Vallox 096 MV User manual

Manual

Models

Vallox 096 MV

Vallox 110 MV

Vallox 145 MV

Types

3722

3702

3712

MANUAL

Document

1.09.619 EN

Valid from

3.2.2015

Updated

18.1.2016

A+

MANUAL

CONTENTS

MANUAL

1. INTRODUCTION

•Main parts of the ventilation unit

•System description

•General safety instructions, guarantee and liability

•MyVallox Control control panel buttons

•Starting up and shutting down the unit

2. SETUP WIZARD

•Basic settings (setting the language, time and date)

•Expert settings (setting the password and access rights,

parental controls, fan settings, profile settings)

3. USING THE UNIT

•Ventilation profiles

•Temperatures and sensors

•Settings (filter, display settings, time and date, week clock,

turning the unit off)

4. MAINTENANCE

•Filters

•Heat recovery cell

•Fans

•Condensing water

•Troubleshooting

5. TECHNICAL SPECIFICATIONS

•Technical data, supply/extract air volumes, fan curves, sound

values, main components, measurement points, dimensions

and duct outlets

•Internal electrical connection

•External electrical connection

•Heating/cooling radiator operation chart

6. INSTALLATION

•Wall mounting

•Measuring tubes

•Ceiling mounting

•Floor mounting

•Condensing water

7. CERTIFICATE OF CONFORMITY

8. EXPLODED VIEW AND PARTS LIST

9. USER LEVEL DIAGRAMS

NOTE:

You can find your MyVallox account at www.MyVallox.com

INTRODUCTION

MAIN PARTS OF THE VENTILATION UNIT

R model in the figure

EXTRACT AIR FAN (BEHIND THE PROTECTIVE COVER)

SUPPLY AIR FAN (BEHIND THE EXTRACT AIR DUCT)

OUTDOOR AIR FILTER F7

HEAT RECOVERY CELL

SUMMER/WINTER DAMPER

OUTDOOR AIR FILTER G4

EXTRACT AIR FILTER G4

POST-HEATING RADIATOR (BEHIND THE EXTRACT AIR DUCT)

SAFETY SWITCH

CONTROL PANEL

CARBON DIOXIDE SENSOR

HUMIDITY SENSOR

INTERNAL HUMIDITY SENSOR

INTRODUCTION

INTRODUCTIONINTRODUCTION

SYSTEM DESCRIPTION

Modbus

Internet

Router

WLAN/LAN

WLAN

Additional switch

Sensors

DIFFERENCES BETWEEN THE UNITS

• Power

• Size

• Vallox 096 MV does not have an additional heater. Vallox 110

MV and Vallox 145 MV have an additional heater.

• Weight

• In the model Vallox 096 MV, there is a sealing tape at the

bottom of the heat recovery cell. In other models, there is a

separate sealing bar under the heat recovery cell.

• Standard delivery options vary from country to country.

• The available options vary from country to country.

Mounting options:

• Models Vallox 096 MV and Vallox 110 MV can be mounted

either on the wall, or on the ceiling by using a mounting plate

(optional). These models cannot be mounted on the floor.

• Model Vallox 145 MV can be mounted either on the wall, or

on the floor by using a floor rack (optional). This model cannot

be mounted on the ceiling.

GENERAL SAFETY INSTRUCTIONS

Safe and appropriate handling requires knowledge of the basic

safety regulations, and of the intended use of the ventilation

system. Read this manual before operating the ventilation unit.

Keep this manual for later use. If you lose the manual, it can be

downloaded from our website.

This user manual contains all important hints for operating the

system safely. All persons who operate and maintain the ventilation

system must follow the instructions provided in this manual.

Furthermore, all local accident prevention regulations must be

observed.

INTENDED USE

All Vallox ventilation units have been designed to provide

appropriate and continuous ventilation so as to present no threat

to health and to maintain structures in good condition.

