UNITED R-102 User manual
Model No: R-102
Handheld vacuum cleaner
User Manual
Brief Introduction
It is a cordless handy rechargeable vacuum cleaner.
It is et and dry, can suck up dust and ater easily.
It is very convenient for home or any similar places.
General description( Fig. 1)
A. Dust compartment
B. Dust compartment release button.
C. On/off slide
D. Charging light(LED)
E. Charger base
F. Accessories:
1. Squeegee brush; 2.Brush tool;3.Crevice tool,
G. Filter unit, including:
4.Inner filter holder; 5.Inner filter; 6. Filter ring
7.Outer filter
H. Adaptor
Important
Read this user manual carefully before you use the
appliance and save it for future reference.
Danger
- Never suck up flammable substances or corrosive
liquids and do not suck up ashes until they are cold.
- Never immerse the vacuum cleaner or the charger in
ater.
Warning
- Check if the voltage indicated on the appliance
corresponds to the local mains voltage before you
connect the appliance.
- Do not use the appliance if the plug, the mains cord
or other parts are damaged.
- If the cord of the adaptor is damaged, it can not be
replaced and the adaptor must be discarded.
- The adaptor and the charge of this appliance can not
be replaced. If the adaptor or charger is damaged,
the appliance must be discarded.
- This appliance is not intended for use by persons
(including children) ith reduced physical, sensory
or mental capabilities or lack of experience and
kno ledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
- Children should be supervised to ensure that they do
not play ith the appliance.
Caution
- Remove the adaptor from the all socket before you
clean the charger.
- Only charge the vacuum cleaner ith the adaptor and
the charger supplied. During charging, the adaptor
feels arm to the touch. This is normal.
- Do not hold the appliance ith the dust compartment
pointing up ards and do not tilt the appliance to
one side hen you suck up liquids.
- Al ays s itch off the vacuum cleaner after use.
- The voltage on the contact strips in the charger is lo
and therefore not dangerous.
- Never block the exhaust air openings during
vacuuming.
- S itch off the appliance hen you recharge it.
- Al ays use the vacuum cleaner ith the filter unit
assembled.
- When you have used the appliance to suck up liquids,
empty and dry the dust compartment before you
store the appliance in the charger.
- To avoid the risk of electric shock, be careful hen
you drill holes in the all to attach the charger,
especially close to a all socket.
Preparing for use
Installing the charger
1. Attach the charger to the all as sho n(Fig.2).
If you attach the charger to the all, the space
bet een the scre holes has to be 12 cm.
2. You can also place the charger on a horizontal
surface(e.g.a table or desk)(Fig. 3)
(Fig.2) (Fig.3)
Charging the appliance
Charge the appliance for at least 10 hours every time
hen the appliance runs out of po er.
1. Make sure the appliance is s itched off.
2. Put the adaptor in the all socket,.
3. Place the vacuum cleaner on the charger(Fig.4)
* The charging light goes on to indicate that the
appliance is in charging(Fig.5)
(Fig.4) (Fig.5)
Note The charging light stays on as long as the
appliance is in the plugged-in charger.
Note The charging light does not give any information
about the battery charge level of the vacuum cleaner.
Using the appliance
1. Push the on/off slide
For ards to the s itch
on the appliance.
2. Push the on/off slider
back ards to s itch
off the appliance (Fig.6) .
Accessories
The appliance comes ith the follo ing accessories:
- a brush tool to clean delicate surfaces;
- a crevice tool to vacuum corners or narro gaps;
- a squeegee to suck up liquid.
(Fig.6)
1. Take the accessory you ant to use.
2. Attach the accessory to the nozzle of the appliance.
(Fig.7)
Sucking up liquid
Connect the squeegee to the appliance.
1. Hold the appliance ith the nozzle pointing
do n ards at an angel of 30o.
Note Never hold the appliance ith the nozzle
pointing up ards hen there is liquid in the dust
compartment.
Note Do not tilt the appliance to one side or shake the
appliance hen there’s liquid in the dust compartment
3. Place the squeegee on the surface to be cleaned.
Make sure the squeegee stays in contact ith the
surface.
4. Suck up liquid
Stop sucking up liquid hen the liquid level inside the
dust compartment has reached the maximum
indication.
5. Empty and dry the dust compartment each time
you have used the appliance to suck up a liquid.
Cleaning
Al ays remove the adaptor from the all socket
before you clean the charger. When you have used the
appliance to suck up liquid al ays empty and dry the
dust compartment after use. Clean the appliance and
the charger ith a damp cloth.
1. Hold the appliance over a dust bin, press the dust
compartment release button(1) and remove the
dust compartment(2) .(Fig.8)
2. Remove the filter unit from the main body(Fig.9).
3. Empty the dust compartment by shaking it ith
the free hand(Fig.10). If necessary, clean the dust
compartment ith a damp cloth.
Make sure you empty and clean the dust compartment
regularly.
(Fig.8) (Fig.9) (Fig.10)
Note If there is liquid in the dust compartment,
empty the dust compartment and ipe it dry.
4. Clean the filter unit:
Take the outer filter from
the filter holder and then
the filter ring and remove
inner filter from the filter
holder.(Fig.11)
Clean the inner filter and the
outer filter ith a brush or ith a normal vacuum
cleaner if it is very dirty.
Note: If necessary, you can clean the inner filter and
the outer filter in cold or luke arm ater. Dry the
inner and outer filter thoroughly before you use the
filter unit again.
5. Put the inner filter back into the filter holder, put
the filter ring and then the outer filter.(Fig.12)
6. Put the filter unit back to the dust compartment.
(Fig.13).
7. To reattach the dust compartment, align the slot on
the dust compartment ith the projection on the
appliance. First attach the bottom of the dust
compartment(1) and then push the top of the dust
compartment to ards the appliance(2) until it
locks into place("click")(Fig.14)
(Fig.11)
(Fig.12) (Fig.13) (Fig.14)
Storage
You can store the vacuum cleaner and the accessories
on the charger.
Replacement
We advise you to replace the inner filter after a
prolonged period of use or if you can no longer clean it
properly.
Replacing the inner filter
1. Remove the filter unit from the main body.
2. Take the outer filter from the filter holder.
3. Gently take off the filter ring, then the inner filter.
4. Place a ne inner filter on the filter holder and
put the ring on to attach it.
5. Put the outer filter back and fix them properly.
6. Put the filter unit back into the dust compartment.
Note Make sure you insert the filter unit in the correct
ay.
Table of contents
Other UNITED Vacuum Cleaner manuals
