fully closed position when not in use.

Before putting on headphones always adjust the volume setting to the lowest position.

Remember to leave the dome light switch in the off or auto positions when the vehicle is unattended, as the dome lights, if left on, can drain

the vehicle's battery.

Do not put pressure on the screen.

Caution children to avoid touching or scratching the screen, as it may become dirty or damaged.

Licensed under one or more of the following patents,

Patent NOS. 5,775,762 , 5,927,784 and 6,678,892

FEATURES

Congratulations

Safety Precaution

Congratulations on your purchase of the ADVENT ADV10

DVD Player with drop-down video / monitor. The ADV10 has

been designed to give you and your family many years of

video entertainment in the mobile environment. Please read

the directions that follow to familiarize yourself with the

product to ensure that you obtain the best results from your

equipment.

For safety reasons, when changing video media it is

recommended that the vehicle is not in motion, and that you

do not allow children to unfasten seat-belts to change video

media or make any adjustments to the system. System

adjustments can be accomplished using the remote control,

while seat-belts remain fastened. Enjoy your ADVENT

entertainment system but remember the safety of all

passengers remains the number one priority.

Note: Installation options vary, see the individual owner's

manuals for each component in your system to obtain a full

understanding of each component's operation.

• 10.1” TFT (Thin Film Transistor) Active Matrix LCD

(Liquid Crystal Display) Monitor

• DVD Player

• OSD (On Screen Display) for Control of Picture Quality

and Functions

•

• Audio / Video Source Inputs (DVD, AV1/AUX)

• Dome lights with built-in three way switch

•

•ds

Built-in

Two

Built-in 16 Channel Wireless FM Modulator

Last Position Memory for DVD

Playing DVD, CD and MP3 isc

Infrared Transmitter for IR wireless headphones

AV output via RCA Jacks

Screen Mode selection (4:3, 16:9)

Full Function Remote Control

Backlit Controls

CONTROLS AND INDICATORS DIAGRAM (FRONT VIEW)

4. STOP ( ) Control

5. EJECT ( ) Control

6. Three Position Dome Light Switch

OFF

AUTO

7. Dome Lights

8. Ventilation Openings

9. LCD Cut Off Switch

10. LCD Panel

11. Screen Release

- Press STOP once : Stops playback,

Pressing the PLAY button again will resume normal

playback from where movie was stopped.

- Press STOP twice and then press PLAY to start playback

from the beginning of the DVD.

This control is used for ejecting disc from the disc

compartment.

- Turns on the dome lights.

- The dome lights will not turn on in this position.

- Automatically switches on the dome lights in

conjunction with the vehicle's interior illumination.

Provide additional interior illumination.

Used to turn off the LCD backlight when the LCD is in the

closed position.

Press to release the screen.



1. POWER ( ) Control

2. Source Select (S)

3. PLAY ( ) Control

Used to turn the system on/off (standby).

Use to select one of the two sources: DVD,AV1/AUX

This control is used to start playback of a disc.

CONTROL FUNCTION DESCRIPTION SIDE VIEW()

1. DVD Disc insertion Slot

For loading and removing discs.

123

CONTROL FUNCTION DESCRIPTION BACK VIEW()

1. Auxiliary Video Input

2. Auxiliary Audio Left Input

3. Auxiliary Audio Right Input

MAIN FUNCTION OPERATION

M1 M2

POWER EJECT

TV DVD

SOURCE

MUTE

DVD SOURCE VOLUME

PIX

SYSTEM MENU DISC MENU ZOOM

REPEAT

ENTER

SUBTITLESETUPDISPLAY

AUDIO

1234

5678

IRT

ON/OFF

FMM

ON/OFF

16 17

CR2025

REMOTE CONTROL OPERATION

Initial Use

When purchased the remote control has a battery installed with a

Pull Tab to prevent battery discharge. Remove the Pull Tab before

attempting to use the remote.

Battery Replacement

1. Remove the battery holder.

2. Insert the battery into the battery holder and insert the battery

holder into the remote. Be sure to observe the correct polarity.

3. Align the battery holder with the remote control and push it in

until the holder clicks.

