Worx WG168E User manual
WG168E WG168E.9
P06
P17
P29
P40
P52
Cordless Lawn Trimmer / Lawn Edge Trimmer
Akku-Græstrimmer / Græskanttrimmer
Johdoton Ruohotrimmeri / Ruohon Reunatrimmeri
Trådløs Gressklipper / Kantklipper
Sladdlös Gräsmattetrimmer / Kanttrimmer Gräsmatta
EN
DK
FIN
NOR
SV
Original instructions EN
Original brugsanvisning DK
Alkuperäiset ohjeet FIN
Original driftsinstruks NOR
Bruksanvisning i original SV
1
9
2
3
5
4
6
10
7
8
7
8
RIGHT WRONG
16
11
12
13
14
15
A1 A2 B1
B2 C1 C2
C3 D1 D2
E F G
H1 H2 H3
H4 I1 I2
J K1 K2
K3 K4
7
8
RIGHT WRONG
16
11
12
13
14
15
A1 A2 B1
B2 C1 C2
C3 D1 D2
E F G
H1 H2 H3
H4 I1 I2
J K1 K2
K3 K4
6
Cordless Lawn Trimmer/Lawn Edge Trimmer
EN
1. THREE SPEED SETTINGS
2. AUXILIARY HANDLE
3. AUXILIARY HANDLE LOCKING CLAMP
4. SAFETY GUARD
5. EDGE GUIDE
6. SHAFT LOCKING KNOB
7. ON/OFF SWITCH
8. LOCK OFF SWITCH
9. BATTERY PACK
10. LINE CUTTER
11. TRIMMER HEAD COVER (See Fig. I2)
12. CAP RELEASE LATCH (See Fig. I2)
13. SPOOL (See Fig. I2)
14. TRIMMER HEAD (See Fig. I2)
15. EYELET (See Fig. I2)
16. LINE FEED BUTTON (See Fig. I1)
* Not all the accessories illustrated or described are included in standard delivery.
TECHNICAL DATA
Type WG168E WG168E.9 (1-designation of machinery, representative of Cordless
grass Trimmer)
WG168E WG168E.9
Voltage 40V Max**
No load speed 8300/min
Cutting diameter 33cm
Line diameter 2.0mm
Charging time 1hr approx. /
Machine weight 3.5kg 2.7kg
** Voltage measured without workload. Initial battery voltage reaches maximum of 40 volts.
Nominal voltage is 36 volts.
7
Cordless Lawn Trimmer/Lawn Edge Trimmer
EN
WARNING:The vibration emission value during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used dependant on the
following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING:To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool
is switched off and when it is running idle but not actually doing the job.This may significantly
reduce the exposure level over the total working period.
Helping to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration accessories.
Avoid using tools in temperatures of 10oC or less.
Plan your work schedule to spread any high vibration tool use across a number of days.
ACCESSORIES
WG168E WG168E.9
Charger 1 (WA3735) /
Battery pack 1 (WA3536) /
Spool 1 (WA0200) 1 (WA0200)
We recommend that you purchase your accessories from the same store that sold you the tool.
Use good quality accessories marked with a well-known brand name. Choose the type according
to the work you intend to undertake. Refer to the accessory packaging for further details. Store
personnel can assist you and offer advice.
VIBRATION INFORMATION
Vibration emission value according to Annex D of EN 786: ah= 2.6m/s²
Uncertainty K 1.5m/s²
NOISE INFORMATION
A weighted sound pressure according to Annex E of EN 786 LpA = 82dB(A)
KpA 3.0dB(A)
A weighted sound power according to Noise Directive 2000/14/EC LwA = 96dB(A)
Wear ear protection
8
Cordless Lawn Trimmer/Lawn Edge Trimmer
EN
GENERAL POWER TOOL
SAFETY WARNINGS
WARNING: Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for
future reference.
The term “power tool” in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
1) WORK AREA SAFETY
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in
explosive atmospheres, such as in the
presence of flammable liquids, gases
or dust. Power tools create sparks which
may ignite the dust or fumes.
c) Keep children and bystanders
away while operating a power tool.
Distractions can cause you to lose control.
2) ELECTRICAL SAFETY
a) Power tool plugs must match the
outlet. Never modify the plug in any
way. Do not use any adapter plugs
with earthed (grounded) power tools.
Unmodified plugs and matching outlets
will reduce risk of electric shock.
b) Avoid body contact with earthed or
grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock
if your body is earthed or grounded.
c) Do not expose power tools to rain or
wet conditions. Water entering a power
tool will increase the risk of electric shock.
d) Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the power tool. Keep cord
away from heat, oil, sharp edges or
moving parts. Damaged or entangled
cords increase the risk of electric shock.
e) When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of
electric shock.
f) If operating a power tool in a damp
location is unavoidable, use a residual
current device (RCD) protected
supply. Use of an RCD reduces the risk of
electric shock.
3) PERSONAL SAFETY
a) Stay alert, watch what you are
doing and use common sense when
operating a power tool. Do not use
a power tool while you are tired or
under the influence of drugs, alcohol
or medication. A moment of inattention
while operating power tools may result in
serious personal injury.
b) Use personal protective equipment.
