2
To Remove the Oven Door
1. Fully open the oven door.
2. Raise the U-clip over the hook on each of the
hinges to the“locked” position (see illustration
below). This will prevent the hinge from snap-
ping closed when the door is removed.
3. Grasp the door by the sides toward the back.
Raisethefrontofthedoorseveralinches(there
will be some spring resistance to overcome be-
causeofthe hinge being locked).Whenthefront
of the door is high enough, you will be able to
lift the hinges to clear the indents.
4. Pull the hinges out of the slots in the oven front
frame.
WARNING
Turn of the electrical power circuit to the
oven at the main junction box, before
servicing this unit.
WARNING
With the door off, never release the levers
and try; to close the hinges. Without the
weight of the door,the powerful springs will
snap the hinges closed with great force.
FIGURE 1.
Raise Clip to“Locked Position
to Remove Door
Lower
Clip
After
Door is
Replaced
HingeArm
Latch Hinge
THESE KITSWILL BE COMPRISED OFTHE FOLLOWING:
Quantity Description Part Number
1 UpperVentTube 16-10-058
1 LowerVentTube 16-10-059
2 Insulation 14-38-692
2 Templets (Inside of Instructions)
8 Screws 14-91-102
1 Kit Instructions 96-93-563 RevA
1 Bracket Blower Mounts 14-38-482-01
NOTE: THE OVENWAS SHIPPEDWITHTHETHERMOSTAT ADJUSTEDAT +25 DEGREES.
WITH THE NEW UPWARD VENT,THE OVEN NEEDS TO BE CALIBRATED TO ZERO.
INSTRUCTIONS,TAKEN FROMTHE CARE AND USE MANUAL,ARE FOUND ON PAGE 20
OFTHIS PUBLICATION.
CAUTION
When you work on the oven, be careful
whenhandlingthesheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
TO CONVERTTHE UPPER OVEN CELL
REMOVE OVEN FROMWALL:
1)TURN OFF ELECTRICITYAT CIRCUIT BREAKER.
2) REMOVE MOUNTING SCREWS FROM CABINET.
3) DISCONNECT ELECTRICAL CONNECTIONS.
4) REMOVE OVEN DOORS. Figure 1.
5) REMOVE OVEN FROMWALLAND PLACE ON DOLLY OR PROTECTED FLOOR.
