Technoline WS6825 User manual

WS6825 - INSTRUCTION MANUAL

LED WEATHER STATION WITH RADIO CONTROLLED CLOCK AND ALARM

Words in the figure:

ENGLISH

OTHER LANGUAGE

Front view

ALARM ON

TIME

RCC INDICATOR

INDOOR TEMPERATURE

OUTDOOR TMEPERATURE

WEATHER FORECAST

Back view

SNOOZE/DIMMER

UP/RF

SET

ALARM

DOWN/WAVE

RESET

AC/DC ADAPTOR

DC SOCKET

INSERT AC/DC

ADAPTOR JACK

STAND HOLE

INSERT 1 x CR2032

BATTERY INSIDE THE

BATTERY COMPARTMENT

BATTERY DOOR

HANGER HOLE

OUTDOOR TEMPERATURE SENSOR

LED

RESET

STAND

CHANNEL 1

CHANNEL 2

CHANNEL 3

INSERT 2 x AAA BATTERIES

ENVIRONMENTAL RECEPTION EFFECTS

The weather station obtains the accurate time with wireless technology. Same as all wireless devices,

the reception is maybe affected by the following circumstances:

Long transmitting distance

Nearby mountains and valleys

Among tall buildings

Near freeway, railway, airports, high voltage cable etc.

Near construction site

Inside concrete buildings

Near electrical appliances (computers, TV’s, etc)

Inside moving vehicles

Near metallic structures

Place the station at a location with optimal signal, i.e. close to a window and away from metal surfaces

or electrical appliances.

QUICK SETUP

Step 1 Keep the station and outdoor sensor next to each other. Slide open the battery cover at the

back of the outdoor sensor. Make sure the channel selector is set at position 1 (top position), then

insert 2 x AAA batteries (not included) into the outdoor sensor by observing the correct “+/-“polarity

signs inside the battery compartment. Replace the battery door.

Step 2 Insert the AC/DC adaptor to any 230V AC household outlet. Then insert the DC jack to the

back case of the station. Insert the stand to the bottom of the weather station.

Step 3 Slide open the battery cover at the back of the station, then insert 1 x CR2032 Lithium battery

(not included) to the battery compartment. Make sure “+” polarity of the battery is facing up. Then

replace the battery cover.

Step 4 Peel off the protective label on the front. The weather station is ready to work for you.

The station will receive data signal from the outdoor sensor in few seconds. Then place the outdoor

sensor in a dry and shaded area outdoor.

BACK-UP BATTERIES

When the power supply is not in use, the station will be powered by the back-up batteries. The LED

display is turned off, but time and alarm time remain stored (also in the event of a power failure).

DCF SIGNAL RECEPTION AND SIGNAL INDICATOR

After the station is powered up, it starts to receive DCF signal. The icon flashes.

Receiving DCF signal ( icon flashing)

Successful reception ( icon becomes static)

Failed reception ( icon disappear)

During reception, press the /

WAVE

button will display reception mode and signal strength indication:

When strong DCF signal is detected, display shows with 3 bars .

When weak or no DCF signal is detected, display shows or .

During reception, the signal strength may move from 1 bar to 2 bars to 3 bars. This is normal since

the clock is detecting DCF signal and other signals in the air at the same time. Press the SET button

will return to the time display with icon flashing.

Successful reception or failed reception

Icon becomes static on (stop blinking) when reception is successful.

Icon disappears when reception is failed.

Automatic reception and manual reception

The station starts automatic reception everyday at 1:00, 2:00, and 3:00. If it fails to receive the DCF signal

at 3:00, it will start reception at 4:00. If it fails again, it will start reception at 5:00. If it fails again, it

will start automatic reception at 1:00 again in the next day.

For manual reception simply press and hold the / WAVE button, the station will gives a short beep

and starts manual reception. Press and hold the / WAVE button to stop DCF reception.

When the weather station is receiving the radio controlled time signal, the display will turn dimmer. It

will resume to the brightness level which you originally selected after the radio controlled time

reception is completed.

During DCF reception all buttons do not function and it does not take temperature measurement. The

temperature readings will get stable and become more accurate after the station clock is powered up

for around 30 minutes.

To cancel DCF reception permanently

Press and hold the / WAVE and the button at the same time for 2 seconds, the station will give

2 short beeps and the radio controlled function is permanently disabled.

To resume the radio controlled function, press and hold the / WAVE and the button at the

same time for 2 seconds, the station will give 2 short beeps and will start DCF reception immediately.

THE WEATHER FORECAST

The weather station has a built-in barometer which measures the barometric pressure. After power

up, the display shows SUNNY & CLOUDY icon. The weather station takes around 24 hours to gather

data of barometric pressure changes and predicts next 6-12 hours weather conditions.

There are four types of weather display in the weather station:

Sunny

Sunny & Cloudy

Cloudy

Rainy

Note: Moving the weather station within the house or in the vicinity will causing a sudden change in

the attitude of the station and it affects the accuracy and correctness of the weather forecast. After

the weather station is powered up, it will take around 24 hours to get stable. The weather icons on

the display give a reference to the next 6-12 hours weather conditions. It may not match with the

current weather condition outside.

TIME SETTING

1. Press and hold the SET button for 2 seconds, hour digits flash. Press the or the button to

set the hours.

2. Then pressthe

SET

button again, the minute digits flash. Press the or the button to set the minutes.

3. Then press the SET button again, display shows 05 and flash. Press the or the button to

set snooze duration from 5 minutes to 60 minutes.