GUARANTEE AND LIABILITY

The guarantee and liability exclude damage resulting from:

• Unintended use of the ventilation system or the control unit

• Improper mounting, initial operation and operation

• Operating the ventilation system with a defective safety

system

• Ignoring hints for transportation, mounting, operation and

maintenance

INTRODUCTION

IMPORTANT

For further information, go to

www.vallox.com

INTRODUCTION

Change profile button. This button allows you to

change the ventilation profile of the unit.

Profile Information button. This button allows you to

view the currently active profile information.

Temperature button. Pressing this button displays

information on temperatures and sensors.

Settings button. Press this button to open the settings.

Back button. Pressing this button takes you backwards in

the menu.

Left arrow button. Pressing this button takes you to the

left in the menu.

Right arrow button. Pressing this button takes you to the

right in the menu.

OK button. Press this button to accept the selected

option.

Select button. Press this button to select an option from

the list.

Edit button. Press this button to edit settings.

Plus button. Press this button to:

•Increase the value of the selected setting.

•Move to the next menu item.

•Move from a one-day view to a week view in the

temperature, relative humidity of air and carbon

dioxide level graphs.

Minus button. Press this button to:

•Reduce the value of the selected setting.

•Return to the previous menu item.

•Move from a week view to a one-day view in the

temperature, relative humidity of air and carbon

dioxide level graphs.

Up arrow button. Pressing this button takes you upwards

in the menu.

Down arrow button. Pressing this button takes you

downwards in the menu.

Statistics button. Pressing this button opens the

temperature, relative humidity of air and carbon dioxide

level graphs (1 day or 1 week).

These icons indicate the hierarchy level of the settings.

This icon indicates when the feature is turned off at your

user level. The parental controls lock code is 1001.

BUTTON DESCRIPTION

INTRODUCTION

NOTE

The MyVallox Control control panel

contains the buttons described in the

following table. You can press the

graphical user interface buttons by

using the ring-shaped buttons below

the control panel. The control panel

does not have a touch screen.

• Unauthorized structural alteration and changes of the

programming

• Disasters due to extraneous elements and force majeure

INSTALLATION

Installation and setup should be carried out only by qualified

experts. Electrical installations and connections must be

carried out only by an electrician and in compliance with local

regulations.

CONTROL PANEL BUTTONS

INTRODUCTION

In order to ensure that the indoor air presents no harm to health

and remains optimal also for the structures of the apartment,

ventilation must be kept on without disruptions. Even for longer

holidays, it is not advisable to stop the ventilation, because the

indoor air will become stuffy and, during the heating season, the

indoor air humidity may condense in the ventilation ductwork and

structures, causing moisture damage.

You can control and automate the Vallox ventilation unit operation

in the following ways:

• Through the control panel installed in the building

• Through the MyVallox Home local network connection and

the web interface

• Through the MyVallox Cloud cloud service and the web

interface

• Through a remote monitoring service or building automation

that uses voltage signals or Modbus messages

The required ventilation may also be adjusted automatically with

the optional carbon dioxide and humidity sensors. When these

are used, ventilation remains optimal even when the apartment is

unoccupied.

Each user can use the Week clock to adjust the ventilation to fit

their individual lifestyle.

WARNING

The unit is not intended for use by children under 8 or by persons

with reduced sensory, physical or mental capabilities, or whose

lack of knowledge and experience do not ensure safe operation

of the unit.

Such persons can use the unit under supervision, or by following

the instructions of someone who is responsible for their safety.

TIP

The MyVallox Control control panel automatically switches to

the sleep mode when the pre-set Sleep time has elapsed. To

reactivate the MyVallox Control control panel, press any button.

INTRODUCTION

The ventilation specialist has made the ventilation system basic

settings, based on the ventilation plan. The basic settings are:

• User interface language.

• Time and date.

• System administrator password. The installer has given you the

system administrator password.

• Parental controls, if turned on.

• Fan settings.

• User profile settings, such as the temperature.

If you are satisfied with the basic settings made by the installer, do

not make changes to them.

STARTING THE UNIT

If you are starting the ventilation unit for the first time or after a

maintenance procedure, first connect it to the mains. During the

start-up, the diagnostics display will appear for a few seconds,

after which the main display of the At home profile opens.

