V-TAC VT-521 User manual
WEEE Number: 80133970
INSTALLATION MANUAL
RECESSED HANGING EMERGENCY EXIT LIGHT
VT-521
SAFETY:
• Installaon of this luminaire should only be carried out by a qualified electrician or
competent person to the current IEE Wiring Regulaons (BS7671)
• Please isolate mains prior to installaon/maintenance
• Check the total load on the circuit, including when this luminaire is fied, does not
exceed the rang of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protecon) rang of this luminaire when deciding the
locaon for Installaon
• This product is Class II double insulated
• This product is non-dimmable
INSTALLATION:
• Provide power to the required point of installaon,
• Cut a suitable aperture in the ceiling as per the cut-out details in Fig 1 ensuring that it
does not infringe with electrical cables, water/gas pipes or ceiling joists
• Connect the baery to the inverter via the plug and socket provided
• Connect the live and neutral to the push fit terminals on the PCB of the inverter (Fig 3)
• Remove 2 screws on top of the fing (see Fig 2)
Fig1
Fig2
Remove screws
Cable entry point
WARNING:
• This product must be disconnected from the circuit if subjected to any high voltage or
insulaon resistance tesng. Irreparable damage will occur if this instrucon is not
followed
• Recommended roune test procedure in accordance with BS5266
• Daily check – check that the status GREEN LED indicator is illuminated
• Monthly funconal test – simulate a mains supply failure for approx. 30 secs by
operaon of key switch or switching off a circuit breaker. Ensure normal supply is
restored aer test and the indicator status LED is illuminated
• Twice yearly conduct a one hour duraon test - simulate a mains supply failure for one
hour connuous test by operaon of key switch or switching off circuit breaker. Ensure
normal supply is restored aer test and the indicator status LED is illuminated
• Annual full three hour duraon test - conduct a three hour connuous duraon test.
Simulate a mains supply failure for three hour connuous test by operaon of key switch
or switching off circuit breaker. Ensure normal supply is restored aer test and the
indicator status LED is illuminated
• If the luminaire fails any of the above tests, please contact a qualified electrician.
Fig 3
Live (brown)
Neutral (blue)
LS
N
L
L
GENERAL:
The LEDs fied in this product are non-replaceable. The unit should be recycled in the
correct manner when it reaches the end of its life. Check local authories for where
facilies exist.
Clean with a so dry cloth only, do not use aggressive cleaning products or solvents
which may damage the fing.
GUARANTEE
• This product is only guaranteed against defects in manufacture.
• The warranty is valid for two years from date of purchase.
• The warranty does not cover damage caused by improper installaon or abnormal wear
caused.
• The manufacturer does not warrant damage to surfaces resulng from improper
removal Or installaon.
In case of any query/issue with the product you can reach out to us at [email protected]
Table of contents
Other V-TAC Lighting Equipment manuals
V-TAC
V-TAC VT-967 User manual
V-TAC
V-TAC VT-7522 User manual
V-TAC
V-TAC VT-8082 User manual
V-TAC
V-TAC 80133970 User manual
V-TAC
V-TAC VT-45055 User manual
V-TAC
V-TAC VT-767-2 User manual
V-TAC
V-TAC VT-1143 User manual
V-TAC
V-TAC VT-13 User manual
V-TAC
V-TAC VT-4121 User manual
V-TAC
V-TAC VT-522-S User manual
Popular Lighting Equipment manuals by other brands
Qazqa
Qazqa Suplux SL 3 Black 103062 instruction manual
Commercial Electric
Commercial Electric 54568141 Use and care guide
CREE LIGHTING
CREE LIGHTING 304 Series installation instructions
Goobay
Goobay 49867 user manual
ECOMAN ITALIA
ECOMAN ITALIA LED T8 instruction manual
Alkalite
Alkalite Krypton KT-81 user manual
