Total TGT11316 User manual
TGT11316
UTGT11316
1400W
HIGH PRESSURE
WASHER
SCAN FOR VIDEO
totaltoolsworld
TOTAL TOOLS WORLD
SAVE THESE INSTRUCTIONS
Please read and comply with these
original instructions prior to the initial operation
of your appliance and store them for later use or
subsequent owners.
Apart from the notes contained herein the
general safety provisions and rules for the
prevention of accidents of the legislator must be
observed.
Warnings and notes that are attached on the
appliance provide important notes for the safe
operation.
Hazard levels
DANGER
Pointer to immediate danger, if not avoided,
which leads to severe injuries or death.
WARNING
Pointer to a possibly dangerous situation, if not
avoided, which can lead to severe injuries or
death.
CAUTION
Pointer to a possibly dangerous situation, if not
avoided, which can lead to minor injuries.
ATTENTION
Pointer to a possibly dangerous situation, which
can lead to property damage.
Electric components
DANGER
Risk of electric shock.
Never touch the mains plug and the socket with
wet hands.
Check the power cord with mains Plug for
damage prior to every use. Do not use the
machine if a supply cord or important parts of
the machine are damaged, e.g. safety devices,
high pressure hoses, trigger gun.
All current-conducting parts in the working area
must be protected against jet water.
The mains plug and the coupling of an
extension cable must be watertight and must
never lie in water. Moreover, the coupling may
never lie on the ground. The use of cable reels
that ensure that the sockets are at least 60 mm
above the ground is commended.
IMPORTANT SAFETY INSTRUCTIONS
2
Make sure that the power cord or extension
cable is not damaged by running over, pinching,
dragging or the like. Protect the power cords
from heat, oil, and sharp edges.
Always switch off the mains disconnecting
switch when leaving the appliance unattended.
WARNING
The appliance may only be connected to an
electric supply that has been installed by an
electrician in accordance with IEC 60364.
The appliance may only be connected to
alternate current. The voltage must correspond
with the type plate of the appliance.
For safety reasons, we recommend that you
operate the appliance only via a residual
current device (max. 30mA).
An unsuitable electrical extension cable can be
hazardous. Only use an electrical extension
cable which has been approved and labeled for
this purpose and has an adequate cable
cross-section outdoors: 1 - 10 m: 1.5 mm2;10 -
30 m: 2.5 mm2
Always fully unreel the extension cable from the
cable drum.
An unsuitable electrical extension cable can be
hazardous.
Safe handling
DANGER
The user must be the appliance as intended.
The person must consider the local conditions
and must pay attention to other persons in the
vicinity when working with the appliance.
Check important components, such as high
pressure hose, hand spray gun and safety
installations, for damage prior to every
operation. Immediately replace damaged
components. Do not operate appliance with
damaged components.
The appliance has been designed for use with
the cleaning agent supplied or recommended
by the manufacturer. The use of the other
cleaning agents or chemicals may adversely
affect the safety of the appliance.
High-pressure jets can be dangerous if subject
to misuse. The jet must not be directed at
persons, live electrical equipment or the
machine itself.
Do not direct the jet against yourself or others in
order to clean clothes or foot-wear.
Do not use the appliance within range of
persons unless they wear protective clothing.
Wear appropriate Personnel Protection
Equipment (PPE) while operating the
appliance.
Do not direct the jet against yourself or others in
order to clean clothes or foot-wear.
WARNING
3
The appliance must not be operated by children
or untrained personnel.
This appliance is not intended for use by
persons(including children) with reduced
physical, sensory or mental capacities, or
lacking experience and knowledge.
Children must not play with this appliance.
Supervise children to prevent them from playing
with the appliance.
Create stability for the appliance prior to any
work on or with the appliance to prevent
accidents damage.
The water jet that is emitted from the high
pressure nozzle results in a repulsion power
acting on the hand spray gun. Make sure that
you have a firm footing and are also holding the
hand spray gun and spray lance firmly.
Never leave the appliance unattended as long
as it is in operation.
