Tylo SENSE PLUS/MPE User manual

1304

ENGLISH

USER GUIDE

SENSE PLUS /MPE

29005151 -ENG

Keep this user guide!

In the event of any problems, please contact the retailer

where you purchased the equipment.

without the written permission of Tylö. Tylö reserves the right to

make changes in materials, construction and design.

TABLE OF CONTENTS

General information ....................................................... 1

Before use ...................................................................... 1

The first time you use the heater ...........................................1

Before each use .....................................................................2

Use ...................................................................................3

Functions .............................................................................. 3

After use ......................................................................... 3

Switch off main power switch ................................................ 3

Maintenance ....................................................................4

Cleaning the fragrance holder and air humidifier ................... 4

Check the stone compartment ...............................................4

Troubleshooting ............................................................. 5

Troubleshooting the sauna heater ......................................... 5

Spare parts list ...............................................................5

RoHS (Restriction of Hazardous Substances) .............6

GENERAL INFORMATION

Congratulations on your new sauna heater! Follow this user guide

to get the most from your purchase.

Wet and dry saunas are forms of bathing which originate way

back in history. These hot sauna baths are best at temperatures

between 70-90°C.

BEFORE USE

The first time you use the heater

Fill the stone compartment

CAUTION! Always use dolerite stones (Tylö Sauna

Stones). “Ordinary” stones can damage the heater.

Do not use ceramic stones. Ceramic stones can

damage the heater. The heater guarantee does not

cover damage caused by ceramic stones.

Fill the stone compartment around the heating elements from the

bottom to the top, to approx. 50 mm above the front top edge.

Do not press the stones into place. Capacity: Approx. 20 kg of

stones.

Place the stones loosely to allow optimum air circulation. The tu-

bular heating elements must not be squeezed together or against

the side.

Sauna stones must:

• tolerate extreme heat and fluctuations caused by water being

poured on them.

• be cleaned before use.

• have an uneven surface, so that the water “clings” to the

stone surface and evaporates efficiently.

• be between 30-50 mm in size to allow air circulation in the

stone compartment. This will increase the life of the tubular

elements.

CAUTION! Never place stones on top of the side air

chambers. Covering the vents will obstruct air circu-

lation, the unit will overheat and the cut-out switch

will activate.

Figure 1: Filling the stone compartment

1. Stone compartment

2. Side chambers

Switch on the heater to remove any new paint odours

To remove “new paint odour” from the heater:

Heat to approx. 90°C for about one hour.

A little smoke may appear.

Read the User Guide for the control panel for operation of the

controls and heater.

Before each use

Check the following

Check that:

• there are no foreign objects in the sauna cabin, on or in the

heater.

• the door and any windows to the sauna cabin are closed.

• that the sauna door opens outwards with a little pressure.

NB:

DANGER! Anyone with a mental or physical disabil-

ity or little experience of or knowledge of how to use

the equipment (e.g. children) must be instructed or

supervised by someone responsible for their safety.

DANGER! Do not touch the upper parts of the heat-

er - risk of burns! Tylö recommends that the heater

screen is always used.

DANGER! Never allow children to play near the

heater!

DANGER! Saunas are not recommended for people

in poor health. Please consult a doctor.

DANGER! Fragrant essences and similar products

can ignite if poured directly onto the stones.

DANGER! Covering the heater can cause fire.

CAUTION! Never use a hose in the sauna.

NOTE! Do not use the sauna cabin for any purpose

other than taking saunas.

Turn on the main power switch

The main power switch is at the bottom of the heater.

Turn on the main power switch if not already on (see Figure 2,

Page 2).

Figure 2: Location of main power switch

1. Main power switch

USE

Functions

Fragrance holder

DANGER! Fragrant essences etc. may ignite if

poured directly onto the stones.

To create a pleasant fragrance in the sauna, pour a few drops of

Tylö Sauna Fragrance into the water in the fragrance holder.

You can also mix a few drops of the sauna fragrance with water in

a sauna bucket and pour the water on fully heated stones. Use a

sauna ladle for pouring water on the hot stones.

Tylö Sauna Fragrance comes in six fragrances:

• eucalyptus,

• mint,

• menthol,

• pine,

• lemon

• and birch.

Figure 3: Other functions

1. Fragrance holder

2. Air humidifier

Air humidifier

DANGER! Do not pour water into the fragrance

holder once it has been heated up, as this can cause

boiling water to splash on the sauna occupants. Do

not stand or sit in front of the heater while water is

being poured into the fragrance holder, as hot water

can spray out suddenly.

To maintain a pleasant basic humidity in the sauna, fill the built-

in air humidifier (see Figure 3, Page 3) with water before

switching on the sauna.