4. Then press the SET button again, display shows 00 and flash. Press the or the button to

set the time zone:

“-01” GMT +0 (United Kingdom)

“00” GMT +1 (Central Europaen time)

“01” GMT +2 (Eastern Europaen time)

Note: Time zone can only set when the clock successfully receives a radio signal.

5. Press the SET button again to store the settings and return to normal time display. The clock

will return to normal mode in around 10 seconds if no further press of any other buttons.

Note: The time is displayed in 24-hour display format.

ALARM SETTING

(default alarm setting is 6:00 AM)

1. Press and hold the ALM button until the AL icon appears on the display, the hour digits flash.

Press the or the button to set the desired alarm hours.

2. Press the ALM button again, the minute digits flash. Press the or the button to set the

desired alarm minutes.

3. Press the ALM button again to store the alarm settings and return to normal time display. The

clock will return to normal mode in around 10 seconds if no further press of any other buttons.

To turn on or off the alarm

Single press the ALM button during normal time display to turn on or off the alarm. When the alarm

function is turned on the AL icon appears on top of the time digits.

Note: Alarm duration is 2 minutes.

To use the snooze function

When time reaches the set alarm time, the station will give a beep sound to wake you up. The AL

icon will flash.

1. Press SNOOZE once to stop the alarm temporarily, AL icon keeps flashing. The alarm will

beep again after the set snooze duration.

2. To stop the daily alarm, press any button except the SNOOZE button when alarm is beeping.

The alarm will stop and

icon becomes static. The Alarm will beep again same time next day.

DIMMER FUNCTION

Press the SNOOZE / DIMMER button to adjust high or low brightness of the LED display.

TROUBLE SHOOTING

In case the station shows false digits, it maybe affected by electrostatic discharge or interferences

from other devices. Press the RESET button on the back of the station. The station will be reset to

default setting of time and calendar and it will start to receive radio controlled time signal again.

If you lose the outdoor temperature

When the outdoor temperature digits show “--“, the wireless transmission is either interrupted or lost.

Press and hold the button of the station, then press the RESET button located on the back of the

outdoor transmitter. If you continue to lose the outdoor temperature display, try placing the transmitter

in a different location until you have smooth transmission of temperature data.

Note: Keep in mind that the outdoor transmitter only has a 30 meter transmission range in open area

with no obstructions. Each obstruction between the transmitter and the station (roof, walls, floors,

ceilings, thick trees, etc.) will effectively cut the transmission range in half.

CARE OF THIS ITEM

Do not expose the unit to extreme temperature, water or direct sunlight.

Avoid contact with any corrosive materials.

Do not subject the unit to excessive force, dust or humidity.

Do not open the inner back case or tamper with any components of this unit.

SPECIFICATIONS

Operation temperature: 0°C to +45°C

Temperature measuring range:

Indoor: 0°C to +50°C

(display shows HH.H / LL.L if out of this range)

Outdoor: -50°C to +70°C

(display shows HH.H / LL.L if out of this range)

Temperature resolution: 1°C

Alarm duration: 2 minutes

Snooze duration: 5 to 60 minutes

Consideration of duty according to the battery law

Old batteries do not belong to domestic waste because they could cause damages of

health and environment

End-users are committed by law to bring back needed

batteries to distributors and other collecting points!

Table of contents

Other Technoline Weather Station manuals

Technoline

Technoline WS9480 User manual

Technoline

Technoline WS1700 User manual

Technoline

Technoline WS 6720 User manual

Technoline

Technoline WS6446 User manual

Technoline

Technoline WS 6750 User manual

Technoline

Technoline WS 9422 User manual

Technoline

Technoline WS-7108 User manual

Technoline

Technoline WS 9172 User manual

Technoline

Technoline WS 6720 User manual

Technoline

Technoline WS 6449 User manual

Technoline

Technoline WS 9257-IT User manual

Technoline

Technoline WS 6820 User manual

Technoline

Technoline WS 9032 User manual

Technoline

Technoline WS 9123 User manual

Technoline

Technoline WS6850 User manual

Technoline

Technoline WS 9765 User manual

Technoline

Technoline WS 6710 User manual

Technoline

Technoline WS9125 User manual

Technoline

Technoline WS 6760 User manual

Technoline

Technoline WT 245 User manual

Technoline

Technoline WS 6830 User manual

Technoline

Technoline WS6501 User manual

Technoline

Technoline WS 9132 User manual

Technoline

Technoline WS 2307 User manual

Popular Weather Station manuals by other brands

Auriol

Auriol AHFL 433 A1 operating instructions

NexSens

NexSens G2-HYDROMET quick start

Hyundai

Hyundai WS 2202 instruction manual

IROX

IROX HBVR761 UV-X user manual

La Crosse Technology

La Crosse Technology C86371 instruction manual

ADE

ADE WS 1711 operating instructions

Auriol

Auriol z29592 Operation and safety notes

Auriol

Auriol 296289 Operation and safety notes

Hyundai

Hyundai WS 2266 instruction manual

La Crosse Technology

La Crosse Technology WS-2210 Operation manual

La Crosse Technology

La Crosse Technology WS-811561 manual 

Ventus

Ventus W177 owner's manual

National Geographic

National Geographic VA Colour RC instruction manual

Renkforce

Renkforce 1208067 operating instructions

Levenhuk

Levenhuk Discovery Report WA40 quick start guide

Instant Transmission

Instant Transmission MA 10410 instruction manual

Lutron Electronics

Lutron Electronics PHB-318 Operation manual

WAREMA

WAREMA EWFS Weather station eco Operating and installation instructions