ATTENTION
In case of extended breaks, switch the
appliance off at the main switch or pull the
mains plug.
Do not operate the appliance at temperatures
below 0ºC
Other risks
DANGER
The appliance may not be operate in explosive
atmospheres.
Risk of explosion-Do not spray flammable
liquids.
Never draw in fluids containing solvents or
undiluted acids and solvents! This includes
petrol, paint thinner and heating oil. The spray
mist is highly inflammable, explosive and
poisonous. Do not use acetone, undiluted acids
and solvents, as they corrode the materials
used on the appliance.
Never use the product with inflammable or toxic
liquids, or liquids with characteristics
incompatible with its proper operation.
Keep packaging films away from children, there
is a risk of suffocation!
WARNING
According to applicable regulations , the
appliance must never be used on the drinking
water net without a system separator. Ensure
that the connection of your building water
installation on which the high pressure cleaner
is operated is equipped with a system separator
pursuant
Water that has flown through backflow
preventers is considered to be non-potable.
High-pressure hoses, fittings and couplings are
important for the safety of the appliance. Only
use high-pressure hoses, fittings and couplings
recommended by the manufacturer.
4
To ensure applicable safety, use only original
spare parts from the manufacturer or approved
by the manufacturer.
Switch the product off and disconnect it from
the power supply removing the power plug from
the socket outlet before assembly,
cleaning ,adjustments, maintenance, storage
and transportation or converting the product to
another function.
CAUTION
Mind the weight of the appliance when selecting
the storage location and during transport to
prevent accidents or injuries.
Several hours of continuous use of the
appliance can lead to numbness in the hands in
rare cases.
→Wear gloves.
→Keep hands warm.
→Take breaks at regular intervals. Working with
detergent
WARNING
The improper use of detergents can cause
severe injuries or oxidation.
Store cleaning agent away from the reach of
children.
Discharge residual pressure before
disconnecting the hose from the product.
Check before each use , and at regular intervals,
that all metal fasteners are tight and the
product’s components are in good condition;
inspect for broken or worn parts.
Be aware of kick-back: Hold With Both Hands.
Residual risks
Even if you are operating this product in
accordance with all the safety requirements,
potential risks of injury and damage remain.
The following dangers can arise in connection
with the structure and design of this product:
Health defects resulting from vibration emission
if the product is being used over long periods of
time or not adequately managed and properly
maintained.
Danger of injury and property damage caused
by flying objects.
Injuries and damage to property due to broken
accessories or the sudden impact of hidden
objects during use.
5
Safety Devices
CAUTION
Safety installations serve the protection of the
user and may not be modified or by past.
Power switch
The appliance switch prevents unintentional
operation of the appliance.
Lock trigger gun
This lock locks the lever of the trigger gun and
prevents the inadvertent start of the appliance.
Overflow valve with.
Water that has flowed through backflow
preventers is considered to be non-potable.
Pressure switch
If the lever on the trigger gun is released the
pressure switch turns off the pump, the high
pressure jet is stopped. If the lever is pulled the
pump is turned on again.
Motor protection switch
The motor protection switch off the device if the
power consumption is high.
Personal protective equipment
CAUTION
Wear protective clothing and safety goggles to
protect against splash back containing water or
dirt.
During the use of high-pressure cleaners
aerosols can develop. Inhaling aerosols can
cause health damage.
—Depending on the application, completely
shielded nozzles(e.g. surface cleaner)that
significantly reduce the emission of aqueous
aerosols can be used for high-pressure
cleaning.
—The use of such shielding is not possible with
all applications.
Symbols on the machine
The high pressure jet must not
be directed at persons, animals, live electrical
equipment or at the appliance itself.
The appliance must not be directly
connected to the public drinking water network.
For protection against injury, wear ear
defenders and safety goggles.
Wear safety gloves during use to
protect hands
Wear non-slip footwear that will
protect your feet and improve your footing on
slippery surfaces.
Sound power level is 92dB(A)
6
Proper use
Use this pressure washer for private
households only:
If connection is made to a potable water system,
the system shall be protected against backflow.
