V-tech ErisStation VCS855 User manual
Wireless Speaker and DECT Dongle bundle
VCS855
Quick Start Guide
Wireless Conference System
ErisStation
TM
VCS850
VU-060
CHARGE
ErisStation
VCS855
DECT USB Expansion Speakerphone
2
Important safety instructions
When using your telephone equipment, basic safety precautions should always
be followed to reduce the risk of re, electric shock and injury to persons,
including the following:
Safety Information
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid or
aerosol cleaners. Use a damp cloth for cleaning.
4. Do not use this product near water such as near a bathtub, wash bowl,
kitchen sink, laundry tub or swimming pool, or in a wet basement or shower.
5. Do not place this product on an unstable table, shelf, stand or other unstable
surfaces.
6. Slots and openings in the wireless speaker are provided for ventilation.
To protect them from overheating, these openings must not be blocked by
placing the product on a soft surface such as a bed, sofa or rug. This product
should never be placed near or over a radiator or heat register. This product
should not be placed in any area where proper ventilation is not provided.
7. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power supply
in your oce, consult your dealer or local power company.
8. Do not allow anything to rest on the power cord. Do not install this product
where the cord may be walked on.
9. Never push objects of any kind into this product through the slots in the
product because they may touch dangerous voltage points or create a short
circuit. Never spill liquid of any kind on the product.
10. To reduce the risk of electric shock, do not disassemble this product, but
take it to an authorized service facility. Opening or removing parts of the
wireless speakerphone other than specied access doors may expose you to
dangerous voltages or other risks. Incorrect reassembling can cause electric
shock when the product is subsequently used.
11. Do not overload wall outlets and extension cords.
12. Unplug this product from the wall outlet and refer servicing to an authorized
service facility under the following conditions:
• When the power supply cord or plug is damaged or frayed.
• If liquid has been spilled onto the product.
• If the product has been exposed to rain or water.
• If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operation
3
• instructions. Improper adjustment of other controls may result in damage
and often requires extensive work by an authorized technician to restore
the product to normal operation.
• If the product has been dropped and the wireless speaker has been
damaged.
• If the product exhibits a distinct change in performance.
13. Avoid using the ErisStation wireless speaker during an electrical storm.
There is a remote risk of electric shock from lightning.
14. Do not use the ErisStation Wireless Speaker to report a gas leak in the
vicinity of the leak. Under certain circumstances, a spark may be created
when the adapter is plugged into the power outlet. This is a common event
associated with the closing of any electrical circuit. The user should not plug
the product into a power outlet if the product is located in an environment
containing concentrations of ammable or ame-supporting gases, unless
there is adequate ventilation. A spark in such an environment could create a
re or explosion. Such environments might include: medical use of oxygen
without adequate ventilation; industrial gases (cleaning solvents; gasoline
vapors; etc.); a leak of natural gas; etc.
15. The power cables are intended to be correctly oriented in a vertical or oor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling or cabinet outlet.
16. For pluggable equipment, the socket-outlet shall be installed near the
equipment and shall be easily accessible.
17. CAUTION: Use only the batteries indicated in this manual. There
may be a risk of explosion if a wrong type of battery is used. Use only the
supplied rechargeable battery or replacement battery pack (BT260280).
Do not dispose of batteries in a re. They may explode. Dispose of used
battery according to the information in The RBRC®seal.
18. Use only the adapter included with this product. Incorrect adapter polarity
or voltage can seriously damage the product. Base unit power adapter:
Input 100–240V AC 50/60Hz; Output: 12V DC @ 1.0A.
19. Use only with UL listed phones.
4
Precautions for users of implanted cardiac pacemakers
Cardiac pacemakers (applies only to digital cordless devices):
Wireless Technology Research, LLC (WTR), an independent research entity, led
a multidisciplinary evaluation of the interference between portable digital cordless
devices and implanted cardiac pacemakers. Supported by the U.S. Food and
Drug Administration, WTR recommends to physicians that:
Pacemaker patients
• Should keep digital cordless devices at least six inches from the pacemaker.