If the ventilation unit was turned off from the control panel (see

Turning the Unit Off), you can start it by pressing any control panel

button.

NOTE

The first launch of the unit may take a while, as the control panel

will format its software and verify that it has the latest software

version.

TURNING THE UNIT OFF

To turn the ventilation unit off:

1. Select Settings > Turn unit off.

2. Press the OK button.

3. The system asks for confirmation.

4. Press the OK button.

5. The ventilation unit has now been turned off.

INTRODUCTION

SETUP WIZARD

BASIC SETTINGS

SETUP WIZARD

1. Start the Vallox ventilation unit by plugging in the power cord

to the power outlet.

2. When you start the Vallox ventilation unit for the first time, the

Vallox logo is shown on the MyVallox Control control panel.

3. Press the OK button.

4. The setup wizard is launched.

SELECTING THE LANGUAGE

Select the user interface language as follows:

1. Use the arrow buttons to select the language you want, for

example, English:

2. Press the OK button.

3. The selected language is now English.

SET THE TIME

When the setup wizard prompts you to set the date and time, the

Time and date display opens first:

1. Use the Plus and Minus buttons to set the hours.

2. Press the Right arrow button.

3. Use the Plus and Minus buttons to set the minutes.

4. The time is now set.

5. Proceed to the next phase by pressing the Right arrow

button.

SET THE 24- OR 12-HOUR CLOCK

By default, the system uses the 24-hour clock.

To use the 24 hour clock, proceed to the next step by pressing the

Arrow right button.

To use the 12-hour clock:

1. Press the Minus button. The 24-Hour Time setting value is

changed to Off.

2. Proceed to the next phase by pressing the Right arrow

button.

Other manuals for 096 MV

This manual suits for next models

Table of contents

Other Vallox Fan manuals

Vallox

Vallox 125E MV User manual

Vallox

Vallox 90 SE R Manual

Vallox

Vallox 252 M User manual

Vallox

Vallox TSK MULTI 50 SC BP Manual

Vallox

Vallox 70 COMPACT R/L User manual

Vallox

Vallox DIGIT SE Specification sheet

Vallox

Vallox Vallox 101 MV User manual

Vallox

Vallox Vallox 101 MV User manual

Vallox

Vallox Vallox TSK Multi 50 MV EH User manual

Vallox

Vallox 70 COMPACT R Specification sheet

Vallox

Vallox C3741 User manual

Vallox

Vallox A3609 User manual

Vallox

Vallox 096 MV User manual

Vallox

Vallox A3741 User manual

Vallox

Vallox 096 MV User manual

Vallox

Vallox 096 MC R Owner's manual

Vallox

Vallox 90 SE Series Specification sheet

Vallox

Vallox 279846 User manual

Vallox

Vallox 51 MV User manual

Vallox

Vallox 75 Specification sheet

Vallox

Vallox 121 MC Series Owner's manual

Vallox

Vallox 132 E Series Specification sheet

Vallox

Vallox A3712-1 User manual

Vallox

Vallox 15P-EC User manual

Popular Fan manuals by other brands

ELTA FANS

ELTA FANS H03VV-F installation guide

Hunter

Hunter 20714 Owner's guide and installation manual

Emerson

Emerson CARRERA VERANDA CF542ORB00 owner's manual

Hunter

Hunter Caraway Owner's guide and installation manual

Panasonic

Panasonic FV-15NLFS1 Service manual

Kompernass

Kompernass KH 1150 operating instructions

VES

VES FALA100/12V/TR Original instructions

Vertiv

Vertiv Liebert DCD user manual

Westinghouse

Westinghouse GFP Series owner's manual

Venmar

Venmar KUBIX HRV PLUS Series user guide

Maico

Maico ECR 31 installation instructions

Sonnenkonig

Sonnenkonig Dinky instruction manual

S&P

S&P ECOWATT HXBR manual

Wider

Wider IMP03369BH instruction manual

Panasonic

Panasonic F-60DHN Operating and installation instructions

Hinkley

Hinkley HIGHLAND instruction manual

Broan

Broan 766BN installation guide

Premium

Premium PFS16022 Use manual