Trane GECA -006 Setup guide

GECA-SVX01B-EN

Models

“A” and later Design Sequence

60 HZ: GECA -006, -009, -012, -015, -018

50 HZ: GECA -006, -009, -012, -015

Installation

Owner

Diagnostics

AxiomTM Console Configuration

Water-Source Comfort System

Model GEC

General

Information

Introduction

The GECA water-source comfort system contains standard features to enhance performance, serviceability

and extend life of the equipment. Several of these features are shown below:

WATER

REGULATING

CONNECTION

WARNINGS / CAUTIONS

EXPLANATION:

Warnings are provided throughout

this manual to indicate to installing

contractors, operators, and service

personnel potentially hazardous

situations which, if not avoided,

COULD result in death or serious

injury.

WARNING

Cautions are provided throughout this

manual to indicate to installing

contractors, operators, and service

personnel potentially hazardous

situations which, if not avoided, MAY

result in minor or moderate injury.

CAUTION

GECA-SVX01B-EN 3

Contents

Installation/Startup/Commissioning

General Information 2

Pre-installation Checklist 4

Dimensions/Weights 5

Installation Instructions 19

Electrical Requirements 27

Pre-Startup Checklist 29

Startup/Commissioning

Sequence of Operation 31

Startup Checklist & Log 34

Maintenance

Warranty Information

Troubleshooting Checklist

Unit Wiring

4GECA-SVX01B-EN

Jobsite Storage

This unit is intended for indoor use

only. To protect the unit from damage

due to the elements, and to prevent

possible IAQ contaminant sources

from growing, the unit should be

stored indoors. If indoor storage is

not possible, the following provisions

for outdoor storage must be met.

1. Place the unit(s) on a dry sur-

face or raise above the ground

to assure adequate air circula-

tion beneath the unit. This is to

assure that no portion of the unit

contacts standing water at any

time.

2. Cover the unit(s) with a water

proof tarp to protect them from

the elements.

3. Make provisions for continu-

ous venting of the covered

units to prevent moisture from

standing on the unit(s) sur-

faces. Wet interior unit insulation

can become an amplification site

for microbial growth (mold) which

has been determined to be a

cause of odors and serious

health related indoor air quality

problems.

4. Store units in the normal UP

orientation. Storing units in this

manner maintains oil in the com-

pressor.

5. Units may be stacked two high.

Pre-installation

Checklist

Jobsite Inspection

Each unit has been inspected, tested

and operated at the factory by pro-

duction and quality associates prior

to being crated for safe transit. How-

ever, rough handling or accidents

can occur resulting in damaged

equipment being delivered. Always

perform the following checks before

accepting a unit:

1. Do not sign the bill of lading

accepting the unit(s) until

inspection has been com-

pleted. Check for damage

promptly after the unit(s) are

unloaded. Once the bill of lading

is signed at the jobsite, the unit(s)

are now the property of the SOLD

TO party and future freight claims

MAY NOT be accepted by the

freight company.

2. Check the unit model numbers

on the bill of lading against

those ordered and received to

assure equipment is AS

ORDERED.

3. Check to assure that the refrig-

erant charge has been retained

during shipment by use of

gauges. Schrader taps are

located and labeled internal to

the cabinet. (See Figure 1).

Figure 1: Schrader location

HIGH

LOW

IMPORTANT!

After assuring that charge has been retained:

Reinstall schrader caps to assure that refrigerant

leakage does not occur.

Reinstall unit panel using all factory provided

screws.

Notice

UNIT CONTAINS HCFC (R-22)

REFRIGERANT

INSTRUCTIONS!

SECTION 608, PARAGRAPH C OF THE 1990 CLEAN AIR ACT STATES:

EFFECTIVE JULY 1, 1992, IT SHALL BE UNLAWFUL FOR ANY PERSON, IN COURSE OF

MAINTAINING, SERVICING, REPAIRING, OR DISPOSING OF AN AIR CONDITIONING SYS-

TEM, TO KNOWINGLY VENT OR RELEASE ANY CFC OR HCFC REFRIGERANT. MINIMAL

RELEASES (AIR PURGES OF REFRIGERANT HOSES) ASSOCIATED WITH GOOD FAITH

ATTEMPTS TO RECAPTURE OR RECYCLE ARE EXEMPT FROM THE BAN ON VENTING.