• Should NOT place digital cordless devices directly over the pacemaker, such
as in a breast pocket, when it is turned ON.
• Should use the digital cordless device at the ear opposite the pacemaker.
WTR’s evaluation did not identify any risk to bystanders with pacemakers
from other persons using wireless telephones.
WTR’s evaluation did not identify any risk to bystanders with pacemakers from
other persons using digital cordless devices.
SAVE THESE INSTRUCTIONS
5
Congratulations
on purchasing your new VTech product. Before using this product, please read
the “Important safety instructions” on page 2-4 of this manual.
This quick start guide provides you with the basic installation, setup, and
operation instructions for your VTech product.
For customer service or product information, visit our website at
vtechphones.com or call 1 (800) 595-9511.
Telephones identied with
this logo have reduced
noise and interference
when used with most T-coil
equipped hearing aids
and cochlear implants.
The TIA-1083 Compliant
Logo is a trademark of the
Telecommunications Industry
Association. Used under
license.
For Dongle VU-060: For Speakerphone VCS855:
FCC ID: EW780-1391-00 FCC ID: EW780-0585-00
IC: 1135B-80139100 IC: 1135B-80058500
HVIN: VU-060 HVIN: VCS855
PMN: DECT Dongle PMN: VCS855
ErisStation®is a registered trademark of VTech Communications, Inc.
Orbitlink Wireless TechnologyTM is a trademark of VTech Communications, Inc.
6
Introduction
The VU-060 DECT Dongle is preregistered to the VCS855 Wireless speaker.
The dongle enables you to connect the wireless speaker to your computer for
playing music or audio from soft phone calls.
What’s in the box
Your product package contains the following items. Save your sales receipt and
original packaging in the event warranty service is necessary.
VCS855 Wireless Speaker
Quick
Start
Guide
VCS855
Power adapter
VU-060 DECT Dongle
CHARGE
NOTE: The wireless speaker battery (BT260280) is not included, and must be
purchased separately.
To purchase the battery, or any accessories or replacements, visit our website at
www.vtechphones.com/store/products/accessories.
7
Wireless Speaker Overview
&+$5*(
1
1
2
2
3
3
4
4
5
5
6
6
7
7
Change LED
- On when charging
- Off when charging is complete
- Flashes when battery is low
1. Microphone
2. Speaker
3. MUTE ALL
During a call, press to mute or
end mute all microphones in
the system.
4.
• Press to enable the
speaker.
• Press to answer or end a
call.
5. Multipurpose LEDs (four)
6.
• Press to adjust the speaker
volume.
• Press to adjust the ringer volume.
• During a call, press to adjust the
speaker volume.
7. Microphone
8
Wireless Speaker LEDs
LED color and behavior Wireless speaker status
Steady Green • Call active, speaker on
Flashes Green • Incoming call
Flashes Green slowly • Paged by base
Steady Green for ve seconds • Successfully registered
Flashes Red and Green alternately • Ready for registration
Steady Red for ve seconds • Registration failed
Steady Red • Microphone muted
Flashes Red slowly • Out of range, deregistered
Steady Orange • Reset mode
Steady Orange for ve seconds • Power on
Install the wireless speaker battery
• CAUTION: Risk of explosion! Batteries should not be exposed to
excessive heat such as bright sunlight or re.
• CAUTION: Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
• Use only battery model BT260280.
1. After removing the battery door, plug the battery connector securely into the
socket inside the battery compartment.
2. Place the battery into the battery compartment.
3. Attach the battery door until it clicks into place.
Connect power to the wireless speaker
1. Plug one end of the AC adapter into the power jack on the bottom of the unit.
2. Route the cord through the slots.
3. Plug the large end of the AC adapter into a wall outlet not controlled by a
switch.
• The supplied power adapter is designed for use only with the VCS855
wireless speaker. It is not designed to power other devices. Do not
connect the supplied power adapter to any other devices.