This high pressure cleaner is designated with a
rated input current. The intended use of this
product covers the cleaning of vehicles,
buildings, terraces, facades and garden
equipment using clean water and
biodegradable chemical detergents. Likewise
the product can be used to clean paving slabs
or rain gutters.
This product may not be used to clean clothing,
shoes and other textiles. The water jet should
not be directed against persons. Animals, any
electrical equipment or on the product itself. Do
not flush any objects which contain health
hazardous materials. The product must not be
run with inflammable, explosive and toxic
liquids.
For safety reasons it is essential to read the
entire instruction manual before first operation
and to observe all the instructions there in.
Description of the Appliance
1. Handle
2. Power cord hook
3. Adjust switch OFF/ON
4. Power cord
5. Water outlet Front case
6. Spray wand
7. Trigger gun /Spray wand holder
8. Water inlet
9. High-pressure hose
10. Trigger gun
7
Technical specifications
Voltage 220-240V～
Frequency 50/60Hz
Watt 1400W
Degree of protection IPX5
Rated pressure 70bar(1000psi)
Allowable pressure 130bar(1900psi)
Rated flow 5.5L/min
Assembly
Mount loose parts delivered with appliance prior
to start-up.
1.Slid the power cord hook
2. Installing the spray wand
• Fit the spray wand into the gun and rotate it
until the two parts are completely locked.
3. Connect the high pressure hose to the
trigger gun
• Connect the sliver end of the high-pressure
hose to the trigger gun and twist the nut as
indicated to secure the connection.
8
TGT11316
Voltage 110-120V～
Frequency 60Hz
Watt 1400W
Degree of protection IPX5
Rated pressure 70bar(1000psi)
Allowable pressure 130bar(1900psi)
Rated flow 5.5L/min
UTGT11316
4. Connect the high-pressure hose to the
water outlet
Connect the other end of the high-pressure
hose to the water outlet on the washer and twist
the black rotatable end-piece as indicated to
secure the connection.
5. Connect the garden hose to the water
inlet
Connect the garden hose adaptor(female
coupler) to the water inlet of the pressure
washer, then thread your garden hose(male
end) into the garden hose adaptor.
Start up
Park the appliance on an even surface.
Insert the mains plug into the socket.
Water supply
For connection values, see type plate.
ATTENTION
Impurities in the water can damage the
high-pressure pump and the accessories.
Water supply from mains
Drawing in water from the open reservoirs
This high-pressure cleaner is suited to work
with the YILI suction hose with backflow vale to
draw in surface water, e.g. from water butts or
ponds.
Fill the suction hose with water.
Screw the suction hose into the water
connection of the appliance and insert it into the
water source (e.g. rainwater drum).
Bleed the device as follows prior to operation:
9
• Turn on the appliance “OFF/ON”
• Unlock the lever of the trigger gun.
• Push the lever of the trigger gun, the device
will switch on.
• Let the device run (max. 2 minutes) until the
water exits the trigger gun without bubbles.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
Operation
ATTENTION
Dry running of more than 2 minutes leads to
damage of the high-pressure pump. If the
appliance does not build up pressure within 2
minutes, switch the appliance off and proceed
in accordance with the instructions in Chapter
“Troubleshooting”
High pressure operation
CAUTION
Keep a distance of at least 30 cm when using
the jet for cleaning painted surfaces to avoid
damage.
CAUTION
Make sure the on/off switch is set to “OFF/O”
and insert the plug into a properly installed
socket.
ATTENTION
• The washer must be used on a secure and
stable surface in a standing, upright position
Connect the product to power and water supply
as described.
• Open the water supply
• Hold the spray gun with both hands.
• Direct the nozzle of the chosen accessory
away from you towards the surface to be
cleaned.
• Unlock the trigger and press it until a constant
amount of water flows through the nozzle, to
allow air trapped in the hose to escape.
• Release the trigger.
• Turn on the switch “OFF/ON”,.
10
This manual suits for next models
1
Table of contents
Other Total Pressure Washer manuals