1. POWER*

2. MONITOR SELECT

M1 Button –

M2 Button** –

3. SOURCE*

4. TV Mode Select

5. DVD Source

6. PIX ( Picture Select )

7. SYSTEM MENU

8. CURSOR ( )

Function control is available on the unit and the Remote Control.

Function not available in this model.

Press this button to turn the unit ON and OFF.

Set the remote control code to allow control of the unit in M1 mode.

Set the remote control code to allow control of the unit in M2 mode.

Each time the button is pressed, the unit will cycle through modes DVD, AV1/AUX

Switches certain function keys on the remote control for monitor functions.

This button is only active when remote control is in DVD mode.

Each time of this button is pressed, the OSD picture adjustment displays the “Adjustment bar” for BRIGHTNESS, CONTRAST,

COLOR, TINT(For NTSC only) or RESET. Once the desired adjustment bar is displayed, use the VOLUME+/ –VOLUME– button to

adjust the setting. The display will automatically turn off if no adjustments are made within 6 seconds.

Allow the user to access the system menu when the unit has been placed in TV mode ( See Item number 4 ). Press cursor ( ) buttons to select

desired picture control FMM screen mode, OSD language and source default during power up.

Use these buttons to access menu selections on the screen.

pqtu

9. ENTER

10. DISPLAY

11. SCAN BACKWARD ( )

12. PLAY*

13. PREVIOUS ( )

14. PAUSE ( )

15. NUMBERS

16. FMM ON/OFF

17. IRT ON/OFF (Optional)

18. NEXT ( )

Used to implement a selected setting or menu option.

Press to display the current disc information while the disc is playing. Press the cursor ( ) buttons to select the Title or Chapter. For

Title/Chapter selection use the numeric buttons to enter the desired Title /Chapter selection.

Press to search in a backward direction. Press repeatedly to change the search speed from 2, 4, 8, 16 times and normal speed.

Press to activate the play mode while a disc is loaded into the disc compartment.

Press to return to the previous chapter or track.

Press to pause playback.

Allow the user to ENTER the numbers 0-9 for selection of the tracks, titles chapters or password setting.

Turns the FM Modulator power on/off.

Turns the Infrared Transmitter on or off for IR wireless headphones.

Press to skip to the next chapter or track.

19. STOP ( )*

20. SCAN FORWARD ( )

21. AUDIO

22. SETUP

23. SUBTITLE

24. REPEAT

25. DISC MENU

Press to stop playback.(Playback will resume from the point it is stopped).

Press twice at once to stop playback fully. (Playback will resume from the beginning of the disc).

Press to search in a forward direction. Press repeatedly to change the search speed from 2, 4, 8, 16 times and normal speed.

Press to display and select audio language in DVD mode. Each time you press the button, the language changes.

Press to display the Setup menu which allows the user to change the DVD player options such as LANGUAGE, VIDEO, RATING &

MISC.

Press to display and select the subtitle language in DVD mode. Each time you press the button, the subtitle language changes.

Allows the user to repeat a selected title, chapter, or track.

Allow the user to access the disc’s menu mode.

Note:

Note

Note:

The available languages vary from disc to disc.

: The unit must be set to DVD mode by pressing the DVD button prior to pressing the SETUP button.

The type and number of languages for subtitle vary from disc to disc.

26. ZOOM

27. VOLUME DOWN (-) or UP (+)

28. DVD Mode Select Button

29. MUTE

30. EJECT ( )*

Press this button to enlarge the picture when playing a DVD disc.

Once Q1- Enlarge the picture 2 times of the original size

Second Q2- Enlarge the picture 3 times of the original size

Third Q3- Enlarge the picture 4 times of the original size

Forth Q off- Picture is returned to original size

Press to decrease or increase the level of the picture adjustments after the picture select button (PIX) is pressed.

Switches certain function keys on the remote control for DVD function.

Press this button to mute the audio for wireless FMM, IR headphones and wired headphones.

Pressing the button again restores the audio to the previously set level.

This button is used to eject the disc.

Press ZOOM button DVD player perform



This manual suits for next models

Table of contents

Advent 128-8567 User manual

Popular Car Video System manuals by other brands