SAFETY GUIDELINES
3TDS-200CL
• Always wear safety glasses complying with
OSHA/ANSI requirements Z87.1.
• Wear a mask or respirator when dust is
generated.
• Keep bystanders out of the work area while
operating the tool.
• Always ensure that the work area is clear of
any flammable materials, liquids or gasses,
because the use of this tool may create sparks.
•Wheel guards and eye shields must be properly
adjusted and tightened.
• During each start-up, stand to one side of
the grinder and switch it on. Let the grinder
operate at full speed for approximately one
minute so that any undetected flaws or cracks
will become apparent.
• Use only 40 W (max.) bulbs on the work light.
• Use only 8” wheels suitable for 3450 RPM
or over.
• Keep guards in place and working properly.
• Keep hands clear of grinding wheels.
•Always make sure wheels are properly mounted.
• Secure the tool when working to prevent
unexpected movement.
• Never reach behind or beneath the grinding
wheels.
• Unplug from power supply before adjusting
or servicing. The grinding wheels continue
to rotate after the tool is switched off. Always
allow wheels to stop before adjusting or
servicing.
• To avoid electric shock, DO NOT use in damp
conditions or expose to rain.
Failure to observe any of the following
instructions could result in severe
personal injury to tool user and bystanders
or cause damage to tool and property!
Read, understand and observe all
instructions in this manual before
using or operating the tool for which
it is written and supplied. Ensure that
anyone who is to use the tool has read
and understood the instructionsprovided.
•When fitting a new grinding wheel, always
check that the stated maximum RPM meets
or exceeds that stated on the grinder. Also
check the new wheel for damage, such as
flaws or cracks. If the wheel appears
satisfactory, fit it to the grinder.
• When a new grinding wheel has been
fitted, stand to one side of the grinder and
switch it on.
Let the grinder operate at full speed for
approximately one minute so that any
undetected flaws or cracks will become
apparent.
• Use only accessories that are recommended
by the manufacturer for your model.
•DO NOT attempt to cut anything with the
grinding wheel.
• Grounded tools must be plugged into an outlet
that has been properly installed and grounded
in accordance with all local codes and ordinances.
Never remove the grounding prong from the plug
or modify it in any way. Do not use adaptor plugs.
If in doubt as to whether the outlet is properly
grounded, consult a qualified electrician.
• Do not use the tool when tired or under the
influence of drugs, alcohol or medication.
• Do not wear gloves, neckties, jewellery or loose
clothing when using tool. Keep hair tied back.
• Ensure the power switch is off prior to plugging
in the tool.
Replace cracked grinding wheels
immediately.
• Do not overtighten spindle nuts.
• Spacing between tool rests and wheels should
be set to 1/8” or less; hold workpiece firmly
against tool rest.
• Service on thesetools should only be performed
by an authorized, qualified technician.
• Failure to comply with these warnings may
result in serious personal injury.
• There is a risk of injury due to accidental starting;
do not use this tool in an area where children
may be present.
