Step 8. Top, Parts required-315
Secure 315
into position using 8x20mm CHB’s as shown
Step 9
.
Mounting the Flat Panel,
Parts
required- 4x 313
Note: Minimum of 2-3 people are required for this
step.
Using two people remove the panel from it’s shipping
box. Remove the soft foam cover from the panel lay the
shipping box flat, lay the foam onto the box then lay the
panel onto the foam on the box (Face Down).
As there are an infinite amount of panel Styles, Brands
and Models out there. This is has been designed as a
guide only.
Read the manufactures instructions to locate the
correct size Visa Mount spacing and screw size to
mount the panel.
Panels with 100x100mm Visa Mount Centers.
Using the correct size bolts use a Nylon spacer wide
enough to separate the panel from the stand when the
bolts are secured.
OR
Panels with other size Visa Mount Centers.
Measure screws and the Visa Mount spacing and that
will determine the spacing for the braces, part # 313.
Then orientate the panel braces 313, nylon spaces,
washers and 6x30mm CHB ‘s to secure the panel to
the stand as photos will indicate.
Each panel will mount slightly different to the photos
below so don’t be discouraged if there are parts left
over from this step.
Note: Only tighten the bolts to the panel in
accordance with the manufactures specifications.
Once you have trial fitted the Stand Visa Mount 4x part
313 bolt it to the stand using 6x30mm CHB, spacers
and Nylock Nuts Lay the stand down onto the panel
(using minimum of two people).
Note: The stand will have to sit level with the panel
for this step.
Secure the panel to the Visa Mount using the correct
size bolts. Tighten in accordance with the manufactures
specifications.
Note: Use minimum of 3 people for this step.
Using a minimum of 3 people one to secure the base of
the stand, one more on each side of the panel and then
raise the stand vertical.
4x 313
Nylon
Spacer
6x 30mm CHB
Clear Gap between
314 & 313
315
6x 30mm
Hex Bolt
