Safety Precautions
•
Please read these safety instructions carefully.
•
Please keep this user’s manual for later reference.
•
Please disconnect this equipment from any AC outlet before cleaning. Do not
use liquid or spray detergents for cleaning. Use a damp cloth.
•
Do not touch the LCD panel surface with sharp or hard objects.
•
For pluggable equipment, the power outlet must be installed near
the
equipment and must be easily accessible.
•
Keep this equipment away from humidity.
•
Place this equipment on a reliable surface during installation. Dropping it or
letting it fall could cause damage.
•
The openings on the enclosure are for air convection. Protect the equipment
from overheating. DO NOT COVER THE OPENINGS.
•
Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
•
Position the power cord so that people cannot step on it. Do not place
anything over the power cord.
•
All cautions and warnings on the equipment should be noted.
•
If the equipment is not used for a long time, disconnect it from the power
source to avoid damage by transient over-voltage.
•
Never pour any liquid into an opening. This could cause fire or electrical shock.
•
Never open the equipment. For safety reasons, only qualified service personnel
should open the equipment.
•
If any of the following situations arises, get the equipment checked by service
personnel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment does not work well, or you cannot get it to work according to
the
user’s manual.
The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.
•
Do not leave this equipment in an uncontrolled environment where the storage
temperature is below -20°C (-4°F) or above 60°C (140°F). It may damage the
equipment.
•
Caution – Use recommended mounting apparatus to avoid risk of injury.
•
WARNING – Only use the connection cords which comes along with the
product, when in doubt, please contact the manufacturer.
•
Provision shall be made to provide transient protection device to be set at a
level
