Yamaha NS-C60 User manual

Table of contents

Other Yamaha Speakers System manuals

Popular Speakers System manuals by other brands

JVC

JVC CA-MXK5R instructions

LG

LG NB4532B owner's manual

JVC

JVC CA-FSH100 instructions

5Core

5Core Pro Series Operation manual

EAW

EAW MQV1394e Specifications

Lynx

Lynx GXR-LA10A user manual

iLive

iLive ITB066B user guide

RDX

RDX QuickStation 4 product manual

Electro-Voice

Electro-Voice S-122 Specifications

Sven

Sven SPS-619 GOLD Operation manual

Pioneer

Pioneer CS-7070 instruction manual

EAW

EAW UB82e Technical specifications

Sondpex

Sondpex Active Speaker System and Digital Music... User manual and installation instructions

JVC

JVC NX-PN7 instructions

Marshall Amplification

Marshall Amplification AR-DM61-BT user manual

SE Audiotechnik

SE Audiotechnik I-LINE manual

Gemini

Gemini WRX-843 Series user manual

TCL

TCL 6100 Series user manual

Thank you for selecting this Yamaha NS-C60 speaker system.

This model is designed mainly to be used as a center speaker system.

NS-C60 Natural Sound

Center Speaker System

Note

Though this speaker is a magnetic shielding type,

there may be an influence on TV picture accord-

ing to the type of TV or the placement of the

speaker. In such a case, place the speaker apart

from the TV so that there is no influence on TV

picture.

PRECAUTIONS

Read these precautions carefully before operating

your speaker.

●When using an amplifier with a rated output power

higher than the music input of the speaker, care

should be taken never to exceed the speaker’s

music input.

●Do not attempt to clean the speaker with chemical

solvents as this might damage the finish. To clean,

wipe with a dry, soft cloth.

●To prevent the enclosure from warping or discolor-

ing, do not place the speaker where it will be

exposed to direct sunlight or excessive humidity.

●Do not place the speaker where it is liable to be

knocked over or struck by falling objects. Stable

placement will also ensure better sound perfor-

mance.

●Placing the speaker on the same shelf or rack as

the turntable can result in feedback.

●Anytime you note distortion, reduce the volume con-

trol on your amplifier to a lower setting. Never allow

your amplifier to be driven into “clipping”.

●Secure placing is the owner’s responsibility.

YAMAHA shall not be liable to any accident

caused by an improper placing of the speaker.

PLACING THE SPEAKER

Slip-prevention pad

Place the speaker on top of the TV or on the floor

under the TV or inside the TV rack so that it is stabi-

lized.

When placing the speaker on top of the TV, to pre-

vent the speaker from falling down, put the provided

slip-prevention pads at four positions on the bottom of

the speaker where the speaker touches the surface of

the TV.

TV set

Note

Do not let the bare speaker wires touch each other

as this could damage the speaker and/or

the amplifier.

CONNECTION TO

YOUR AMPLIFIER

BEFORE MAKING CONNECTIONS, MAKE SURE

THAT THE AMPLIFIER IS SWITCHED OFF.

■CONNECTIONS

●Connect the push-type input terminals at the rear of

the speaker to the speaker output terminals of your

amplifier with the provided speaker cables.

●One side of the speaker cable is marked by a white

line. Connect the (+) terminals on both the amplifier

and the speakers using this white-marked side.

Connect the (–) terminals on both components

using the unmarked side of the cable. If connected

with reversed polarity, the sound will be unnatural

and lack bass.

Procedures:

➀Press the tab on the terminal down, as shown in

the figure.

➁Insert the bare wire end properly into the terminal

hole. [Remove approx. 5 mm (1/4”) insulation from

the speaker cable.]

➂Remove your finger from the tab to allow it to lock

snugly on the cable’s wire end.

➃Test the security of the connection by tugging

lightly on the cable at the terminal.

SPECIFICATIONS

Type ......................2 way bass-reflex speaker system

Magnetic-shielding type (EIAJ)

Speaker Unit..............8 cm cone woofer (JA0858) x 2

Tweeter (JA05S0) x 1

Input Terminal .............................................Push-type

Nominal Impedance.........................................6 ohms

Frequency Response...........60 Hz – 20 kHz (–10 dB)

Nominal Input Power............................................40W

Music Input Power................................................80W

Sensitivity ...................................................88 dB/w/m

Dimensions (WxHxD)..................435 x 100 x 221 mm

(17-1/8” x 4” x 8-11/16”)

Weight.........................................2.2 kg (4 lbs. 13 oz.)

Accessories............................Speaker cable (4m) x 1

Slip-prevention pad x 4

* Specifications subject to change without notice due

to product improvements.

* Care should be taken not to exceed the input power

values noted above.

Press tab

Center speaker

output terminals

of the amplifier

White line

White line

White line

NS-C60