TV Star T2505 User manual

High Definition Digital Receiver
T2505

1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
8) Operate this product only from the type of power source indicated on the
label. If you are not sure of the type of power connected to your home,
consult your local power company. Disconnect the unit from the mains before
any maintenance or installation procedure.
9) Protect the mains cord from damage and stress.
10) Only use attachments/accessories specified by the manufacturer.
11) Unplug this apparatus during lightning storms or when unused for long
periods of time.
12) Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, including damage to the
mains cord or plug, if the unit has been exposed to liquid or moisture,
has been dropped or is not operating correctly.
13) Do not impede the air flow into the unit by blocking the ventilation slots.
14) Attention should be drawn to the environmental aspects of battery disposal.
15) Use the apparatus in moderate climate.
WARNING: To reduce the risk of fire or electric shock, do not expose this
apparatus to rain or moisture.
WARNING: The batteries shall not be exposed to excessive heat such as
direct sun light, fire, etc.
Important Safety Instructions

This symbol indicates that there are important operating and
maintenance instructions in the literature accompanying this unit.
This symbol indicates that dangerous voltages constituting a risk of
electric shock are present within this unit.
This symbol indicates that this product incorporates double insulation
between hazardous mains voltage and user accessible parts.
When servicing use only identical replacement parts.
This symbol on the product or in the instructions means that your
electrical and electronic equipment should be disposed at the end of
life separately from your household waste. There are separate
collection systems for recycling.
For more information, please contact the local authority or your retailer
where you purchased the product.

Table of Contents
Front and Rear Panel ............................................................................... 1
Remote Control.... ................................................................................... 2
Connecting to a Television.........................................................................4
First TimeInstallation............................................................................... 5
Troubleshooting......................................................................................16
Technical Specifications...........................................................................17
AAA Battery
DVB-T TV Receiver
User Manual
Remote Control
High Definition Digital Receiver
T2505

Front and Rear Panel
1. Front panel
1
2. Rear panel
1
2
3
4
COAXIAL
RF IN:
feed
SCART
This socket connects to your external Aerial.
RF LOOP THROUGH: This socket will the RF signal to either your TV or
another video system.
.
High definition audio and video output used to connect to a HDMI device
HDMI:
5
2
1
REMOTE CONTROL SENSOR: Used to receive the signal from the Remote Control.
USB: For software upgrade and media playback.

Remote Control
2
POWER: Switch the receiver in and out of
Standby mode.
<0>-<9>: Numeric keys.
CH-/CH+: Program changing keys.
MENU: Display main menu on TV screen, and
press again to disappear menu.
OK: To confirm current setting, or display all
programs in no-menu mode.
VOL-/ VOL+: To increase / decrease volume.
: Press to move the cursor
EPG: Shows the Electronic Program Guide.
FAV: Displays your favorite channels list.
Press FAV again to access to the other
favorite lists.
V-FORMAT: Switch the HDMI 720P and 1080i.
RECALL: Go back to the previous viewed
channel.
Red/green/yellow /blue: Use to navigate
between pages in
teletext mode.
TTX: Switch on Teletext, if current channel has
this option, and use EXIT key to quit
Teletext.
SUBTITLE: Display subtitle options
(availability depends on the channel).
LANG: Change the Audio language and
Left/Right channel (availability depends
on the channel).
EXIT: Use this key to quit current menu.
INFO: Display information about the current
channel.
TV/RADIO: Switch between Digital Radio and
DVB-T modes.
MUTE: To navigate inside the menus.
PAGE+/PAGE -: To navigate inside the menus.
ASPECT:Switch 4:3/16:9.
TIMESHIFT: See page 16
ZOOM
LIST
GOTO
REPEAT
TIMER
Multimedia keys:
REW FF PREV NEXT

Installing the Batteries
Remove the battery cover from
2xAAA size batteries inside the compartment.
the rear of the Remote Control and place
Please make sure the battery polarities match the polarity markings inside
the compartment.
OPEN
CLOSE
1.Open the cover 2.Install batteries 3.Close the cover
Using the Remote Control
To use the Remote Control, point it towards the front of the Digital Set Top Box.
The Remote Control has a range of up to 7 metres from the Set Top Box at an
angle of up to 60 degrees.
The Remote Control will not operate if its pa h is blocked.
Sunlight or very bright light will decrease the sensitivity of the
Remote Control.
3

Connecting to a Television
For a basic connection from your Set Top Box to the television, use the
Composite connection outlined below.
For a higher quality connection, use the Component Video connection
outlined below combined with the Composite Audio Connection.
For the highest quality connection use a direct HDMI connection,
see below.
4

First Time Installation
(1) [OSD Language] press RIGHT/LEFT key to select a language.
(2) [Country] press RIGHT/LEFT key to select your country of
residence.
(3) [Channel Search] press RIGHT or OK key to begin Automatic
channel search.
(4) Once channel tuning is complete, you can start watching TV programs.
After all connections have been made properly, switch on TV and make sure the
is connected to the Main Power. Press Power button to switch on.
If you are using the for the first time or
.neercsVTruoynoraeppalliweht
tinuehttinu
unit or have restored the unit to Factory
Default, Installation Guide Menu
Basic Operation
(1). Program Manage Settings
To access the Menu, press the MENU button and select [Program].
The Menu provides options
to adjust the Program Manage Settings. Select an option and press OK or
RIGHT to adjust that setting. Press the EXIT button to exit the Menu.
using the
RIGHT/LEFT keys to navigate through the menu.
5

(a) Program Edit
To edit your program preferences (lock, skip, favourite, move or delete), you
will need to enter the Program Edit Menu. This Menu requiresa password to
access. Enter the default password '000000'. The master unlock password
is .'888888'
Set Favourite
You can create a shortlist of favourite programs that you can easily access.
Set Favourite TV or Radio program:
.nottubETIRUOVAFehtsserpnehttceleS.1
Aheart-shaped symbol will appear and the is marked as a favourite.
2. Repeat the previous step to select more Favourite .
3. To confirm and exit the Menu, press the EXIT key.
Disable Favourite TV or Radio :
View Favourite
et
iruovaFehtdnanottubetiruovaF.1
Menu will appear.
2. Press UP/DOWN to
3. Press OK to select your favourite .
TV or Radio Program
1. Select the Program and then press the BLUE button.
A will appear. Press OK to delete the
2. Repeat the previous step to select more to delete.
Skip TV or Radio
1. Select the you would like to skip and press the GREEN button.
Askip symbol is displayed. The is marked as a skip.
2. Repeat the previous step to more .
.yekTIXEsser
p,unemehttixeoT.3
Disable
Channels
your desired channel
channel
channels
Channel
Select the Favorite channel and press Favorite button on the remote control
to cancel.
Channel
While in normal viewing mode, press
browse through your Favourite Channels.
channel
Delete a
.lennahcegassemgninraw
channels
Channel
channel
channel
skip channels
save your settings and
the Skip Channel function:
Select the Skip channel and press the GREEN button on the remote
control to cancel.
6
Table of contents
Other TV Star TV Receiver manuals























