Installation Manual of Inverter Type Household Air Source Heat Pump Chiller (Heat Pump)
2
II. Must-read for Users
Read the Installation & Operation Manual thoroughly before installing and using the equipment and keep it for
future reference.
● Only TICA authorized personnel can install TICA air to water heat pump chiller. The installation must comply
with the requirements of the company. TICA assumes no liabilities for losses arising from improper operations,
including but not limited to pipe leakage, electric leakage and adverse effect or damages on the equipment.
● Reserve enough space for equipment installation strictly in accordance with the Manual. Otherwise, the heat
exchange effect may be compromised.
● Install a residual current device between the power supply and the equipment.
● When the equipment is available for commissioning upon installation, call TICA's hotline to request equipment
commissioning service. The equipment is usable only after a commissioning test is done. TICA assumes no
liabilities for any losses arising from unauthorized access to the equipment.
● The equipment shall undergo regular maintenance and servicing after it is installed. In case of an abnormality,
stop using it immediately and call TICA's hotline to report such event.
● Do not put your finger or other objects into a running equipment as it may cause personal injuries.
● If any parts are soaked in water, contact TICA's personnel to check or repair it before use again.
● Never drink or use the water in the unit for daily lives.
● All the circuits must be dedicated. The unit must be reliably grounded.
● Contact a qualified electrician to check electricity meter, circuit breaker and wire diameter to make sure that
they meet the maximum operating current requirement.
● If the ambient temperature is lower than 5°C and a power failure occurs, be sure to thoroughly drain water
from the unit and pipeline. If the ambient temperature is lower than 5°C and the water system is fully filled with
water, ensure that the unit is in the power-up state, and the chilled water circulating pump of the air conditioner
is interlocked with the unit. In this way, the unit can automatically control the water pump operation or heating
operation, thereby implementing automatic anti-freezing protection of the air conditioning water system. The
purpose is to protect facilities such as the unit and water pipeline against damage caused by freezing of water in
the pipeline of the air conditioning water system. When the unit is energized, the unit may consume a certain
amount of electricity to prevent it from freezing.
●The unit is prohibited from using open water systems.
● TICA assumes no liabilities for any losses arising from commissioning, maintenance or servicing by
unauthorized personnel or from using the equipment other than the purposes contained within this Manual.
● If the power cord is damaged, to avoid dangers, make sure to ask a professional from the manufacturer or its
maintenance department or similar department to replace it.
● Nanjing TICA Climate Solutions Co., Ltd. reserves the right to interpret this Manual.
Caution: Failure to observe this Manual may cause fire, losses, personal injury or
even be fatal.
