Xyron 4400 User manual
4400
step by step guide to
loading lamination material
For more information see the users manual,
or visit xyronpro.com, select "support", then
selct 4400 from the drop down menu.
Remove media supporter
before loading laminate rolls.
1.
match
colored
dots
Match bottom and top roll with
the yellow and green dots on
machine. On each one of the
ends it will tell you top roll or
bottom roll.
2.
rollers
supply
role
underlay
film
teflon
bars
rollers
supply
role
underlay
film
Teflon
bars
Take the ends of the top roll,
weave it under the Teflon bar,
pull the sheet toward you,
grabbing all the way on each
end. Make sure you pull out
enough so it hangs just
below the bottom roller.
3.
rollers
supply
role
underlay
film
Take the ends of the bottom
roll weave it under the Teflon
bar pull the sheet toward you,
grabbing all the way on each
end. This time, pull out
enough to stick firmly to the
material from the top bar
4.
Using the foot pedal (direction,
FORWARD; feed' FOOT; speed
control, 3) start feeding it
through so you can see about
3” coming out between rubber
rollers in the back.
5.
load plate
load plate
To remove the wrinkles
from the material, press the
foot pedal and use the load
plate, or a scrap piece of
cardboard and feed it
through the machine until
the wrinkles disappear.
6.
Replace the media support tray and you are now
ready to begin use of the XYRON 4400.
For more information see the users manual, or visit
xyronpro.com, select "support", then selct 4400
from the drop down menu.
7.
Other Xyron Laminator manuals
Xyron
Xyron PRO 1255 XM1255 User manual
Xyron
Xyron ezLaminator User manual
Xyron
Xyron ezLaminator User manual
Xyron
Xyron XRN510ATP User manual
Xyron
Xyron Creative Station User manual
Xyron
Xyron PRO 1250 User manual
Xyron
Xyron 2500 User manual
Xyron
Xyron Creative Station Home User manual
Xyron
Xyron Xyron ezLaminator User manual
Xyron
Xyron XM2500 User manual
