MAKO Series LED Area Light
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
IMPORTANT INSTALLATION INFORMATION
1.Before commencing installation or maintenance, ensure
electricity is switched off at the mains. Installation or
maintenance should be carried out by a qualified electrician.
2.The luminaire must not, under any circumstances, be installed
directly to flammable materials, and luminaires must not be
covered with any flammable materials.
3.Mounting height range of 3 meters to 6 meters, this model is
suitable for outdoor lighting.
4.Ensure there is adequate free air circulation of at least 50cm
around the luminaire. All luminaires run hot. It is the installer's
responsibility to consider fire risk and take appropriate
precautions.
3
1 2
4
Installation Instruction & Installation Steps
STEP 2:
1.When the pole is inside the spigot, fasten the screws.
STEP 1:
1.Loosen the M10 screws on the spigot with a wrenc h.
2.Insert the pole into the middle hole of spigot till to the end.
Screws
Pole
LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER
FOR FUTURE REFERENCE
5
STEP 4:
1. Get mains power supply cord into led driver compartment via
cable gland.
2. Lock the gland to mains power supply cord tightly.
3. For more details about wiring,please refer to the wiring instruction,
See Figure 6.
4. This Mako has 2 output options, and is set to 40W/5500 lm as
standard with the nominal output switch pointing at digit 0.To adjust
the Mako to the lower output 30W/4000 lm, adjust the nominal
output switch to point at digit 1 which will lower the drive current
and output.The output can be restored to 40W/5500 lm by
returning the switch back to digit 0.
502.5mm
200mm 71mm
STEP 3:
1. Loosen locking bolts and open the cover.
STEP 5:
1. Fasten the locking bolts on the cover tightly.
Screws
Locking bolts
Cover
Locking bolts
0°
Mains power supply cord
Bubble level
Cable gland
5500lm/4000lm Switch
by
