Toyota Corolla E12-A User manual
**
E12
**
-A
AND **
E12
**
-D
Toyota Genuine Audio
INSTALLATION INSTRUCTIONS
FOR
TOYOTA MOTOR CORPORATIONManual Ref. n° AIM 000 164-1
Corolla (RHD)
Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 205-04
PRECAUTIONS
• Be sure to disconnect the negative (-) lead from the battery ter-
minals.
• Do not pinch the rear wiring or harness in the tightened part.
• When passing the wires through the bulkhead or other panels,
use a grommet to ensure waterproofing.
• Protect the wiring using tape when it is passed through a hole.
• When disconnecting the connectors, be sure to grip the con-
nector body. Do not tug on the wiring.
• Do not forcibly pull any car wiring harness. Rough tugging may
result in opened connections, or a broken wire or harness.
• Confirm that lamps, horn, wiper and other car accessories operate
normally.
• Protect your car using wing covers, seat and so on.
• Use the correct tool when tightening bolts or nuts.
• Before drilling a hole, check that the rear of the mounting wall
is clear.
• Be sure to firmly tighten connectors and terminals.
• Before connecting the power wiring to the battery, check the
wiring connections, harness, etc. to see that they are properly
secured.
• Check body and trim near area of installation to be certain no
dirt or scratches resulted from the installation.
PLEASE READ THOROUGHLY THESE PRECAUTIONS
BEFORE THE INSTALLATION
waterproof - O.K. !!
Grommet
Stop it !
Taping
Insert
completely
Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 305-04
TABLE OF CONTENTS
1. Application Chart......................................................................................................................................................... 4
2. System Layout ............................................................................................................................................................ 5
3. In-Dash 6CD Changer Installation............................................................................................................................... 7
4. Hide Away 6CD Changer Installation........................................................................................................................... 19
5. Tweeters Installation ................................................................................................................................................... 25
6. Subwoofer Installation ................................................................................................................................................ 30
audio apl chart mmc 04 corr.xls
Hide-Away CD-Changer TM0461(08601-00911) Navigation Sy tem TNS300 (08545-52801)
1CD-Tuner
(
onl
y)
Standard from factor
y
2CD-Tuner + CD-Chan
g
er Standard from factor
y
Standard from factor
y
.
(
1
)
3CD-Tuner + Navi
g
ation
(
TBT
)
Standard from factor
y
.
(
2
)
4CD-Tuner + CD-Chan
g
er + Standard from factor
y
.
(
2
)
Navi
g
ation
(
TBT
)
Standard from factor
y
.
(
1
)
.
(
2
)
5CD Chan
g
er-Tuner
(
onl
y)
Standard o
p
tional from factor
y
6CD Changer-Tuner + CD-Changer Standard optional from factory
Standard optional from factory . (1)
7CD Changer-Tuner + Navigation (TBT) Standard optional from factory . (2)
8CD Chan
g
er-Tuner + CD-Chan
g
er + Standard o
p
tional from factor
y
.
(
2
)
Navi
g
ation
(
TBT
)
Standard o
p
tional from factor
y
.
(
1
)
.
(
2
)
10 Head unit Standard o
p
tional from factor
y
Standard o
p
tional from factor
y
.
(
1
)
(
1
)
Located under the RH seat,
(
2
)
located under the LH seat
HEAD UNIT
In Da h CD-Changer TM 0561(08601-00907)
REQUIRED ADDITIONAL PARTS
+ ADD-ON UNIT(S)
COMBINATION
wire 08695-00370
-
F K 08695-02800 + wire 08695-00370
wire 08695-00370
F K 08695-02800 + wire 08695-00370
-
F K
(
PZ 425-E0336-60
)
+ wire 08673-64800 + wire 08673-64801
F K (PZ 425-E0336-60) + F K 08695-02800 + wire 08695-00370 + wire 08673-64801 +
wire 08673-64800
F K (PZ 425-E0336-60) + wire 08695-00370 + wire 08673-64801 + wire 08673-64800
F K (PZ 425-E0336-60) + F K 08695-02800 + wire 08695-00370 + wire 08673-64801 +
wire 08673-64800
AVN full map nav -system
F K (PZ 425-E0336-60) + wire 08673-64800 + wire 08673-64801
wire 08695-00370
F K (PZ 425-E0336-60) + wire 08695-00370 + wire 08673-64801 + wire 08673-64800
UDA (Un que Des gn Aud o)
F K 08695-02800 + wire 08695-00370
AUDIO APPLICATION CHART
TMME-CA ivision ev. ept. - 05May, 2004
Corolla **E12**-A and **E12**-D (LHD + RHD)
Subwoofer 08691-00834: On the floor, preferably under the RH seat (if free), under LH also possible (if free)
2. SYSTEM LAYOUT
Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 505-04
See Application Chart
6
HIDE-AWAY 6 CD-CHANGER
6
IN-DASH 6 CD-CHANGER
Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 6
05-04
See Application Chart
24
24
SUBWOOFER
TWEETERS
21
Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 705-04
IN CASE OF MANUAL AIR CONDITIONER
2.
