TensCare nouri auto User manual
1
User Manual
Manual del usuario
Mode d’emploi
Benutzerhandbuch
Manuale d’uso
2
Contents
Introduction 3
Kit Contents 3
Pump Parts 3
Cleaning and Sterilising 4
Installation Guide 6
Pump Controls and Display 7
Pumping with Nouri Auto 7
Storing Breast Milk 9
Preparing Breast Milk 9
Power Supply 10
Feeding Breast Milk 10
Charging your Nouri Auto 10
When to start using Nouri 11
Troubleshooting 11
Warranty 12
3
Introduction
Kit Contents
Pump Parts
Nouri Auto is an automatic breast pump, designed to make breast pumping
quick and easy. The pump offers a variety of suction levels and modes
alongside its soft breast shields. Nouri Auto includes an integrated light,
allowing you to pump day and night in complete comfort.
1 x Electric pump
2 x Bottle (150ml)
1 x Feeding teat and cap
1 x Diaphragm
1 x Tube
1 x Breast Shield
1 x Shield cover
1 x Shield connector
1 x Bottle cap
1 x USB cable
1 x Bottle dock
2 x Bottle valve
1 x Diaphragm cap
Electric Pump
Tube
Teat Cap
Teat
Breast Shield
Bottle Valve
Diaphragm
Cap
Diaphragm
Shield
Connector
Bottle
4
Cleaning and Sterilising
Before using for the rst time
Clean and sanitise the below parts before using your Nouri Auto for the rst
time. Use the following cleaning and sanitising instructions.
• Breast shield
• Shield connector
• Bottle Valve and Valve membrane
• Bottle
After each use:
Clean all parts that come in contact with your breast and breast milk.
• Separate all parts, remembering to remove the clear membrane from the
bottle valve
• Rinse the parts in cool water to remove breast milk residue.
Washing in sink:
• Soak all parts in warm soapy water for 5 minutes and then clean with a
clean dish-cloth or soft brush.
• Rinse all parts that come in contact with your breast and breast milk with
clear water.
• Allow parts to dry.
Washing in dishwasher:
• Wash all separated parts on the top rack of the dishwasher.
• Allow all parts to dry.
Sanitise daily:
• Wash hands thoroughly.
• Separate all parts that come in contact with your breast and breast milk,
remembering to remove the clear membrane from the bottle valve
• Immerse parts in boiling water for 10 minutes using a household pot.
• Allow water to cool before removing parts from the water.
• Place parts on a clean surface and/or towel and allow to dry.
Tubing and Electric Pump Unit
• Turn off the breast pump
• Unplug the pump from any power source.
5
• Separate the tube from the pump and bottle.
• Wipe the electric pump unit and tube with a clean, damp cloth.
Caution:
Only use drinking tap water or bottled water for cleaning.
Separate and wash all parts that come in contact with the breast and milk
immediately after use to avoid milk residue drying and to prevent bacteria
growth.
Do not store wet or damp parts.
During sanitising with boiling water, prevent the parts from touching the side
of the pot. This can cause the parts to deform or be damaged.
Nouri is for single person use. To avoid contamination, please do not share
the pump.
Note:
Wash the Nouri Auto parts that come in contact with the breast and breast
milk after every use.
Sanitise the Nouri Auto parts that come in contact with the breast and
breast milk once a day.
Be careful not to damage parts during cleaning.
6
2. Insert the bottle
valve into the shield
connector.
3. Insert the
diaphragm into the
top of the shield
connector.
4. Attach the
diaphragm cap on
top of the diaphragm
with the tube insert
positioned roughly
135° from the shield
connector thread.
5. Turn the diaphragm
cover 45° clockwise.
6. Screw the bottle into
the shield connector
assembly.
7. Attach the breast
shield to the shield
connector.
8. Connect the bottle to
the electric pump by
inserting the tube rmly
onto the diaphragm cap
and pump unit or insert
the diaphragm cap
directly into the pump.
Installation Guide
1. Wash your hands
thoroughly with
soap and water.
7
1. Wash your hands
thoroughly with
soap and water
and make sure that
your breast is clean.
2. Place the breast
pump onto your
breast. Make sure
that you centre your
nipple.
