BACKPACK PUMP, WITH BATTERY
Cod. 5981
4
Never use acids, alkaline products, and flammable solutions. Do not use highly toxic and highly
persistent pesticides to control parasites of edible plants or fruit trees, etc., without respecting the
time necessary for their dissolution before product consumption. In any case refer to the information
provided by the product manufacturer.
Do not throw used batteries into a fire. Do not open the batteries. Dispose of them according to local
regulations.
Do not store in an unattended public place in order to avoid endangering public safety. Keep out
of the reach of children.
Substances placed in this container should never exceed 45°C. Operation in an environment above
45°C or below -10°C should be avoided.
After use, rinse the container with clean water, operate the pump for at least 1 minute to remove
the internal parts. Before use and before filling the backpack pump with the product to be sprayed,
it is a good idea to use clean water to check for leaks.
The preparation of products to be sprayed must carefully follow the instructions of the product
manufacturer to avoid risk to people and animals, and for the proper treatment of the plants to be
sprayed.
At the end of work, change clothing and wash your exposed body parts such as hands and face.
In any case, observe the instructions of the manufacturer of the product being sprayed.
IV. OPERATION
1. Control panel description
The display is equipped with 5 LEDs (1 Yellow warning light, 3 Green warning lights, 1
Red warning light).
a. The green lights show the remaining charge. 3 green lights show that the battery is
fully charged; if only one green light turns on, power is low.
b. If the yellow light turns on, the battery is completely dead. Recharging is required. In
this case a beep will be heard.
c. The red light warns of overload/overvoltage. (This light will not turn on during normal operation)
1 warning lights 2 knob 3 socket for charging 4 fuse carrier
2. Charger operation
Make sure that the input parameters of the battery charger comply
with the power parameters of the 220 volt network.
The battery of the backpack pump is supplied charged, however you may need to recharge it before use.
Check the battery charge by turning the knob 2 in the maximum power position. If only one green light appears
or the yellow light appears, the battery must be recharged. The battery can only be charged with the battery charger
supplied, by connecting it to the charging socket of the backpack pump and then to the power socket.
When the 3 lights turn green, the battery is fully charged.
