WE-EF FLB141 1 LED User manual

Surge Protection

This product features built-in surge protection circuitry in compliance

with applicable standards.

For comprehensive protection of a luminaire installation against lightning

and electrical surges,it is essential to cover mains supply and data input

lines at the distribution board level,by using respective primary (Type 1)

and secondary (Type 2) surge arrestors in compliance with EN61643-11/

IEC61643-1.

Warning

Ensure that all required surge protection measures are in place and

activated prior to luminaire installation.Also,disconnect luminaires

before operating high-power devices such as, for example,electrical

arc welders.

Do not open during installation

This product is factory-sealed.

Refer to the instructions contained in this

document for details.

WE-EF LIGHTING

Installation and Maintenance

Instructions

Floodlight

FLB141 #1 LED

1

Floodlight

FLB141 #1

IP66, IK08. Class I. ta = 40°C

Weight lb

for FLB141 #1 LED 6.83

Windage area ft²

for FLB141 #1 LED 0.409

Orientation: all directions

Mounting Accessories

)ODWVXUIDFHĥWWHU

SF-FLD1 for FLB141 #1 145-9535

&ROXPQĥWWHU

CF-FLD1 for FLB141 #1 145-9536

2

Light Source

LED

Maintenance

Apart from cleaning the product’s exterior surfaces,no special maintenance work is required.

Do not use high-pressure cleaners.

In case of component failure due to abnormal circumstances or at end of life, replacement must be carried

RXWE\DVXLWDEO\TXDOLĥHGDQGWUDLQHGSURIHVVLRQDO

Warning: Do not open luminaire while mains supply is switched on.

3

Installation

The product must be installed and maintained by a VXLWDEO\TXDOLĥHGSURIHVVLRQDOLQFRPSOLDQFHZLWKODWHVW

building/construction and/or electrical regulations and relevant legislation.

Warning:6ZLWFKRĪPDLQVHOHFWULFDOVXSSO\SULRUWRLQVWDOOLQJDQGFRQQHFWLQJWKHOXPLQDLUH

Notice:,IWKHOXPLQDLUHLVPRGLĥHGE\DQ\ERG\RWKHUWKDQWKHRULJLQDOPDQXIDFWXUHUWKHQWKHZDUUDQW\ZLOO

no longer be valid and shall become the full responsibility of the modifying person/organisation.

Claims based on defects attributable to improper installation and/or application, and the consequences

thereof, are excluded.

The installation on site must comply with local and/or national health and safety regulations.

4

 6ZLWFKRĪPDLQVHOHFWULFDOVXSSO\

Installation Procedure

,QVWDOODWLRQŅ)ODWVXUIDFHĥWWHU

3) Feed cable Afrom luminaire Bthrough pivot and

 KROHRIĦDWVXUIDFHĥWWHUC.

 'HWHUPLQHSRVLWLRQVIRUĥ[LQJVFUHZVD.

Drill relevant holes Eand insert nylon plugs.

Insert and tighten screws D.

Warning: Ensure not to damage any electrical

cable, water pipe or other items drilling holes.

2) Check that rating shown on luminaire label

conforms with mains electrical supply.

(example)

FLB141-LED 120-277V / 60Hz

161-XXXX SOE XXXXXXX

LED 3000K 18W item no.XXX

07/18 IP66

5

5) Loosen screws F6OLGHVOLSĥWWHURYHUSLYRW

while pulling cable Athrough hole.

8) Loosen screw G. Aim luminaire in desired

direction and tighten screw G.

6) Turn luminaire towards object to be

LOOXPLQDWHG(QVXUHVOLSĥWWHULVSURSHUO\

seated on pivot,then tighten screws F.

7) Connect cable Awith mains supply cable.

a) ON/OFF (L = Phase,N = Neutral,

= Earthing)

b) 0-10 V (L = Phase,N = Neutral,

= Earthing,D–/D+ = 0-10 V control line).

G

6

 6ZLWFKRĪPDLQVHOHFWULFDOVXSSO\

,QVWDOODWLRQ&ROXPQĥWWHU

Suitable for column diameter Ť2.99 in.

6HUYLFHGRRURQFROXPQKDVWREHSURYLGHGIRUFDEOHWHUPLQDWLRQPD[LPXPIWIURPFROXPQĥWWHUPRXQWLQJSRVL-

tion).

3) Drill screw holes Aand cable entry hole Bon

column. Ensure cable entry hole BKDVVXĩFLHQW

diameter to feed cable from luminaire.

 6HWDQGĥ[FROXPQĥWWHUCin position.Insert

and tighten screws D.

2) Check that rating shown on luminaire label

conforms with mains electrical supply.

(example)

FLB141-LED 120-277V / 60Hz

161-XXXX SOE XXXXXXX

LED 3000K 18W item no.XXX

07/18 IP66

7

5) Loosen screws F. Feed cable Dfrom luminaire

Ethrough pivot and cable entry hole B.

Connect luminaire EZLWKFROXPQĥWWHUCby

VOLGLQJVOLSĥWWHURYHUSLYRW

8) Loosen screw G. Aim luminaire in desired

direction and tighten screw G.

6) Turn luminaire Etowards object to be

LOOXPLQDWHG(QVXUHVOLSĥWWHULVSURSHUO\

seated on pivot,then tighten screws F.

7) Connect cable Dwith mains supply cable.

a) ON/OFF (L = Phase,N = Neutral,

= Earthing)

b) 0-10 V/DALI (L = Phase,N = Neutral,

= Earthing,D–/D+ = 0-10 V control line).

www.we-ef.com

WE-EF LIGHTING

United States of America

Tel +1 724 742 0030

Fax +1 724 742 0035

[email protected]

TO9250W0522 © WE-EF 2022

Technical specifications are

subject to change.

Other manuals for FLB141 1 LED

1

Table of contents

Popular Outdoor Light manuals by other brands

Sealey

Sealey LED37 instructions

nordlux

nordlux VEJERS Mounting instruction

SImx

SImx ELITE LED LHTC637 installation instructions

GEV

GEV CAROLINE 10833 manual

NEBO

NEBO NEB-LSP-0020 Use and care guide

Lindby

Lindby 9949029 Intended use

HEPER

HEPER DOGO Side LW6048.585-US Installation & maintenance instructions

HEPER

HEPER LW8034.003-US Installation & maintenance instructions

Maretti

Maretti VIBE S 14.6080.04.A quick start guide

BEGA

BEGA 84 253 Installation and technical information

HEPER

HEPER MINIMO Installation & maintenance instructions

LIGMAN

LIGMAN BAMBOO 3 installation manual

Maretti

Maretti TUBE CUBE WALL 14.4998.04 quick start guide

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB installation instructions

urban ambiance

urban ambiance UQL1273 installation instructions

TotalPond

TotalPond 52238 instruction manual

Donner & Blitzen

Donner & Blitzen 0-02661479-2 owner's manual

LIGMAN

LIGMAN DE-20023 installation manual