DS1722-129 10 LBT20731
2.5 HOW TO MAKE VIDEO SWITCHING BETWEEN VIDEO DOOR PHONES
The call tone will be generated in alternating manner by the different video door phones after a call if "Slave"
video door phones (OP3) are present in the system. The 'Master' video door phone will enable also the video
door phone switching on. In this case, during the call pick-up time (3 minutes from the call), the other device
video door phones can be switched on by pressing and buttons in sequence (video door phone
switching function), until one of the video door phones picks up.
The picture of the camera will appear only on the device that picked up afterwards.
The camera picture will therefore be normally shown on only one apartment station at a time.
2.6 HOW TO CONTROL AUTO-ON AT THE CALLING STATION
Turn on the screen, if off, by tapping it at any point or by pressing the button (5) in the bottom right
corner of the screen.
Tap the icon to view the images from the camera at the calling station.
By pressing the various icons at the same time it is possible to:
Listen to the environmental noise near the calling station and start a hands-free conversation. To
stop viewing, press the same icon again: the screen will go off.
Open a driveway or garage gate.
Activate an auxiliary function, e.g. turning on the stair lights.
(The icon is only active if the feature has been configured in the 'Settings' menu for Yokis Home
Automation options. For the button configuration, please refer to the dedicated instruction manual
available on the Urmet website.)
Open a submenu where you can:
Change the audio volume in the calling point-to-video door phone direction, or the
brightness , contrast , and colour of the display (the changes will be
stored only if the button is pressed afterwards).
Enlarge or shrink the image, also changing its format from 4:3 to 16:9.
Stop the vision of the camera if the audio is disabled
Store a snapshot of the outdoor picture displayed on the screen.
Turn off or reactivate the video door phone microphone, to prevent anyone opposite the
calling station from overhearing the conversation. The icon will only be active after pressing
the button .
The icon will flash to signal an activated function.
Close the previous submenu.