• The AC power cord is intended for a vertical or oor mount position.
The prongs are not designed to hold the plug in place if it is plugged into
a ceiling, under-the-table, or cabinet outlet.
9
Wireless speaker specications
Frequency control Crystal controlled PLL synthesizer
Transmit frequency 1921.536–1928.448 MHz
Channels 5
Nominal eective range Maximum power allowed by FCC and IC.
Actual operating range may vary according to
environmental conditions at the time of use.
Power requirements Ni-MH Battery Pack (BT260280);
7.2V; 2100mAH rechargeable battery
Power adapter:
Input: 100–240V AC 50/60Hz
Output: 12V DC @ 1.0A
DECT Dongle Overview
LED status button
For manually registering the
dongle to a speaker.
NOTE: Your dongle is
preregistered to the wireless
speaker.
DECT Dongle LEDs
LED color and behavior DECT dongle status
Steady Green • Dongle is not in use
Steady Green for three seconds • Dongle is deregistered from the
wireless speaker
Flashes Green quickly • Incoming call
Flashes Green quickly every three
seconds
• Wireless speaker is in use
Steady Red • Dongle is not registered
Flashes Red very quickly • Dongle is registering to a wireless
speaker
Flashes Red quickly • Dongle is entering registration
mode
Flashes Red slowly • Wireless speaker is muted
10
Connecting the wireless speaker to a computer
Your DECT dongle is preregistered to the wireless speaker.
To connect the wireless speaker to your computer:
1. Plug the dongle in the USB port on your computer.
The dongle LED light will turn steady green.
2. Press the key on the wireless speaker.
This enables the speaker to play audio.
Registering the dongle
Your DECT Dongle is preregistered to the wireless speaker. You do not need to
register your dongle. However, the steps below are provided in the event you
need to manually deregister and re-register your dongle.
To register the dongle to the wireless speaker:
1. Make sure the wireless speakerphone is properly installed. Flashing red and
green LEDs indicate the wireless speaker is ready for registration.
2. Press and hold the REGISTRATION button on the bottom of the wireless
speaker for ve seconds, and then release the button.
3. Plug the dongle to the computer.
4. Press and hold the LED status button on the dongle for about four seconds
until the Dongle LED light ashes red very quickly, and then release the
button.
It takes about 60 seconds to complete the registration process. Once the wireless
speaker is registered, the wireless speaker LEDs stop ashing. The LEDs turn
green briey and then turn o.
Deregistering the dongle
1. Press the key on the dongle for 10 seconds to enter deregistration mode.
After 4 seconds the red LED starts to double-ash; after 10 seconds the
LED starts to ash red rapidly, indicating that the dongle has entered
deregistration mode.
2. Release the key and press it again for 1 second to conrm deregistration.
The LED turns green for three seconds, turns o for one second and then
shows steady red light.
Table of contents
Other V-tech Telephone manuals
V-tech
V-tech VT 2961 User manual
V-tech
V-tech ErisTerminal VSP875G User manual
V-tech
V-tech ia5882 User manual
V-tech
V-tech mi6879 User manual
V-tech
V-tech VT 9162 User manual
V-tech
V-tech CS6648-2 User manual
V-tech
V-tech CS6419 User manual
V-tech
V-tech ip5852 User manual
V-tech
V-tech LS6115 - DECT 6.0 W CALL User manual
V-tech
V-tech ErisTerminal VSP726A User manual
V-tech
V-tech gz5838 User manual
V-tech
V-tech ia5863 User manual
V-tech
V-tech S2213-10 User manual
V-tech
V-tech ia5847 User manual
V-tech
V-tech DS6291 User manual
V-tech
V-tech VSP725 User manual
V-tech
V-tech ia5824 Setup guide
V-tech
V-tech I 6783 Setup guide
V-tech
V-tech CS6147 User manual
V-tech
V-tech LS6191 User manual
