Watchguard WGP01487 User manual
WatchGuard Video ‐ Proprietary
WGD00080‐001Re
v
C Page 1 o
f
3
4REDVRCenterConsoleBracketInstallationManual
NOTE: There are different manufacturers of Center consoles that have different sizes and
lengths for the bracket, ensure the manufacturer type matches the type of center console
bracket used. The following brackets fit most Center Consoles
Parts included with Bracket:
Center Console Bracket
o
WGP01487 Console Faceplate Adapter, 4RE, Jotto-Troy, 2"
o
WGP01439 Console Faceplate Adapter, 4RE, Jotto-Troy, 3"
(2) – 1/4”-20 Socket Head cap Screws (WGP00787-002)
(4) – 1/2” Black Sheetmetal Screws (WGP571)
o
Optional Filler Panel
o
Optional Riser
WGP01439-001Console Faceplate Extender, 4RE, 1"
WGP01439-002Console Faceplate Extender, 4RE, 2”
WGP01439-003Console Faceplate Extender, 4RE, 3”
Parts needed from 4RE system (in separate box):
4RE DVR
Tools Required:
Philips Head # 2 Screwdriver
3/16 Allen Wrench
WatchGuard Video ‐ Proprietary
WGD00080‐001Re
v
C Page 2 o
f
3
BeforeInstallation
Before installing the bracket in the vehicle, ensure there are no missing or damaged parts from
the box. If there are any missing or damaged parts, please contact:
Customer Service at 866-384-8567
*Note: For more detailed instructions on installing the complete 4RE system, please refer the
4RE Vehicle Installation Manual.
Before installation, ensure that the system cables are routed to the center console.
MountingtheCenterConsoleBracket
Before mounting the bracket, double check that all the cables have been routed to the center
console and have enough length that the cables will not come unplugged if the 4RE DVR is
removed.
After making sure the cables lengths are correct, ensure there is enough space so the cables
are not pinched on the bottom of the center console.
Optional: If there is not enough room for the cables, use a “Riser” (different sizes
available) as pictured below. The “split” in the riser is placed to the bottom of the DVR.
Or adjust the screws after the bracket is
in place.
WatchGuard Video ‐ Proprietary
WGD00080‐001Re
v
C Page 3 o
f
3
The bracket fits snug on the 4RE DVR, so angle the bracket to catch a rear corner of the 4RE
DVR and use both hands to slide the bracket to the top of the DVR.
After the bracket is installed, fasten the Bracket to the DVR so that it will not move with (4)1/4”-
20 Allen screws using the 3/16” Allen Wrench. (Not all screws may
be used). After the Allen
screws are tightened, attach all the cables to the corresponding ports
and place the DVR into
the Center console.
Fasten the bracket to the center console with the (4) 1/2” black sheet-metal screws using the
Phillips Head #2 Screwdriver.
The bracket installation is complete.
This manual suits for next models
1
Table of contents
Other Watchguard Dashcam manuals