Always wear eye protection. Protective
equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing
protection used for appropriate conditions
will reduce personal injuries.
c) Prevent unintentional starting. Ensure
the switch is in the off-position before
connecting to power source and/or
battery pack, picking up or carrying
the tool. Carrying power tools with your
finger on the switch or energising power
tools that have the switch on invites
accidents.
d) Remove any adjusting key or wrench
before turning the power tool on. A
wrench or a key left attached to a rotating
part of the power tool may result in
personal injury.
e) Do not overreach. Keep proper
footing and balance at all times.This
enables better control of the power tool in
unexpected situations.
f) Dress properly. Do not wear loose
clothing or jewellery. Keep your
hair, clothing and gloves away from
moving parts. Loose clothes, jewellery or
long hair can be caught in moving parts.
g)
If devices are provided for the
connection of dust extraction and
collection facilities, ensure these are
connected and properly used. Use of dust
collection can reduce dust-related hazards.
9
Cordless Lawn Trimmer/Lawn Edge Trimmer
EN
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use
the correct power tool for your
application. The correct power tool will
do the job better and safer at the rate for
which it was designed.
b) Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
d) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tool’s operation. If damaged, have the
power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5) BATTERY TOOL USE AND CARE
a) Recharge only with the charger
specified by the manufacturer. A
charger that is suitable for one type of
battery pack may create a risk of fire when
used with another battery pack.
b) Use power tools only with specifically
designated battery packs. Use of any
other battery packs may create a risk of
injury and fire.
c) When battery pack is not in use, keep
it away from other metal objects, like
paper clips, coins, keys, nails, screws
or other small metal objects, that can
make a connection from one terminal
to another. Shorting the battery terminals
together may cause burns or a fire.
d) Under abusive conditions, liquid
may be ejected from the battery;
avoid contact. If contact accidentally
occurs, flush with water. If liquid
contacts eyes, additionally seek
medical help. Liquid ejected from the
battery may cause irritation or burns.
6) SERVICE
a) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
LAWN / EDGE TRIMMER
SAFETY WARNINGS
WARNING: When using the machine
the safety rules must be followed.
For your own safety and bystanders
please read the instructions before
using the machine. Please keep the
instructions safe for later use.
- This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
- Children should be supervised to ensure
that they do not play with the appliance.
a) Read instruction manual.
b) Keep bystanders away.
c) Wear eye protection.
d) Do not expose to moisture.
e) Never allow children or people unfamiliar
10
Cordless Lawn Trimmer/Lawn Edge Trimmer
EN
with the instructions to use the machine;
f) Stop using the machine while people,
especially children, or pets are nearby;
g) Only use the machine in daylight or good
artificial light;
h) Before using the machine and after any
impact, check for signs of wear or damage
and repair as necessary;
i) Never operate the machine with damaged
guards or without the guards in place;
j) Keep hands and feet away from the cutting
means at all times and especially when
switching on the motor;
k) Take care against injury from any device
fitted for trimming the filament line length.
After extending new cutter line always
return the machine to its normal operating
position before switching on;
l) Never fit metal cutting elements;
m) Never use replacement parts or accessories
not provided or recommended by the
manufacturer;
n) Always ensure that ventilation openings
are kept clear of debris;
o) Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
p) Be familiar with the controls and proper
use of the equipment;
SAFETY WARNINGS FOR
BATTERY PACK
a) Do not dismantle, open or shred cells
or battery pack.
b) Do not short-circuit a battery pack. Do
not store battery packs haphazardly
in a box or drawer where they may
short-circuit each other or be short-
circuited by conductive materials.
When battery pack is not in use, keep it
away from other metal objects, like paper
clips, coins, keys, nails, screws or other
small metal objects, that can make a
connection from one terminal to another.
Shorting the battery terminals together
may cause burns or a fire.
c) Do not expose battery pack to heat or
fire. Avoid storage in direct sunlight.
d) Do not subject battery pack to
mechanical shock.
e) In the event of battery leaking, do not
allow the liquid to come into contact
with the skin or eyes. If contact has
been made, wash the affected area
with copious amounts of water and
seek medical advice.
f) Seek medical advice immediately if a cell
or battery pack has been swallowed.
g) Keep battery pack clean and dry.
h) Wipe the battery pack terminals with
a clean dry cloth if they become dirty.
i) Battery pack needs to be charged
before use. Always refer to this
instruction and use the correct
charging procedure.
j) Do not maintain battery pack on
charge when not in use.
k) After extended periods of storage,
it may be necessary to charge and
discharge the battery pack several
times to obtain maximum performance.
l) Battery pack gives its best
performance when it is operated at
normal room temperature (20°C ± 5°C).
m)When disposing of battery packs,
keep battery packs of different
electrochemical systems separate
from each other.
n) Recharge only with the charger
specified by WORX. Do not use any
charger other than that specifically
provided for use with the equipment. A
charger that is suitable for one type of
battery pack may create a risk of fire when
used with another battery pack.
o) Do not use any battery pack which
is not designed for use with the
equipment.
p) Keep battery pack out of the reach of
children.
q) Retain the original product literature
for future reference.
r) Remove the battery from the
equipment when not in use.
s) Dispose of properly.
Other manuals for WG168E
5
This manual suits for next models
1
Table of contents
Languages:
Other Worx Trimmer manuals