Important!

Equipment is shipped FOB (Free on

Board) at the manufacturer. There-

fore, freight claims for damages

against the carrier must be initiated

by the receiver.

GECA-SVX01B-EN 5

Dimensions/

Weights

Unit

Size without Pallet with Pallet

60 HZ 50 HZ

Unit

Weight

(lbs)

Chassis

Weight

(lbs)

Unit

Weight

(lbs)

Chassis

Weight

(lbs)

006 - 188 140 218 170

009 006 192 144 222 174

012 009 204 156 234 186

015 012 203 155 233 185

018 015 210 162 240 192

Unit Clearance

Access to the unit for servicing purposes should be provided at installation. All configurations require clear-

ance from other mechanical and electrical equipment on three service sides (shown below). This enables

panel removal from the unit for service/maintenance ability.

6GECA-SVX01B-EN

Dimensions/Weights

Cabinet (RH) no Pump Kit

GECA-SVX01B-EN 7

Dimensions/Weights

Subbase (RH) no Pump Kit

8GECA-SVX01B-EN

Dimensions/Weights

Cabinet (LH) no Pump Kit

GECA-SVX01B-EN 9

Dimensions/Weights

Subbase (LH) no Pump Kit

10 GECA-SVX01B-EN

Dimensions/Weights

Cabinet (RH) Extended Length

This manual suits for next models

Table of contents

Other Trane Heat Pump manuals

Trane

Trane CGA Series Owner's manual

Trane

Trane GSSD Installation and operating instructions

Trane

Trane A4AC3018A Assembly instructions

Trane

Trane 5TTX5018 User manual

Trane

Trane GETB User manual

Trane

Trane 4TTR3018H User manual

Trane

Trane 4TTR3 User manual

Trane

Trane WFS-IR 1 Quick start guide

Trane

Trane CAUC-C20 Owner's manual

Trane

Trane A4AC4018A Assembly instructions

Trane

Trane 4TWR7 Assembly instructions

Trane

Trane GEHB018 User manual

Trane

Trane 4TWB4018G Assembly instructions

Trane

Trane LIFT 81-P Owner's manual

Trane

Trane 4TWX8 Assembly instructions

Trane

Trane 4TWR4 User manual

Trane

Trane Horizon OAKD Installation and operating instructions

Trane

Trane EXWA User manual

Trane

Trane WCP-IOM-1E Owner's manual

Trane

Trane 4TWB3018D Assembly instructions

Trane

Trane Axiom EXW Series Installation and operating instructions

Trane

Trane WCY024G1 Instruction manual

Trane

Trane A4HP5 User manual

Trane

Trane TAYPLUS103A Assembly instructions

Popular Heat Pump manuals by other brands

MICROWELL

MICROWELL HP 1000 GREEN Installation and user manual

Sanyo

Sanyo SAP120FCH Service manual

Daikin

Daikin EHYHBH05AA Operation manual

Panasonic

Panasonic WH-SDF03E3E5 Design handbook

Bryant

Bryant 544B Specifications

Airxcel

Airxcel 45000 Series Installation, operation and maintenance instructions

Mitsubishi Electric

Mitsubishi Electric PUZ-SWM60VAA Service manual

Dimplex

Dimplex LI 16I-TUR Installation and operating instruction

Carrier

Carrier WSHP Open v3 Integration guide

TGM

TGM CTV14CN018A Technical manual

Carrier

Carrier 38MGQ Series installation instructions

Kokido

Kokido K2O K880BX/EU Owner's manual & installation guide

Viessmann

Viessmann VITOCAL 300-G PRO Type BW 2150 Installation and service instructions

Carrier

Carrier 48EZN installation instructions

Viessmann

Viessmann KWT Vitocal 350-G Pro Series Installation and service instructions for contractors

Ariston

Ariston NIMBUS user manual

Weishaupt

Weishaupt WWP L 7 Installation and operating instruction

GE Zoneline AZ85H09EAC datasheet