2 3
- WARNING: Supervisionis advised for young children and persons
without sufficient knowledge of the workings of the water dispenser
- Do not tilt the water dispenser beyond 45˚ always keep upright
- Ensure the water dispenser is on a flat surface and placed at least
15cm from the wall.
- WARNING - Keep the water dispenser well ventilated if placed in an
enclosed area
- If the water dispenser is not in use for long periods of time, unplug
the unit from the wall socket and drain water from the unit via both
taps and the drain situated at the rear of the unit.
- Clean your water dispenser before use, if it has not been used for a
long period, discard the water from the hot & cold water taps, before
drinking.
- WARNING - Do not damage the thermostat
CAUTION: Plastic bags can be dangerous. To avoid danger of
suffocation, keep this bag away from babies and
children.
2. Characteristics
1. The Water Well water dispensers are energy efficient and emit
very little noise.
2. All the components of the water dispenser are made of high grade
materials.
3. Water Dispenser unit keeps your water below 10°C, allowing you to
a fresh glass of cold water at anytime. The Water Dispenser also
dispenses water at room temperature.
4. The water dispenser uses a unique electronic refrigerating system
to cool the water, using only 120W of power when cooling.
5. This Water Dispener is perfect for home or office and can be used with
either a Standard Water Bottle or a Filtration Bottle.
3. Installation of the Water Dispenser
1. Remove the water dispenser from its packaging.
2. Place in an upright position away from direct heat or sunlight.
3. Clean the Water Dispener by wiping down the exterior with soap and
clean water. (DO NOT get any soapy water inside the water reservoir)
3. Once you have inserted your water bottle (see sections 4 & 5) allow
the water to flow into the water dispenser.
4. Disguard the first few litres of water from both the cold and ambient
water taps to eliminate any dust and dirt which may be in the unit.
5. Once water has filled the reservoir tanks and is flowing out of both
the ambient and cold water taps in the water dispenser, allow to stand
for a few minutes then plug the water dispenser into a wall socket.
Turn on the power switch on the back of the water dispenser. The
cooling indicator and the power lights on the front of the water
dispenser will come on.
6. Allow the water dispenser to stand for a while to reach the optimum
water temperature.
4. Installation of a Filter Bottle
Bottle Support
1. Remove the Bottle Support from the water dispenser by twisting the
Bottle Support to the left and lifting out of the water dispenser.
See Images 1 -3
Image 1 Image 2 Image 3
