3
INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
• Caution: Do not use any power supply other than the one supplied with your genuine Reef Flow
2.0 pump.
• The use ofa different power supply will invalidate the guarantee.
• Always isolate the PSU from the mains electricity before installing orcarrying out any maintenance
to the pump. Caution: Reef Flow 2.0 controller is not waterproof and therefore must not be
mounted above the aquarium orsump,or in any position where it may accidentally fall into water or
be splashed by water,or in a humid environment.
• Only use the correctly-rated controller supplied with the pump, e.g the Reef Flow 2.0 8000
Controllerwith the Reef Flow 2.0 8000 pump.
• A label on the back of the controller denotes which pump it is designed for. Using the wrong
controllerwith the wrong pump will invalidate the guarantee.
• Powerto the pump must be supplied through a Residual Current Device (RCD) with a rated residual
operating current not exceeding 30mA.
• Neveroperatethe pump withoutwaterinside the impellerchamberorwithliquids at atemperature
higher than 95F/35C.
• To ensure the pump continues to maintain a steady water flow, it must be cleaned regularly to
ensure it does not become clogged with debris ordetritus.
• Do not operate any appliance if it has a damaged cord orplug, ifit is malfunctioning, or ifit has been
dropped ordamaged in any way.
• This unit is designed to be used indoors and is not suitable for any outdoorapplications.
• Ensure the ReefFlow 2.0 pump is securely installed before operating.
• Always leave a drip-loop in the pump cable to prevent water running down the cable and reaching
the controllerand powersource (see diagram below).
3
DISPOSE OF THIS UNITRESPONSIBLY
Check with your local authority for disposal information.