a)
Remove the screw and control knob
.
: Screw (1x)
b) Remove the lower cluster panel .
: Clip (8x)
3
100
4
100
3. IN-DASH 6CD CHANGER INSTALLATION
1.
a) Remove the shift cover .
: Clip (6x)
b) Remove the ashtray .
2
1
Fig. 1
Fig. 2
Put the protective tapes on the shaded
areas. Be sure to remove the parts
carefully not to damage the section.
CAUTION
Fig. 3
IN CASE OF AUTO AIR CONDITIONER
3. Remove the lower cluster panel .
: Clip (8x)
3
Put the protective tapes on the shaded
areas. Be sure to remove the parts
carefully not to damage the section.
CAUTION
2
1
100
3
3
Nylon pry tool
Nylon pry tool
Nylon pry tool
4
Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 8
05-04
4.
a) Remove the centre cluster panel .
: Clip (4x)
: Screw (4x)
b) Remove the combo .
6
101
5
Fig. 4
6
5
101
5. Cut the tape (10 pieces).
Fig. 5
6.
a) Route and attach the changer wire
to the reinforcement pipe using tape
(2x) as shown.
b) Bundle up the excess changer wire
and attach it using tape (1x) as
shown.
1
2
1
2
Fig. 6
When installing the combo check that
the changer wire does not overlap the
the rear of the combo.
CAUTION
Excess wire Duct
1
2
1
Reinforcement pipe
Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 905-04
7. Route and attach the changer wire
using tape (1x) as shown.
1
2
Fig. 7
When installing the in-dash 6CD
changer check that the changer wire
does not overlap the rear of the 6CD
changer.
CAUTION
2
1
8.
a)
Connect the changer wire to the com-
bo using the conversion harness .
b) Refit the combo and centre cluster
.
: Clip (4x)
: Screw (4x)
101
5
6
34
6
2
Fig. 8
A conversion harness (P/N 08695-
00370) is needed for connection to the
audio unit.
34
NOTE
5
2
101
Reinforcement pipe
6
34
Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 10
05-04
9. Fit the spring nuts (2x).
40
Fig. 9
Slightly expand the spring nuts and
install them gently.
CAUTION
40
40
This manual suits for next models
2
Table of contents
Other Toyota Car Receiver manuals
Toyota
Toyota RAV4 (LHD) User manual
Toyota
Toyota Aygo LHD User manual
Toyota
Toyota Avensis RHD User manual
Toyota
Toyota RSE User manual
Toyota
Toyota 00016-00950 User manual
Toyota
Toyota CQ-VS8180A User manual
Toyota
Toyota CQ-VS8380A User manual
Toyota
Toyota AUDIO 1-DIN User manual
Toyota
Toyota 08601-00911 User manual
Toyota
Toyota Solara 2005 User manual
Toyota
Toyota CQ-LS8180A User manual
Toyota
Toyota Ice User manual
Toyota
Toyota Premium ICE User manual
Toyota
Toyota Display Audio system User manual
Toyota
Toyota CQ-ES7880AZ User manual
Toyota
Toyota Audio 2001 Avensis Verso User manual
Toyota
Toyota Auris TAS200 2012 User manual
Toyota
Toyota CQ-ES0360A User manual
Toyota
Toyota PC601-00027 User manual
Toyota
Toyota JBL Premium sound User manual
