ENGLISH
5
www.trapp.com.br
Disconnect the battery cable,
remove the fuses, or disconnect the
power plug before performing any
adjustments or changing cutting
blades and accessories. Before
accessing the cutting system, wait
for the complete stop of the disk to
open the machine body and have
access to the shredder’s cutting
system. Such preventive measures
reduce the risk of accidental
operation of the equipment.
Carefully observe the way of introducing
the materials into the shredder; irregular
materials may hit the operator when pulled
by the feeder roll. Insert the material in the
input funnel and, when the feeding roll pulls
it, step away from the shredder.
Do not allow unacquainted persons to use
the equipment. The equipment may become
dangerous at the hands of users unacquainted
with its operation.
Check the site where you intend to release
the shredded material and regulate the
material outlet nozzle before turning on the
shredder. It is recommended that the nozzle
work in parallel to the disk so to avoid
clogging on the exit of material.
Do not use the shredder in sites that are moist
and poorly illuminated.
As soon as the disk reaches the ideal rotation,
start the feeding rolls through the drive bar
located in the feeding funnel and insert the
material you wish to shred.
Before introducing the material you wish to
shred, check the information in this manual
to see the indicated work rotation.
Be acquainted with all the triggering
commands of the shredder to know how to
act in a possible emergency stop.
Conserve your equipment. Check often if the
moving parts are fixed, if any component is
damaged or any other condition that may
affect its proper functioning. If there is a
problem, make the repair before using the
equipment. Many accidents are caused by a
lack of adequate maintenance.
Keep the cutting disk clean and with the
cutting blades clean and sharp, with the
knife and counter-knife measurement
between 3 and 4 mm.
Keep the feeding rolls clean after using the
shredder and remove the leftover material
from the protection of the smooth roll. The
accumulation of material on the feeding
rolls hampers the operation of the hydraulic
engines that trigger the feeding rolls. Keep
the machine on for a few minutes after
finishing the job; this helps in the cleaning of
the shredder.
The cutting blade keeps moving after the
equipment is shut off. Therefore, be aware
of this when performing any maintenance
or cleaning.
Never use a pressurized water jet to clean the
machine, so to not damage the electrical
components. Also do not use chemical
cleaning products, avoiding the corrosion of
the material; only use neutral detergent and
moist cloth or compressed air.
Use the equipment and accessories
according to the instructions contained in
this manual, taking into account the work
conditions and the service to be performed.
The use of the equipment for operations not
included in this manual may result in
hazardous situations.
Turn the shredder off immediately if the
nozzle is clogged, if the cutting disk is locked,
or if you notice excessive vibration of the
machine. With the machine turned off and
the disk stopped, assess the situation and
unblock the outlet nozzle or the disk and
resume the work. If the problem persists,
contact a TRAPP Assistant.
