Viking K-1700-IP-EWP User manual

K-1700-IP or

K-1700-IP-EWP

VoIP Entry Phone System

with Keypad

September 17, 2019

QUICK START GUIDE

VIKING

Electronics, Inc.

KSee Product Manual for complete installation and programming instructions.

1.0 Out-of-Box

1.1 Verify that you have received all of the parts listed

1.2 Download the product manual

1. Go to www.vikingelectronics.com and

enter K-1700-IP in the search box

2. Click K-1700-IP in the search results

3. Click Product Manual to open and

download the PDF

1.3 Download and install the programming software

1. Go to www.vikingelectronics.com and enter K-1700-IP in the search box

2. Click K-1700-IP in the search results

3. Scroll down the page to Downloads, click IP Programming Software

4. Install the programming software by saving or opening the file and then clicking on

setup Viking IP Programming.exe

5. Follow the prompts on your screen to complete software installation

2.0 Power Source

Select PoE Switch or PoE Injector that meets the following requirements:

1. IEEE 802.3af / 802.3at / 802.3bt compliant

2. Capable of providing at least 4 Watts (class 1)

Note: CAT5e (or higher) cable recommended

X 1 K-1700-IP or K-1700-IPEWP

VoIP Entry Phone with Keypad

X 1 Torx T-10 Security Bit

X 14 Gel-Filled Butt Connectors

X 1 Faceplate Gasket

X 4 6-32 x 3/4” Flat Head Torx

Drive Screws

X 1 Rough In Box

X 1 Wire Nut

Scan the QR code to

open and download

the product manual - OR -

4.0 Features Overview

Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries

assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.

See the Product Manual for complete installation and programming instructions.

Questions? Call Viking Product Support: 715-386-8666

K-1700-IP Quick Start Guide ZF303675 REV A

• Make sure the port is not in trunk mode

• Make sure port is capable of 100mbps full duplex

• Disable Spanning Tree Protocol (STP) or enable Portfast

3.0 Network Port Settings

MAC:

18E80FXXXXXX

asdesaxtff

N.C.

- Black

+ Red

- Black

+ Red

Green

White

N.O.

COM.

N.C. (Gray)

N.O. (Yellow)

COM. (Blue)

Relay 1

Output Contacts

(2A@30VDC/ 250VAC max)

Relay 2 Output Contacts

(2A@30VDC/ 250VAC max)

Request for Exit

(REX) Input

* 3 Gel-Filled Butt

Connectors (included)

+ Red

- Black

Black

- Black

+ Red

Speaker

LED

Microphone

Call Switch

MAC Address Label: The

MAC address is a unique

12 digit number used by

routers to send network

traffic to the correct IP

address.

PoE LAN Port 10/100,

PoE Class 2 (<6.5 Watts):

Connect to your LAN via

RJ45 plug and CAT5 or

greater twisted pair wire.

Yellow Network Status

LED: Lights steady to

indicate power and data

link. Blinks to indicate

network activity.

Green Unit Status LED

Rear (PCB) View of the

K-1700-IP Entry Phone

White

(Power typically not

required for gate controllers)

Doorstrike /

Magnetic Lock

120V AC

Connect to Optional

Doorstrike, Mag Lock,

Gate Controller, etc.

(not

connected)

26 Bit Wiegand Input / Output

For connecting optional Proximity Card

Readers, see Viking models left and

above (not included) or program as a

output to connect to the card reader

input of an Access Control System

12 VDC Power Output for

VE-LIGHT, etc.

(12VDC @ 50mA max)

Brown

Violet

White

Model PRX-1

Proximity Card

Reader DOD 221

Model PRX-3 Medium

Range Proximity Card

Reader DOD 228

Model PRX-5

125KHz

Mullion-Mount

Proximity Card

Reader with

Built-In Keypad

DOD 224

Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a

maximum insulation of 0.082 inches. Cut off stripped wire ends before terminating.

Other Viking Intercom System manuals

Viking

Viking C-2000A User manual

Viking

Viking E-32 User manual

Viking

Viking E-20 User manual

Viking

Viking D10 Instructions for use

Viking

Viking AES--2000 Instructions for use

Viking

Viking E-75-SS Instructions for use

Viking

Viking E-10A User manual

Viking

Viking W-3000 Installation and operating instructions

Viking

Viking HID-1 Instructions for use

Viking

Viking K-1270 Series User manual

Viking

Viking E-60-BK Instructions for use

Viking

Viking K-1705-3 Instructions for use

Viking

Viking W-3005/EWP User manual

Viking

Viking K-1775-IP Series User manual

Viking

Viking TBB-1 Instructions for use

Viking

Viking AES-2005 Instructions for use

Viking

Viking K-1700-3 Instructions for use

Viking

Viking K-1705-IP Series User manual

Viking

Viking E-35-IP User manual

Viking

Viking E-35-EWP User manual

Viking

Viking K-1200 Instructions for use

Viking

Viking K-1700-IP Series User manual

Viking

Viking AES--2000 Instructions for use

Viking

Viking W-1000 Instructions for use

Popular Intercom System manuals by other brands

Bticino

Bticino LINEA 3000 Installation

MSI

MSI MSI-140 owner's manual

golmar

golmar Stadio Plus instruction manual

CyberData

CyberData 011211 series Installation quick reference

Vidos

Vidos duo M1021 user manual

Vimar

Vimar ELVOX 7539/E Installation and operation manual

SSS Siedle

SSS Siedle BTSV 850-03 operating instructions

Dahua

Dahua VTO Series quick start guide

Elvox

Elvox 5651 Wiring instructions

Videx

Videx VIDEOKIT Series owner's manual

Rocom

Rocom Doortello Business FW T2.05W2.04 user guide

Safeguard Supply

Safeguard Supply LRA-EX1000 user manual

SSS Siedle

SSS Siedle BFCV 850 Series operating instructions

GRD

GRD MAX V2 user manual

Alecto

Alecto ADI-250 user manual

Aiphone

Aiphone IE-8MD Installation & operation manual

Perel

Perel EDB4 user manual

Bticino

Bticino Classe 300 installation manual