Wolf 24 E Series User manual
24" E Series Oven
Installation Guide
SPECIFICATIONS, INSTALLATION,
AND MORE
2 | Wolf Customer Care 800.222.7820
Contents
324" E Series Oven
4Specifications
7Installation
9Troubleshooting
Features and specifications are subject to change at any
time without notice. Visit wolfappliance.com/specs for the
most up-to-date information.
24" E Series Oven
Important Note
To ensure this product is installed and operated as safely
and eciently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION
Indicates a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING
States a hazard that may cause serious injury or
death if precautions are not followed.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.
IMPORTANT NOTE: Save these instructions for the local
electrical inspector.
wolfappliance.com | 3
Product Information
Important product information, including the model and
serial number, are listed on the product rating plate. The
rating plate is located on the left side of the front face
frame. The oven door must be open to view the rating
plate. Refer to the illustration below.
If service is necessary, contact Wolf Factory Certified
Service with the model and serial number. For the name of
the nearest Wolf Factory Certified Service or for questions
regarding the installation, visit the Product Support section
of our website, wolfappliance.com, or call Wolf Customer
Care at 800-222-7820.
24" E Series Oven
Rating plate location
RATING PLATE
4 | Wolf Customer Care 800.222.7820
Electrical Requirements
Installation must comply with all applicable electrical codes.
For ease of installation, the electrical supply for the oven
should be placed in an adjacent cabinet within reach of the
conduit.
Performance may be compromised if the electrical supply
is less than 240 volts.
The oven is supplied with a conduit consisting of two hot
lead conductors and a ground conductor. The wiring dia-
gram covering the control circuit is provided with the oven.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 240/208 VAC, 60 Hz
Service 20 amp dedicated circuit
Conduit 4' (1.2 m)
Total Amps 16
Max Connected Load 3.6 kW
Specifications
Installation Requirements
The oven can be installed in a standard or flush inset
application.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, the face trim overlaps stiles and
rails. Refer to the chart.
For flush inset installations, a minimum ⁄" (3) reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
Minimum Base Support 150 lb (68 kg)
TRIM OVERLAP
Top ⁄" (3)
Bottom 0" (0)
Sides ⁄" (22)
Rating plate location
RATING PLATE
wolfappliance.com | 5
Specifications
24" E Series Oven
STANDARD INSTALLATION
E
FRONT VIEW
SIDE VIE
W
233/8"
(594)
OPENING
HEIGHT
23" (584)
OPENING
DEPTH
TOP VIEW
221/8" (562)
OPENING WIDTH
NOTE: Location of electrical supply within opening may require additional cabinet depth.
E
E
6 | Wolf Customer Care 800.222.7820
E
233/4" (603)
FLUSH INSET WIDTH**
FRONT VIEW
SIDE VIE
W
24" (610)
FLUSH
INSET
DEPTH
7/8" (22)
233/4" (603)
FLUSH INSET
HEIGHT**
1/4" (6)
1/8" (3)
TOP VIEW
13/16" (21)
FINISHED
CLEATS*
*W
ill be visible and should be finished to match cabinetry.
**
Dimension provides minimum reveals.
NOTE: Location of electrical supply within opening may require additional cabinet depth.
E
E
24" E Series Oven
FLUSH INSET INSTALLATION
Specifications
wolfappliance.com | 7
OVEN DOOR REMOVAL
To remove, open the oven door completely. Rotate both
hinge latches forward to the open position. Close the door
to approximately 30° open, then lift up and out. Refer to
the illustrations below.
To reinstall, insert door hinges into the frame openings.
Open the oven door completely and rotate both hinge
latches back to the closed position.
Installation
Preparation
Before moving the oven, protect any finished flooring and
secure the oven door(s) closed to prevent damage.
Use an appliance dolly to move the unit near the opening.
Remove and recycle packing materials. Do not lift or carry
the oven by the door handle.
CAUTION
Do not lift the oven by the door handle. This will
damage the oven door and hinges.
CLOSED
POSITION
Oven door hinge latch
Door open 30°
8 | Wolf Customer Care 800.222.7820
Installation
Place the oven in the opening and slide back.
Locate the mounting holes on the oven side trim, two on
each side. Drill ⁄" pilot holes. Use the provided mounting
screws to secure the oven to the cabinetry. Refer to the
illustration below.
To avoid interference, a 90° door stop may be required for
any appliance or cabinet door installed next to the oven.
CAUTION
Failure to install the mounting screws may cause the
oven to tip forward during use.
MOUNTING
HOLES
Oven installation
Installation
Electrical Connection
WARNING
Verify power is disconnected from the electrical box
before proceeding.
If the electrical supply is located in the opening, the elec-
trical connection must be made prior to placing the oven
in the opening. If the electrical supply is in an adjacent
cabinet, the electrical connection can be made after plac-
ing the oven in the opening.
1 Connect the black appliance wire to the black (L1)
power supply.
2 Connect the red appliance wire to the red (L2) power
supply.
3 Connect the green appliance wire to the green/ground
wire.
wolfappliance.com | 9
Troubleshooting
IMPORTANT NOTE: If the oven does not operate properly,
follow these troubleshooting steps:
• Verify electrical power is supplied to the oven.
• Verify proper electrical connections.
• If the oven does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
oven. Wolf is not responsible for service required to
correct a faulty installation.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Troubleshooting
2 | Atención al cliente de Wolf 800.222.7820
Contenido
3Horno de la serie E de 24"
4Especificaciones
7Instalación
9Solución de problemas
Las características y especificaciones están sujetas a
cambios sin previo aviso. Visite wolfappliance.com/specs
para obtener la información más actualizada.
Horno de la serie E de 24"
Aviso importante
Para garantizar que este producto se instale y opere de
la forma más segura y eficiente posible, tome nota de los
siguientes tipos de información resaltada en este manual:
AVISO IMPORTANTE señala la información que es
especialmente importante.
PRECAUCIÓN
Indica una situación en la que se pueden sufrir
heridas leves o provocar daños al producto si no se
siguen las instrucciones.
ADVERTENCIA
Indica peligro de que se produzcan heridas graves o
incluso la muerte si no se siguen las precauciones.
AVISO IMPORTANTE: En toda esta guía, las dimensiones
entre paréntesis son milímetros, a menos que se
especifique lo contrario.
AVISO IMPORTANTE: Guarde estas instrucciones para el
inspector eléctrico local.
Other manuals for 24 E Series
1
Table of contents
Languages:
Other Wolf Oven manuals
Wolf
Wolf E Series SO30-2F/S User manual
Wolf
Wolf SO36U Instructions for use
Wolf
Wolf Drawer Microwave Oven User manual
Wolf
Wolf DO30PE/S/PH User manual
Wolf
Wolf e Series Installation and operation manual
Wolf
Wolf E Series User manual
Wolf
Wolf L Series User manual
Wolf
Wolf M Series User manual
Wolf
Wolf ICBSO30-2U/S-TH Guide
Wolf
Wolf MWD24-2U/S User manual
