9>SEAT RECLINE
To recline: While squeezing the seat adjuster
tabs (o) together in a pincer like movement,
ease the seat down to the desired
position. Release the tabs and the seat will
automatically lock in that position
To incline: Place your hand in the centre of
the seat at the rear.
Pull the incline strap (p) while gently pushing
the seat upward to the desired position.
10>BRAKE
To engage the brake press down on the
central red brake pedal (q), until the brakes
engage fully into the wheel cogs.
To disengage, simply reverse the process.
11>HOOD AND HANDLE
The Expanda hood unzips, increasing the
size of your standard hood to give greater
coverage and protection from the sun and
weather for your child.
To open the Expanda Hood: Locate the zip
in the center of the Expanda Hood and unzip
completely (r). Gently pull the Expanda Hood
forward until it is reaches its full extension.
To close the Expanda Hood: Gently push the
Expanda Hood back, allowing the middle
section to fold in on itself. Carefully zip the
Expanda Hood closed.
The hood offers two height positions to
allow for your child’s growth (s). To increase
the height of the hood simply move the hood
to the second fixture.
NOTE: your handle is adjustable. Adjust
the handle by simultaneously pressing the
button on the handle sides and swivelling
the handle into the desired position.
12>HARNESS
Your stroller harness is specifically designed
with many built in safety features.
This includes the requirement that, when
opened, all straps are released so that no
dangerous loops can be formed causing a
strangulation hazard.
WARNING: YOUR CHILD MUST ALWAYS
BE HARNESSED WHEN IN THE STROLLER
Closing your harness:
Slide each of the shoulder strap bottom
guides (t) into the corresponding channel
on the top of each side strap prong.
Insert each completed prong into the central
buckle housing (u).
Carefully adjust the harness straps to snugly
fit your child by adjusting the sliders (v)
located on each strap. The harness should
be fitted to your child’s body, tight enough
so that they cannot wriggle free of the straps
but, loose enough, so as not to cause any
discomfort.
For even more flexibility, the height at which
your shoulder straps are fitted to the stroller
can be adjusted at 3 points. To change the
shoulder strap position:
From the rear of the seat, thread the top of
the strap back through the harness slot (w)
by manoeuvring the locking ring so that it
fits through the slot.
Rethread the strap back through the desired
slot from the front of the seat
Opening your harness:
Press the central housing button (x).
This will release both side prongs from the
central housing. The shoulder and waist
straps will release automatically from each
other.
If the shoulder and waist straps do not
automatically disengage from each other,
manually slide the guides of the waist
channels. Your harness will separate into 5
sections.
IMPORTANT WARNING: WHEN NOT IN
USE, BE SURE THE SHOULDER AND WAIST
STRAPS ARE ALWAYS DISCONNECTED
FROM THE CENTRAL HOUSING AND EACH
OTHER.
13>FOLDING
To ensure maximum compactness, prior to
folding your stroller:
•fold the hood closed back against the
handle
•incline the seat
•lower the bumper bar
•remove all contents from the basket
Locate the frame release (y) on either side
of the handle. Lift the frame release buttons
on either side of the handle simultaneously
upwards.
Swing the handle forward. As the handle
passes the fold joint (z), you will feel the
lower chassis release and fold downward in
a ‘z’ shape.
Push the frame down completely until the
frame lock engages.