TIP! Pour a few drops of diluted sauna fragrance into

the built-in air humidifier.

AFTER USE

Switch off main power switch

The main power switch is at the bottom of the heater.

Switch off here when the heater is not to be used for an extended

period (e.g. several weeks).

Figure 4: Location of main power switch

MAINTENANCE

Cleaning the fragrance holder and air humidifier

Clean the fragrance holder and air humidifier as required.

To clean the fragrance holder and air humidifier:

Remove the fragrance holder/air humidifier and rinse them under

running water.

Figure 5: Cleaning the fragrance holder and air humidifier

Check the stone compartment

Check the stone compartment once annually.

How to check the stone compartment:

1. Pull off the panel holding the tubular elements in place (se

Figure 6, Page 4).

Figure 6: Remove the panel holding the tubular elements in

place

2. Tilt the tubular elements to help remove the stones see Fig-

ure 7, Page 4.

Figure 7: Angle the tubular elements

3. Remove all the stones from the compartment.

4. Remove any small stones, gravel and limescale from the com-

partment.

5. Replace the panel that holds the tubular elements in place.

WARNING! The panel securing the tubular ele-

ments must be in place before putting the stones

in.

Put whole, undamaged stones back. Replace damaged

stones with new ones as required (see The section called Fill

the stone compartment, Page 1).

TROUBLESHOOTING

Troubleshooting the sauna heater

Table 1: Troubleshooting the sauna heater

Symptom Possible cause Remedy

Heater is not work-

ing.

Main power switch

is off.

Switch on.

Heater is not work-

ing.

Fuse blown/tripped Replace/reset fuse.

Heater is not work-

ing.

Temperature cut-out

has been activated.

For more informa-

tion, see The sec-

tion called Temper-

ature cutfunction,

Page 5.

Check and remedy

the cause of tem-

perature cut-out ac-

tivation.

If you are unsure

why the temperat-

ure cut-out was ac-

tivated, contact an

electrician.

Temperature cutfunction

The sensor's temperature cut-out has the purpose of protecting

the components, tubular elements and woodwork in the sauna

from overheating. If the temperature cut-out is activated, the elec-

tricity supply to the control panel will be cut off. When the temper-

ature in the sauna cools down, it can be reset. The cause of the

overheating must be established before resetting the temperature

cut-out. To reset it, press the spring-loaded button with a small

implement such as a paper clip (see Figure 8, Page 5).

Figure 8: Resetting the sensor temperature cut-out

SPARE PARTS LIST

Figure 9: Spare parts

1. 9600 0177 / 8 kW, 9600 0178 / 6 kW Tubular element

2. 9600 0728 Stone compartment

3. 9600 0091 Circuit board

4. 9600 0723 Terminal block

5. 9600 0041 Relay 3-pole

6. 9600 0554 Strain relief connector

ROHS (RESTRICTION OF HAZARDOUS

SUBSTANCES)

Instructions for environmental protection.

Do not dispose of this product with the domestic refuse when no

longer in use. Take it to a recycling station for electrical and elec-

tronic equipment.

For further information, see the symbol on the product, manual or

packaging.

Figure 10: Symbol

The different materials can be recycled as specified by their la-

belling. You can help protect the environment by recycling or re-

using the spent appliances or the materials in them. Take the

product to a recycling centre without the sauna stones or the

soapstone jacket (if fitted).

Contact your local authorities for details of your nearest recycling

centre.

Table of contents

Languages:

Popular Heater manuals by other brands

oventrop

oventrop Regucor Series quick start guide

Blaze King

Blaze King CLARITY CL2118.IPI.1 Operation & installation manual

ELMEKO

ELMEKO ML 150 Installation and operating manual

BN Thermic

BN Thermic 830T instructions

KING

KING K Series Installation, operation & maintenance instructions

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Installation instructions and owner's manual

Well Straler

Well Straler RC-16B user guide

EUROM

EUROM 333299 instruction manual

Heylo

Heylo K 170 operating instructions

Eterna

Eterna TR70W installation instructions

Clarke

Clarke GRH15 Operation & maintenance instructions

IRSAP

IRSAP The Radiator Company Ovali Fitting instructions

Empire Heating Systems

Empire Heating Systems WCC65 Installation and owner's instructions

Wetekom

Wetekom 92 86 43 Original instructions

Desa

Desa SPC170-F owner's manual

Watlow

Watlow Watrod Electric Tubular Heaters Specifications

Haverland

Haverland ECO-DRY GPS Series Instruction & installation manual

Stelpro

Stelpro ASILVC2060 Series user guide