3. Turn on the
Nouri Auto. Note
pumping will start
automatically so
make sure the
breast is positioned
correctly before
switching on the
pump.
Pump Controls and Display
Massage
mode Battery level
indicator
Night light
Expression
mode
Power
indicator
Rapid
mode
Pumping with Nouri Auto
8
7. Stop pumping
when the milk stops
owing or when the
bottle is full.
8. Remove the electric
pump unit (and
tube) from the
bottle assembly.
9. Unscrew the bottle
from the shield
connector. Use
the bottle cap
to seal the bottle
for storage or the
feeding teat for
feeding.
4. When turning on,
massage mode
will begin. Use
the increase and
decrease buttons to
nd a comfortable
suction level.
5. After 2 minutes,
expression mode
will automatically
begin. Again, select
a comfortable
suction level using
the increase and
decrease buttons.
6. For a faster
expression, switch
to rapid mode
by pressing and
holding the mode
switch button for 2
seconds.
Note:
• The pump will run for 30 minutes before automatically turning off. A single
expression should not last longer than 20 minutes.
• To return to expression mode from rapid mode, press and hold the mode
switch button for 2 seconds. To switch between massage mode and
expression mode, press the mode switch button. Massage mode cannot
be accessed from rapid mode.
• Night light has 2 brightness settings. Press the light button to cycle between
OFF, low brightness and high brightness.
9
Cautions
• As shown in the illustration, your nipple should be positioned centrally in
the breast shield. Incorrect positioning may cause irritation or frictional
pain.
• Volume of feeding bottle is 150ml. If milk volume is estimated to be more,
please use a second bottle.
• If you feel pain or discomfort, stop using the pump and refer to the
Troubleshooting section of this manual.
Storing Breast Milk
Storage location Temperature Max. storage duration
Room 16-29 0C (60-85 0F) 4 hours
Refrigerator 4 0C (39 0F) 4 days
Freezer <-4 0C (25 0F) 0-6 months
Warning:
• Do not refreeze thawed milk.
• Do not mix fresh breast milk with thawed milk.
Note:
• Fresh breast milk should be stored in refrigerator or freezer.
• Be sure to date the milk for storage.
• When freezing, maximum milk volume should be ¾ of storage bottle. Milk
can expand during freezing.
Preparing Breast Milk
• If the milk is refrigerated, put the milk container in warm water to heat the
milk. Shake the container to warm the milk through.
• If the milk is frozen, defrost in the refrigerator 24 hours prior to using. Once
defrosted, warm it as refrigerated milk.
Using milk heater:
Turn on milk heater and set it to 400C. Put milk container into heater.
Layers of liquid may for when using frozen milk. This is normal. Please shake
bottle well before feeding.
The above only applies for infants one month of older. Please consult a
doctor for more details.
10
Power Supply
Input: AC100-240V (50/60Hz) 0.2A
Output: 5V/1A
Built-in lithium ion battery: 3.7V/850mAh
Warning:
• Do NOT use a USB charging cable other than the cable provided.
Warning:
• Do not heat thawed milk again.
• Do not use microwave oven to defrost breast milk.
• Do not heat milk with boiling water.
• If hot water is used to heat milk, please try milk temperature before
feeding.
Feeding Breast Milk
It is recommended that breastfeeding is well established prior to bottle
feeding your baby.
• Always inspect the bottle, teat and other parts before and after each use.
If the teat appears cracked or torn, stop using immediately.
• To prevent possible choking hazard, test the strength of teat by pulling on
bulb portion of the teat.
• Do not attempt to enlarge the teat hole.
• Infants must not be bottle fed without adult supervision.
• The teat should not be used as a pacier.
• Clean and disinfect the bottle before rst use and after every use.
Charging your Nouri Auto
To charge the Nouri Auto, connect the USB charging cable to the pump and
a power socket. The charging indicator and battery level will show on the
display.
When fully charged, the battery indicator will stop ashing and show a full
battery.
The Nouri Auto can be used during charging if needed.
The battery has a charge time of 2 hours and will last for 70 minutes before
needing to be recharged.
Table of contents
Languages:
Other TensCare Breast Pump manuals
