21-3600E rev1.2 Monitor xL™ LCD Keypad User's Guide iii
About This Guide
This guide provides details on performing
various tasks in a Monitor xL™ system using
an LCD keypad.
To locate a desired topic, refer to the table of
contents (near the front of this guide), or the
Index (near the back of this guide).
Tip: The bottom of each odd-numbered page also
gives an indication as to your general position
within this guide.
Also See (Related Documents)
For details on using the Director software,
refer to the on-line help or User's Guide
provided with the software.
Copyrights and Trademarks
™ Monitor xL is a trademark of CSG Security
Inc./Sécurité CSG Inc.
™ Pentium is a trademark of Intel Corporation
™ ® Microsoft, Windows, Windows2000, and
Windows XP, are trademarks or registered
trademarks of the Microsoft Corporation.
© Copyright 2006
CSG Security Inc./Sécurité CSG Inc.
All rights reserved.
Disclaimer
In the interests of ongoing improvement in quality
and design, we reserve the right to change product
specifications without prior notification. All
software, firmware, drawings, diagrams,
specifications, catalogues, literature, manuals and
other materials relating to the design, use, and
service of related products shall constitute the
proprietary information of the manufacturer.
Industry Canada Customer Information
NOTICE:
This equipment meets the applicable Industry
Canada Terminal Equipment Technical
Specifications. This is confirmed by the
registration number. The abbreviation, IC,
before the registration number signifies that
registration was performed based on a
Declaration of Conformity indicating that
Industry Canada technical specifications were
met. It does not imply that Industry Canada
approved the equipment.
The Ringer Equivalence Number (REN)
assigned to each terminal equipment provides
an indication of the maximum number of
terminals allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination of
devices subject only to the requirement that the
sum of the Ringer Equivalence Numbers of all
the devices does not exceed five.
The REN for the Monitor xL using the North
American Modem is 0.1
The REN for the Monitor xL using the
Worldwide Modem is 0.0
Repairs to certified equipment should be
coordinated by a representative designated by
the supplier. Any repairs or alterations made by
the user to this equipment, or equipment
malfunctions, may give the telecommunications
company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are
connected together. The precaution may be
particularly important in rural areas.
Caution: Users should not attempt to make
such connections themselves, but should
contact the appropriate electric inspection
authority, or electrician, as appropriate.
NORTH AMERICA:
Customer Instructions Pertaining to
FCC Regulations
This equipment complies with the Federal
Communications Commission (FCC) rules and
regulations governing telephone equipment
and the Technical Requirements for
Connection to the Telephone Network
published by the industry’s Administrative
Council for Terminal Attachments (ACTA). On
modem board of this equipment is a label that
contains, among other information, a product
identifier in the format US:AAAEQ##TXXXX.
If requested, this number must be provided to
the telephone company.
This equipment is designed to be connected to
the telephone network or premises wiring
using a hard wired connection that does NOT
rely on a modular jack. If a modular jack is
