7. Points for attention and safety norms
7.1 The operators must put on the work clothes, safety shoes and gloves during the operation。
7.2 The trucks should be locked in order to prevent moving。
7.3 When the truck is used for the motor vehicle, the truck must be moved slowly to ensure
safety
7.4 Do not park the truck on the slope or in emergency passageway
7.5 Should make operation carefully when used on the slope and make sure to operate on the
top of the slope.
7.6 Put the forks to the lowest place when parking。
7.7 Not allow to park in a place which block traffic or influence on working.。
7.8 Not allow to use in a rainy circumstance。
7.9 It is forbidden for the operator to sit or stand on the hand pallet truck to operate the truck
6.10 Not allow to turn on slope.
7.10 Not allow to turn on slope
7.11 Do not pile the cargo too high in order to prevent the goods from falling down or
overturning of the truck。
7.12 Do not use the hand pallet truck to carry people。
7.13 Untrained personnel are not allowed to stand around the operation area in order to avoid
injury caused by sudden malfunction。
7.14 Before the hand pallet truck is pushed into the elevator, the operator shall make sure that
the elevator can bear the total load of hand pallet truck and cargo as well as the total weight of
the operator and other personnel in the elevator. When entering the elevator, people should let
the load enter first but not operator. When the load or hand pallet truck enters or leaves the
elevator, other personnel should not stay in the elevator.
7.15 The hand pallet truck should be stored in dry and ventilated environment.
8. Check up before using
If the hand pallet truck is not used for a long time, air may get into the hydraulic system. Due to
this, the trouble can be eliminated by the following method:
Set the handle to the lower position. Shake the handle four to six times then let go. May
repeat above procedures for several times if necessary。
9. Loading type and rated weight
The ideal loading type is that the gravity center of the cargo is just in the middle of the truck
forks. The rated weight must be reduced when the cargo gravity center is not in the middle of
the truck forks. The rated weight is shown as the label.。
10.Oil
The oil capacity which oil pump needs is about 250ml(or 0.25kg).According to the ISO oil
criterion ,the choice of oil is 32# when the environment temperature during-5~40℃。
11. Care and Maintenance
Normal check everyday and getting rid of unusual phenomenon. Don’t use faulted trucks
in order to increase the service life. Should ask the professional person to repair if has faults.
